constant temperature flow 中文意思是什麼

constant temperature flow 解釋
恆溫流動
  • constant : adj 1 恆定不變的，固定的，穩定的，恆久的；繼續不斷的。2 不屈不撓的，堅韌的。3 忠實的，有節操的。n...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  1. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明，預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果，局部努謝爾數隨預旋角的增大而有所減小；隨旋轉雷諾數的增加，不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低：當軸向中心進氣質量流量不變時，隨預旋進氣的質量流量增加，內轉靜腔室的轉盤盤面上的換熱基本沒有變化，而預旋腔室的轉盤盤面上的換熱效果增強；當預旋進氣質量流量不變時，軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  2. Wet and dry numerical simulation tests for explosive cyclone over western pacific were performed. by contrast the results show that : tropopause and constant temperature surface were raised by latent heat release in upper level and disturbance trough was produced because air flow ascended and became cold. owing to this process adaption, inertial instability emergenced

    對氣旋強烈爆發的過程進行干濕對比數值模擬試驗，得出：潛熱釋放使對流層項和等溫面抬高，氣流在高層的上升冷卻形成擾動槽，其適應過程使高層出現慣性不穩定。
  3. Under the condition of constant phosphorus mass flow rate, the smog exit temperature would increase slowly while other parameters would decrease with increasing excess air coefficient

    在燃磷量不變情況下，最高燃燒溫度、壁面最大熱流和平均熱流均隨過剩空氣系數的增大而減小，但煙氣出口溫度緩慢增加。
  4. The predicted results showed that maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux would increase with increasing phosphorus mass flow rate when excess - air coefficient or air flow rate was constant

    模擬結果表明，無論過剩空氣系數固定還是空氣流量固定，隨燃磷量的增大，最高燃燒溫度、煙氣出口溫度、壁面平均熱流和最大熱流都呈上升趨勢。
  5. Error analysis and elimination for measuring the widing temperature - rise of electromotor with a constant flow source method

    恆流源法測量電機繞組溫升的誤差分析及消除
  6. On this basis, fortran program is written to solve temperature and velocity fields in transformer. by using this program we can calculate total flow, duct flow, mean temperature rise of transformer oil, oil time constant, mean oil temperature rise in each winding - coil, temperature distribution in each winding - coil, and stable / transient state temperature field. so this program has a great use value

    在此基礎上，我們編制了計算自然油導向冷卻的具有餅式線圈變壓器流場和溫度場的fortran程序，程序可以對總油流量，進入各相、各油道的油流量，各線圈內的油流分佈，變壓器的油平均溫升，油的時間常數，各線圈的平均線油溫升，各線圈內的油溫分佈以及各線圈的穩態溫度場、暫態溫度場進行定量模擬，具有較強的實用價值。
  7. Author considers that munk - anderson ' s modification is not suitable to simulate the buoyant flow in reservoir, and suggests the turbulent prandtl number as the constant of 0. 85 in the water temperature model of reservoir

    本文認為該修正模型並不適用於水庫浮力流的模擬，建議在大型深水庫水溫模型中溫度普朗特數採用常值0 . 85 。
分享友人
分享到 Line

分享到臉書