connection in parallel 中文意思是什麼

connection in parallel 解釋
並聯
  • connection : n. 〈美國〉＝connexion.
  • in : adv 1 朝里，向內，在內。 A coat with a furry side in有皮裡子的外衣。 Come in please 請進來。 The ...
  • parallel : adj 1 平行的；并行的 （to; with）; 【電學】並聯的。2 同一方向的，同一目的的。3 相同的，同樣的，相...
  1. In the circuit, using the way of step - by - step magnify, a normal sine wave signal through former circuit export for the next circuit, and this signal that have been magnified push the next step. the main magnify circuit use the method of high power dynatron that is parallel connection

    在迴路中採用逐級放大的方法，將一個標準的正弦波信號通過前級放大，輸出給后級，推動后級放大迴路，主要的功率放大迴路中採用大功率三極體並聯實現功率放大輸出。
  2. Heating principle of intermediate frequency induction furnace and some factors affecting its power factor are discussed, some betterments that parallel connection spacer circuit is replaced by interfusion connection spacer circuit are put in practice

    摘要對中頻感應爐的加熱原理以及其功率因數的影響因數進行了探討，並將不能恆功率輸出的並聯逆變電路改進為混聯逆變電路。
  3. A new technique useful for parallel connection of commutation cells is introduced in this paper, it consists of using small inductance in order to ensure dynamic and static share of the commutated current among the different switches. operation principle, theoretical analysis and designing procedure are presented. experimental results, obtained from a 3000w boost prototype using two commutation cells

    本文在對apfc模塊電路中的並聯均流技術進行討論的基礎上，著重對內部單元電路間的並聯均流技術進行了深入研究，並對一種新的並聯均流技術進行了理論分析、模擬模擬，結合中功率（ 3kw ） zvt - apfc模塊電路實驗，探討了這種並聯均流技術應用在apfc電路中的設計方法。
  4. Based on the analysis of the characteristics of the raw mix slurry preparing process in alumina sintering production process, firstly, a mechanism model based on material balance principle was established as the master - rule model for the quality prediction ; secondly, considering the problem that the alkali liquor composition was unstable and its real - time measurement was difficult, a nn ( neural networks ) prediction model for the prediction of the alkali liquor composition was set up and nesting - integrated with the mechanism model ; finally, using the gray theory for the information mining from the errors of the mechanism model, a gm ( 1, 1 ) compensation model was put forward and parallel - connection - integrated with the mechanism model, achieving a raw mix slurry quality prediction model

    摘要針對燒結法氧化鋁生產過程中生料漿配料工藝的特點，根據物料平衡的原理建立機理模型，作為生料漿質量預測的主規律模型；針對堿液成分波動大且難以實時檢測的問題，對堿液成分含量建立了神經網路預測模型，並和機理模型進行嵌套集成；利用灰色理論對機理模型的偏差數據進行信息挖掘，建立了gm （ 1 ， 1 ）補償模型，並與機理模型進行並聯集成，獲得生料漿質量預測模型。
  5. The said energy storing water tank consists of warm water storage tank of multiple stage heating and hot water storage tank, in parallel connection with multi - stage confluent water - heating tank

    所述的儲能水箱是一個以上的水箱，儲能水箱包括分級加熱式溫水儲熱水箱及終溫儲熱水箱，分級加熱式匯流熱水箱與分級加熱式溫水儲熱水箱及終溫儲熱水箱間的連接是並聯連接。
  6. The secondary air duct of boilers is a group of large diameter short ducts in parallel connection, having inlet air flow condition with inner positioned resistant pieces

    摘要鍋爐二次風道為有內置阻力件的一組並聯大口徑短通道，其阻力系數嚴重偏小而且風門渦流強烈，從而造成二次風強烈脈動。
  7. The sensors " fault - detection and fault - torlerance algorithms are studied, so do the three variance - caculating methods for sensors " fault - detection, and the fault - tolerance algorithms of parallel connection system and 2 / 3 ( g ) vote system for hardware redundancy. all the derivation and realization processes of these algorithms are discussed in detail

    研究了傳感器的故障檢測和容錯演算法，論述了三種針對單個傳感器故障檢測的方差演算法，以及針對硬體冗餘的並聯和2 3 （ g ） （三取二）表決系統的容錯演算法，並詳細論述了上述演算法的推導及實現過程。
  8. Now the affect and the measure of hypo _ harmonics is in the research. the influence of negative sequence is almost eliminated along with the enlargement of the system ' s capacity and the alternate connection of traction substations. the fixed parallel compensate equipment applied in traction substations consist of a constant capacitor and a constant inductance, so its output is constant

    負序電流的問題已經因系統容量的增大、牽引變電所採用輪換接線方式而基本解決，電力部門實行的「反轉正計」 ，使採用對無功功率固定補償方式由於牽引負荷變化頻繁而出現補償容量不足或過補償現象，難以達到滿意效果。
  9. In the design and debugging process we found that two different caps with parallel connection may make the amplifier instability. with the analyses of the nonideal cap molding we found that the response curve of two different caps with parallel connection has a saltation whose impedance is infinity and at this pot the amplifier is easy to oscillate. than some suggestion of the use of cap in amplifier design is presented

    在放大器的設計、調試過程中發現兩個不同容值的電容並聯會帶來電路的潛在不穩定，對實際電容，即帶有寄生電感和寄生電阻的電容，建模、分析后發現，不同容值的電容直接並聯其響應曲線會有一個阻抗值為無窮大的突變點，該突變點可能會引起電路的自激。
  10. Aimed at the specific requirements to the functionality and performance of fcps, the dissertation puts forward an approach of the fcps design. in this approach a modular dc / dc power supply that may be running in 4 quadrants, and applied the technique of parallel connection of dc / dc modules, that is a main concern of this dissertation, is realized

    本論文工作針對這個大容量特種電源的功能和特性的要求，提出一種設計方案，在這個方案中採用了模塊化的四象限運行的pwmdc dc電源，並採用了作為本文重要研究內容的dc dc電源並聯技術。
  11. When junction boxes are fixed, enough space shall be leftfor parallel connection cables in order for maintenance

    安裝電熱帶接線盒時，並聯帶應留有一定富裕量，以方便檢修。
  12. Same phase inverse parallel connection ' s three - phase bridge thyristor rectifier assembly was researched mainly the application in the chlorine - alkali industry

    本論文主要研究了同相逆並聯三相橋式晶閘管整流裝置在氯堿工業中的應用。
  13. Based on dowll model for transformer, id analytical procedure for calculate pcb winding loss has been developed, which solved the problem of pcb winding connection in parallel, with it, the designer can easy analyzed the loss of the pcb winding

    從著名學者p . l . dowell的一維變壓器模型出發，建立了計算平面變壓器繞組損耗的一維理論公式，從並聯繞組兩端電壓平衡出發，解決了平面變壓器繞組的並聯損耗計算問題，並實現通用系統的計算機演算法。
  14. The hardware designing include the interface with engine controller, such as d / a conversion. we chose the ad75089 which was produced by ad corp. this is a parallel port digital to analog conversion, and i give the presentation about its structure and connection scheme. in order to resolve the contradiction between faster computation and slower display, a buffer storage also needed

    第二部分詳細陳述了高速數據傳輸卡的軟、硬體設計過程，硬體設計包括dsp與pci總線的介面、 dsp與外部控制器的介面、以及電路卡上的擴展數據緩沖區的設計，並使用專門的工具軟體protel繪出全部硬體電路的設計原理圖。
  15. Similarly to other methods for smart rotor, the most important and difficult problem is the design of the actuator. first, the piezoelectric smart material has been studied and an actuator with piezoelectric stack has been proposed in the mode of parallel connection in electrics and series - wound in mechanics according to the property of the piezoelectric porcelain. second, a 2 - x actuator has been designed with the piezoelectric stack active part according to the triangle theory

    本文首先對壓電智能材料進行研究，根據壓電陶瓷的特點，採用電學並聯、力學串聯的設計模式，提出一種壓電堆主動驅動部件，在此基礎上，根據三角形放大原理，設計了推挽式雙x放大機構，並將壓電堆主動件應用於推挽式雙x機構，形成了推挽式雙x驅動器。
  16. This kind of switch use the unilateral fin - line as the basic transmission line, the beam lead pin diode of alpha co. ltd is the control element, there is two diodes in each channel and they are welded in circuit in parallel connection

    本課題主要研究的是毫米波鰭線pin管單刀雙擲開關。該開關採用單側鰭線作為基本傳輸線，控制器件選用alpha公司的梁式引線pin二極體，每路使用兩只，採用並聯形式焊接在電路中。
  17. Multiplexed sensor technology was studied, a new way was applied to realized series connection and parallel connection multiplex. 5. new generation fiber optic strain - sensing gauge was applied to realize long period strain healthy monitoring of dafosi bridge in the yangtze river

    在傳感系統復用技術研究方面，本文比較了幾種法珀傳感器的復用方式，考慮測量系統的難易程度和成本，選擇了空分復用方式作為傳感系統的復用方案，提出了腔長域解復用的新方法，並進行了串並聯復用模擬。
  18. The connection of a device or circuit in parallel with a transmission line

    將一種設備或電路與傳輸線並聯。
  19. In addition, both the series - parallel connection and parallel pipeline for the circuit structure are availed to cut down hardware area and improve processing speed of the system

    同時，為保證系統的實時處理速度和降低硬體成本，在演算法的vlsi實現時採用串並結合和并行流水線等設計。
  20. The series - base - isolation structure, with a composite bearing formed by serial connection of the rubber isolation bearing with friction - sliding isolation bearing and connected with the rubber isolation bearing in parallel form, obtains good effect of vibration isolation under earthquakes

    摘要由橡膠隔震支座與摩擦滑移隔震支座串聯成組合支座，再與橡膠隔震支座並聯形成的串聯基礎隔震結構，在地震時可以取得較好的隔震效果。
分享友人
分享到 Line

分享到臉書