control loads 中文意思是什麼
control loads
解釋
操縱系統載荷-
As we all known, the ballistic trajectory is a pilotless missile, which loads rocket engine and control system, these will drop the missile to the target along its ballistic
眾所周知，彈道導彈是一種無人駕駛的飛行器，它裝有火箭發動機和控制系統，其目的是把導彈沿一定的彈道送到目標區。 -
It can be seen from the results that the control beam had good plastic property in the static failure experiment after two million fatigue loading circles. all specimens with corroded main bars were failure under the fatigue loads within one million fatigue circles. fatigue lifespan of reinforced concrete beam was sharply shortened after main bars corroded in it and the beam was destroyed bristly without any prediction
試驗結果表明，振動測試不能夠對銹蝕鋼筋混凝土梁的疲勞破壞做出可靠的預測;對比梁在經過200萬次疲勞循環加載后的靜力試驗中仍表現出良好的延性破壞特徵;銹蝕梁在100萬次疲勞循環內均因主筋疲勞斷裂而破壞;主筋銹蝕使得梁的疲勞壽命急劇縮短;梁發生脆性破壞而沒有徵兆。 -
Because of the elements which run under nonideal linearity and unentire symmetry in the power system, the loads which are different and change randomly, the methods which adjust and control the system faultily and operate improperly, the disturbance and the malfunction which happen somewhere, the current and voltage in the supply system are distorted seriously and thus large amount of harmonics are produced
但是，由於電力系統元件運行的非理想線性或非完全對稱、負載的性質各異且隨機變化、調控手段的不完善以及錯誤操作、外來干擾和各種故障的存在，供電網中的電流（電壓）發生畸變，產生大量諧波。 -
Because these wind loads are a major structural consideration, they greatly influence the design of the flight control system.
因為這些風載荷是結構上主要的考慮因素，它們很大地影響著飛行控制系統的設計。 -
Also, loads and control forces imposed by space vehicle guidance systems are generally small.
此外，由空間飛行器導引系統所產生的載荷與控制力一般是很小的。 -
Considering special form of the boiler frame, the reconstruction and enforcement method, in addition dynamic analysis are given by particular steps : establishment of the model of boiler steel frame, determination of earthquake loads and distribution form, and anti - side force system for the frame to model and analyze, involving loads on the frame and above it, earthquake loads, damping, sway control installation, hanging bar and plate beam
考慮鍋爐構架鋼結構的特殊形式，研究並提出了電站鍋爐鋼結構改造加固研究方法，及動力分析的具體步驟：建立了鍋爐鋼結構動力分析模型、地震荷載分析方法、建立了鍋爐鋼結構布置型式、及整個鍋爐鋼構架抗側力體系模擬分析方法。具體包括：鋼構架本體及構架上荷載、地震載荷與阻尼系數確定、制晃裝置確定、吊桿與大板梁簡化。 -
The rule of loads and settlement is concluded from numbers of settlement observation points ’ data. and in actual construction, this rule could be used to prevent immediate settlement under the accelerated load, and also, the serious result of the soil destruction could be avoided. at last, a proper method of settlement computing is derived from the identified rules, which can be used to guide the practical construction work, of course, meeting the compulsory standards of the settlement control well
採用逆作法施工，現實地解決了樁、土與筏板接觸面的變形協調關系;通過對樁、土受荷過程的實際測試，得出了樁、土分擔荷載比例和變化過程，從而為樁、土的荷載計算提供實際依據;從設置的大量沉降觀測點中所得到的沉降資料，得出荷載、沉降變化規律，從而指導在實際施工中，防止加載過快而導致速沉，避免由此帶來的土體破壞的嚴重後果;通過沉降規律分析，得出了適用於軟土地區的樁基沉降計算方法，用於指導實際施工，以滿足沉降控制的強制性標準。 -
To prepare international standards for electrical energy measuring and electrical load control equipment ( such as watt - hour meters, var - hour meters, maximum demand indicators, telemetering for consumption and demand, equipment for remote meter reading, time switches, equipment for the control of loads and tarifs and consumer services ) including the equivalent electronic forms of these devices and their accessories
負責制定電能測量和負荷控制設備（如：有功、無功電度表、最大需量指示器、損耗和需量的遙測、遠程抄表設備、時間開關、負荷和費率控制設備及用戶服務等）的國際標準，包括功能相近的運用電子技術實現的設備及其附件。 -
Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。 -
Fork ends, in corrosion - resistant steel, swaged on aircraft control wire rope - dimensions and loads
航空器操縱鋼絲繩上的鍛制耐腐蝕鋼制叉形端.尺寸及載荷 -
Aerospace series. turnbarrels, control cable in copper - zinc alloys. dimensions and loads
航空和航天系列.銅鋅合金制控制索的松緊螺套.尺寸和負載 -
Pwm converter has low efficiency at light loads and high amplitude harmonic. on the other hand, the control circuit and filter for pfm are much complex
Pwm調制模式的spic在輕載下效率較低，控制脈沖諧波峰值較大; pfm控制電路較為復雜，后續濾波器設計困難。 -
Though much progress has been achieved in previous study, there still remains a lot to be studied and perfected. the thesis is devoted to study on the multi - ribbed slab wall, the main bearing member in mrss, including its mechanism, failure mode, aseismic capability, mechanical models, ultimate bearing capacity and aseismic design based on control. the paper mainly accomplished such work as follows : 1 ) based on test research on multi - ribbed slab wall, the paper proposed the member ' s failure modes under horizontal loads, analyzed the co - performance between the inner frame and the infilled silica bricks and that between the slab and the outer frame, discussed the wall ' s bearing capacity, rigidity, deformation, ductility and energy dissipation ability in different modes, and put forward a simplified mechanical model of the slab wall under vertical loads
本文針對密肋壁板結構的主要受力構件? ?密肋復合墻體為研究對象，就其受力機理、破壞模式、抗震性能、三階段力學模型、極限承載能力以及基於控制的抗震設計方法等進行了較為詳細的研究，完成的主要工作有： 1 ）通過對密肋復合墻體在水平低周反復荷載和單調荷載作用下的試驗研究，提出了墻體的主要破壞模式；分析了框格與內部填充砌塊、墻板與外框的共同工作的受力特點；探討了不同破壞模式情況下墻體的承載能力、剛度、變形、延性、耗能等抗震性能，並給出了豎向荷載作用下密肋復合墻體的簡化力學模型。 -
The control parameters influenced the loads of the stall wind turbine small. but it will be bigger to the variable pitch wind turbine and the variable speed wind turbine
對于bladedforwindows軟體，定槳距失速調節型風力發電機組控制參數的輸入量比較少，對機組載荷的影響也比較小。 -
He finds the pitch range after calculated the three important parameters through the bladed for windows software, then presents an optimized control strategy that regulate the pitch angle in terms of the wind speed. it must control the output power because the variational output power brings the variational loads. he confirms and optimizes the control strategy that the output power is the control target, the output power is divided into three parts
將功率作為系統控制的目標，將功率分成三段進行控制，在低風速區，載荷是有限的，以功率最大化作為控制目標；在額定風速附近，由於處在升力曲線斜率的變化點，功率變化較大，應盡快調整槳距角進入失速區工作，減少載荷的波動，該額定風速區的上下工作點要通過現場試驗的手段來確定；在額定風速以上，使功率維持在額定輸出，減少功率波動，並通過bladed軟體的模擬計算對控制策略進行了驗證。 -
Aerospace series. turnbarrels, control cable in corrosion resisting steel. dimensions and loads
航空航天系列.耐蝕鋼制操縱鋼纜緊線器.尺寸和負載 -
For long - span bridges, long - space spatial structure, high - rise buildings, high - rise tower, wind load is one of control loads for structure design, beside for the many use of kinds of the light weight and high strength material and many use of glass cladding, the problem of wind load on the building structure become more serious
對于大跨度橋梁、大跨度空間結構、高層建築、高聳塔桅結構來說，風荷載是其結構設計中主要的控制荷載之一，同時由於各種輕質高強度材料及玻璃幕墻的大量運用，使得建築結構受風影響的問題更加突出。 -
Control loads all the xml data in the xml file identified by the
控制項加載xml文件中由 -
If the control loads its view state by
加載其視圖狀態，則為 -
Use a tag line to control loads. keep hands off the load. do not wrap tag line around your hands or body
使用牽引線來控制貨物，不要用手。不要把牽引線纏在手上或身上。
分享友人