control force system 中文意思是什麼

control force system 解釋
操縱感力系統
  • control : n 1 支配，管理，管制，統制，控制；監督。2 抑制（力）；壓制，節制，拘束；【農業】防治。3 檢查；核...
  • force : n 1 力，勢。2 體力，氣力，精力，魄力。3 暴力，壓力；兵力，武力。4 〈pl 〉 部隊，軍隊，兵力。5 勢...
  • system : n 1 體系，系統；分類法；組織；設備，裝置。2 方式；方法；作業方法。3 制度；主義。4 次序，規律。5 ...
  1. By means of guidance command decomposed forwardly, the combined control system is divided into two parallel subsystems : the aerodynamics subsystem and the direct force subsystem

    復合控制採用對制導指令進行前向分解的方法，將復合控制系統分為兩個并行的子系統，即氣動力控制子系統和直接力控制子系統。
  2. Considering special form of the boiler frame, the reconstruction and enforcement method, in addition dynamic analysis are given by particular steps : establishment of the model of boiler steel frame, determination of earthquake loads and distribution form, and anti - side force system for the frame to model and analyze, involving loads on the frame and above it, earthquake loads, damping, sway control installation, hanging bar and plate beam

    考慮鍋爐構架鋼結構的特殊形式，研究並提出了電站鍋爐鋼結構改造加固研究方法，及動力分析的具體步驟：建立了鍋爐鋼結構動力分析模型、地震荷載分析方法、建立了鍋爐鋼結構布置型式、及整個鍋爐鋼構架抗側力體系模擬分析方法。具體包括：鋼構架本體及構架上荷載、地震載荷與阻尼系數確定、制晃裝置確定、吊桿與大板梁簡化。
  3. A set of non - linear differential equation of this model is formulated based on lagrange ’ s equation. the tension of the cable, the control force of translation and the control torque of rotation are obtained by the method of newton ’ s laws in vector space. the tethered mass system is modeled as a spherical pendulum

    本文基於一種常見的繩系單體系統，運用lagrange方程建立了該系統的非線性運動微分方程，採用矢量法對該運動微分方程進行了校核，並推導出吊索的張力、變幅控制力和回轉控制力。
  4. For these reasons, we can apply the theory of the model reference self - adaptive control syetem design based on the theorem of balance point stabilization in the force system of asymmetric cylinder controlled by symmetric valve. the main idea of model reference self - adaptive controller is to make the self - adaptive control error incline to zero as time passed. the task to design adaptive controller is to find the control input that can make the output of the controlled system to follow that of the reference model

    因此將基於平衡點穩定定理的模型參考自適應控制系統設計理論應用於閥控非對稱缸力系統中，其基本原理是使自適應控制誤差隨時間的推移而趨向于零，自適應控制器設計的目的是尋找使被控系統的輸出漸近一致的跟隨參考模型的輸出的控制輸入，以此來改善被控系統的性能。
  5. The control force characteristics of manual-control system can be modified by the introduction of weights and springs.

    可以通過引進配重和彈簧來改善手控操縱系統的操縱力特性。
  6. This research has include these following : firstly, base on the analysis of the process principle and the limitation of the original system prototype, this paper has analyzed the reasons and redesigned the both organization and control of system, to improve the force condition this paper redesigned the organization of tool arm, to improve the precision of system change the motor and control card, and add the tool auto - check equipment

    本文主要完成了以下幾方面的內容:首先，在分析已有的初代系統不足的基礎上，提出了改型方案，重新進行了機構和控制系統的設計，針對刀具電機受力不合理的問題，增加了支撐結構，重新設計了刀具連接體部分;針對加工臂偏擺電機的精度問題，更換了電機;針對加工設備不完善的問題，增加了對刀模塊。
  7. The paper explains the control force with the center of performance index. the static error is an important index of the control system

    穩態誤差是控制系統一個很重要的性能指標，在九點控制器中k _ 0是穩態時的控製作用。
  8. The paper illustrates the influence of control force on the response of second order surging system. from this paper ' s analyzing, the partition of phase plane is sound

    從分析中可以看出，幾點控制器對相平面的劃分是合理的，各個控製作用對系統運動的影響是有相對獨立性的。
  9. Compared with the rudder control system, the paper introduced the character of the jet control system. then the matlab was used to reveal the relation between the control force coefficient and the deviation of the missile

    與空氣舵控制方式進行比較，說明了噴流控制力系統的特徵，利用matlab模擬模擬出兩個通道的控制力系數和偏差信號之間的關系。
  10. The command and control operation of the force enters a new era when the third generation command and control communications system cciii commences operation

    第三代指揮及控制通訊系統下文簡稱cciii已開始運作，警隊的指揮和控制工作進入新紀元。
  11. New subhead " replacement of command and control communications system for the operations department of the hong kong police force

    香港警務處新分目更換香港警務處行動處的指揮及控制通訊系統
  12. 5. self - adaptive identification and control of pole placement used in force system is deeply studied. 6

    研究自適應辨識和極點配置自適應控制，用來控制剛度不定的力加載試驗過程； 6
  13. In accordance with the mr damper - spring system presented in this paper and non - linear fem model of guyed mast, an " off - on energy dissipation " semi - control strategy based upon mr damper ' s displacement is proposed, in which the control force of mr damper is close to the instantaneous optimal active control force and dissipate energy as possible as it can

    根據本文提出的mr阻尼器?彈簧系統和桅桿結構非線性計算模型，文中提出了使mr阻尼器所提供的控制力盡量接近瞬時最優主動控制力，同時又能盡量耗能的mr阻尼器對桅桿結構風振響應半主動控制基於阻尼器位移的「開關?耗能」半主動控制策略，並在時域內進行了模擬分析。
  14. Collaboration between the two branches was epitomised by the ongoing design and development of the third generation command and control communications system ( cciii ), which will be rolled out in three phases between late 2004 and early 2006. embracing advanced digital radio communication and mobile computing technologies, cciii is the mission - critical system that the force relies upon to support the 999 emergency services in the three regional command and control centres

    資訊應用科和通訊科合作的最佳例子，是第三代指揮及控制通訊系統（簡稱cciii ） 。這個系統將由二四年年底至二六年年初分三個階段推出。 cciii採用先進的數碼無線電通訊及流動電腦技術，以支援警隊三個總區指揮及控制中心的999緊急服務，是警隊的關鍵資訊系統。
  15. In nine - points controller control system, it utilizes k _ ( 0 ) control force achieving the static error requirement. the condition of ko = 0 could fit the second order in most control environments

    對于模型不明確的系統，我們可以同意設置k0 = 0 ，利用此時的k _ 3控製作用，把穩態誤差限制在誤差零帶的范圍內。
  16. It uses the ideas of the receding horizon and the feedback proofread based on the predictive model of the system response to optimize the objective function and gain the optimal control force, which could minimize the difference between the real output and the desired output

    預測控制以系統響應的預測模型為基礎，利用滾動優化和反饋校正的思想，對目標函數進行優化得到最優控制力，使對象輸出與期望值之間的偏差達到最小。
  17. In february 2002, the force began an open worldwide tender for the third - generation command and control communications system ( cc iii )

    二二年二月，警隊就第三代指揮及控制通訊系統向全球公開招標。
  18. Speaking at the contract signing ceremony of the third generation command and control communications system ( cciii ), mr yam said today ( march 27 ) that the system allowed the force to provide a more effective response to better serve the public, fight crime and save lives

    任達榮在今日（三月二十七日）第三代指揮及控制通訊系統簽約儀式中表示，新系統可以更有效回應，為市民提供更佳的服務，撲滅罪行，救急扶危。
  19. Using the optimization control method of the moderm control theories, the time - varying control and output - feedback control the authors study the variable structure active control over the rotor vibration with sma, especially the method of restraining the transient response of the rotor vibration. they get the rule of the optimum control force and the optimum control electric current and discuss the influence of variable stiffness on the total system stiffness through analyzing the structure of sma controller. they also indicate the shortcoming of the orthodox design method of a controller, especially the imbalance phenomenon caused by the lack of the rod stability, and propose a new method for improvement and items which ought to be paid attention to in the design stage

    運用現代控制理論中的最優控制方法，引入時變控制和輸出反饋控制，研究利用形狀記憶合金對轉子振動進行變結構主動控制，特別是抑制轉子振動的瞬態響應的方法，得出了最優控制力和控制電流的強度變化規律；通過分析形狀記憶合金動作器的結構，探討了變剛度支承對系統總體剛度的影響，指出了傳統設計方法的不足之處，特別是由壓桿穩定性不足引起的失穩現象，並提出了改進的方法和在設計中值得注意的問題
  20. The static characteristic of control force takes the key - role in the nonlinear system ' s control

    非線性環節不再像往常那樣對誤差信號起作用，而是針對控製作用。
分享友人
分享到 Line

分享到臉書