constructional concrete 中文意思是什麼

constructional concrete 解釋
構造混凝土
  • constructional : 構造上的
  • concrete : adj 1 具體的,有形的;實在的,實際的。2 固結成的,混凝土製的。3 圖案詩歌的(參閱concrete poetry)...
  1. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - concrete and tile making machines

    混凝土和硅酸鈣建材產品生產機械.安全性.混凝土和空心磚製造設備
  2. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - slide and turntable machines

    生產混凝土和硅酸鈣結構件的設備.安全.滑動和絞盤機
  3. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 5 - 4 : concrete pipe coating machines

    混凝土和硅酸鈣施工產品用生產機械.安全.第5 - 4部分:混凝土管道塗覆機械
  4. In light of the simulative research results, three methods are applied to analyze some controversial problems in this kind of structural system ( such as the concrete pouring sequence of continuous ends, the applying sequence of pretensioned force, the removal of the temporary supports, the concrete pouring style of continuous ends, the optimization of constructional reinforcement and prestressed reinforcement ). some important conclusions are drawn : the concrete pouring sequence of continuous ends should be in accordance with the principle of " interval end " ; the removal of temporary supports is also on this principle ( opposite to traditional opinions ). at the same time, other problems such as the shrinkage and creep effects of concrete, the c racking and failure pattern, the optimization of reinforced bars and prestressed bars are also analyzed in detail

    在此基礎上,對于目前先簡支后連續結構體系中存在的一些有爭議的問題(如后連續端部澆築和后連續預應力張拉的順序、體系轉換中的臨時支座拆除順序、后連續端部澆築方式、后連續端部的預應力筋及普通鋼筋的優化等) ,我們分別運用三種方法進行了細致的模擬分析、研究,並得出了一些具有重要工程意義的結論:后連續端部的澆築順序和后連續預應力張拉的「隔跨」原則,臨時支座拆除的「隔跨」原則(此前人們一直認為「對稱澆注和對稱張拉」是最為合理的施工工序) ,混凝土的收縮、徐變對先簡支后連續結構體系的影響一般較小等。
  5. Have to out : 1 temperature constructional reinforcing not can place in heat area to mass concrete design. temperature constructional reinforcing of bottom of mass concrete need content that owing to temperature change produce bottom control stress smaller than anti - pull strength at the same. get minimum rate of reinforcing to content construct request

    得出: 1在大體積混凝土結構的溫度構造鋼筋配置中,構造鋼筋不宜放置於高溫區;大體積混凝土的底部溫度構造鋼筋應滿足溫度變化產生的底部約束拉應力小於混凝土同齡期的抗拉強度的要求,從而求出抗拉要求的最小配筋率。
  6. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 4 : concrete roof tile making machines ; german version en 12629 - 4 : 2001

    混凝土和硅酸鈣鹽構件生產機械.安全性.第4部分:屋頂
  7. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 7 : stationary and mobile equipment for long line manufacture of prestressed products

    混凝土和硅酸鹽建築產品用生產機器.安全.第7部分:預應力製品長線法生產用固定和移動設備
  8. This system is the new type, in which the connection between the special - shaped column and concrete block is stronger than that of frame structure and the dark beams are located and its constructional sequence is brickwork first and placing columns second and concrete blocks are as bottom forms when beams are placing

    這種新型結構形式的主要特點包括:異形柱與砌塊為馬牙槎連接、墻體內含有暗梁、施工順序為先砌墻后澆柱、梁澆築時以砌塊為底模。
  9. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - concrete pipe coating machines

    生產混凝土和硅酸鈣建築產品用機械.安全.混凝土管塗覆機
  10. Study on aseismic behavior of small concrete hollow block walls with different constructional measures

    不同構造措施下混凝土小型空心砌塊砌體抗震性能研究
  11. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 5 - 4 : concrete pipe coating machines ; german version en 12629 - 5 - 4 : 2003

    生產混凝土和硅酸鹽建築產品用機器.安全.第5 - 4部分
  12. This paper presents the design method for a long span concrete continuous girder bridge with precast segments, mixed arrangement of internal and external tendons, and to be constructed with cantilever erection by overhead launching gantry, and also discusses several issues of the type of the bridge in need of special considerations in aspect of design calculations and constructional design

    摘要介紹採用節段預制架橋機懸拼施工,採用體內、體外混合配束的大跨度混凝土連續梁僑的設計方法,對設計計算及在構造設計上需要特殊考慮的一些問題進行了探討。
  13. It provided the reference to improve the anti - cracking capability of high strength and high performance concrete from the point of view of constructional technology and curing requirement. the result shows that the more the binder material or sand rate, the more serious the shrinkage cracking

    最後運用該軟體分析在外界溫濕度變化以及不同養護條件下,混凝土內部的溫濕度變化規律及其由此引起的溫度應力和濕度應力,為從施工養護方法上改善高強高性能混凝土抗裂性能提供參考。
  14. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - block making machines

    生產混凝土和硅酸鈣建築產品用設備.安全.壓塊機
  15. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 2 : block making machines

    混凝土和硅酸鈣建築產品的生產機器.安全性.第2部分:制塊機
  16. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 2 : block making machines ; german version en 12629 - 2 : 2002

    製造混凝土和硅酸鈣建築產品的設備.安全.第2部分:砌
  17. Constructional details of concrete ship

    鋼筋混凝土船結構節點和圖例
  18. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - stationary and mobile equipment for the manufacture of precast reinforced products

    生產混凝土和硅酸鈣建築產品用機器.安全.生產預制加筋產品的固定和移動設備
  19. Machines for the manufacture of constructional products from concrete and calcium - silicate - safety - part 6 : stationary and mobile equipment for the manufacture of precast reinforced products ; german version en 12629 - 6 : 2004

    生產混凝土和硅酸鈣建築產品用機器.安全.第6部分:生
  20. Code for acceptance of constructional quality of concrete structures

    混凝土結構工程施工質量驗收規范
分享友人