conductivity test 中文意思是什麼

conductivity test 解釋
電導試驗
  • conductivity : n. 【物理學】傳導性[力]，傳導率；導電率[性，系數]。
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Measurement of the steady and non - steady - state chloride diffusion coefficients in a migration test by means of monitoring the conductivity in the anolyte chamber comparison with natural diffusion tests

    很多混凝土科學工作者都在積極努力的發展氯離子傳輸和檢測理論及試驗室方法，目前理論及試驗室檢測標準眾多，但尚無明確的現場檢測標準。
  2. Test method for thermal conductivity of insulating firebrick

    絕熱耐火磚的熱傳導性的測試方法
  3. Standard test methods for measurement of hydraulic conductivity of saturated porous materials using a flexible wall permeameter

    使用撓性壁滲透計測量飽和滲透性材料水滲導性的標準試驗方法
  4. Standard test method for measurement of hydraulic conductivity of porous material using a rigid - wall, compaction - mold permeameter

    使用剛性壁壓縮模式磁導率計測量多孔性材料液壓導電率的標準試驗方法
  5. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  6. Chr standard test method for hydraulic conductivity ratio testing of soil geotextile systems

    土壤土工合成織物系統液力傳導比
  7. Standard test methods for electrical conductivity and resistivity of water

    水的電導性和電阻率的標準試驗方法
  8. Standard test method for electrical conductivity and resistivity of a flowing high purity water sample

    高純度流動水樣品電導性和電阻率的標準測試方法
  9. Electrical conductivity test

    導電率測試
  10. First, executing insulation and conductivity test for loop cable. then, pulsing simulation signal at place of local transmitter and output switch

    首先要對迴路電纜進行絕緣和導通試驗， 2 ）然後在現場變送器、發訊開關處加模擬工藝信號。
  11. Furthermore, both current in - situ conductivity test data interpretation methods and gshp design methods are based on models that only consider heat conduction. therefore, the groundwater flow may impact the results of in - situ thermal property of soil, and then the ghe size, and make the short - time economics of gshp comparatively unattractive consequently

    此外，由於現場對巖土熱物參數的測試及分析也都僅考慮了熱傳導的影響，這勢必影響現場測試結果的精度，最終又會引起換熱器大小的變化，使土壤源熱泵的經濟性受到挑戰。
  12. Belt drives - v - ribbed belts, joined v - belts and v - belts including wide section belts and hexagonal belts - electrical conductivity of antistatic belts : characteristics and methods of test

    帶傳動多楔帶聯組v帶及包括寬v帶六角帶在內的單根v帶抗靜電帶的導電性:要求和試驗方法
  13. Test on gases evolved during combustion of electric cables - part 2 : determination of degree of acidity of gases evolved during the combustion of materials taken from electric cables by measuring ph and conductivity ; amendment 1

    電纜燃燒時排出氣體的試驗.第2部分:通過測量ph值和電導性來測定電纜中的材料在燃燒時所排氣體的酸度.修改件1
  14. Standard test method for thermal conductivity of carbon refractories

    炭精耐火材料導熱率的標準試驗方法
  15. Test method for thermal conductivity of plastics by means of a transient line - source technique

    利用瞬間線性源技術測量塑料熱傳導率的試驗方法
  16. Standard test method for determination of the thermal conductivity of anode carbons by the guarded heat flow meter technique

    用防護熱流量計技術測定陽極碳熱傳導率的標準試驗方法
  17. Test methods of thermal diffusivity, specific heat capacity, and thermal conductivity for fine ceramics by laser flash method

    激光閃爍法測定精細陶瓷的熱擴散率比熱容量熱傳導率試驗方法
  18. Test method for thermal conductivity detector of gas chromatography

    氣相色譜用熱導檢測器.試驗方法
  19. Standard test method for determination of hydrogen in titanium and titanium alloys by the inert gas fusion thermal conductivity infrared detection method

    惰性氣體熔解熱傳導紅外檢測法測定鈦和鈦合金中氫的標準試驗方法
  20. The liquid uptake of polymer electrolyte membrane first increase, then remaining the same as the increasing of ratio of solvents. mechanism capability and ionic conductivity fist increase then decrease during the process, but it changed not much in total. through the test of sem it can be found that the structure of membrane changed little during the process

    在增塑劑含量及聚合物基質含量一定的條件下，隨溶劑含量的增大，聚合物膜的吸液率先增大后基本保持不變，機械強度及離子電導率則先增大后減小，通過sem測試可知，膜的表面形貌無明顯變化。
分享友人
分享到 Line

分享到臉書