cooled in furnace 中文意思是什麼
cooled in furnace
解釋
爐內冷卻-
5. the comprehensive capacities of the azsm alloy were markedly promoted than that of the as - cast azsm alloy which was aged at 200 ?, air - cooled and furnace - cooled after solid - solution, aged at 90 ? and aged in nature after solid - solution
5 ）鑄態azsm合金經200時效3小時、固溶4小時后空冷和爐冷、 400固溶-水淬90時效和自然時效的綜合性能較鑄態有顯著的提高。 -
The results show that it is an effective method for acquiring better electrical properties that the pressed bodies were sintered at 1150 in furnace with the temperature raised dilatorily, heat preserved for 2. 5 hours and furnace cooled to room temperature
研究結果表明，氧化鋅壓敏閥片的最佳燒成制度為：隨爐連續緩慢升溫至1150進行燒結，保溫2 . 5小時后，隨爐緩慢冷卻。 -
Over a 100 to 270 temperature range, the damping capacities are ranked from great to small as follows : sample cooled in furnace, sample cooled in the air, sample quenched at - 70 ( sample quenched at - 195 ) and sample quenched in water
在100 270范圍內，不同熱處理態材料阻尼能力的大小以次為：其爐冷空冷70淬火- 195淬火水淬。超過270 ，由於阻尼性能測試出現第二個內耗峰，不同熱處理態試樣阻尼性能的大小沒有明顯的規律性。 -
Compared with other general cfd software, the numerical modeling software of combustion process improved by the author of this paper has following features : ( 1 ) it can adjust the corresponding parameters and manipulating methods according to furnace architecture, operational parameters and fuels etc. ; ( 2 ) it can arrange the nodes of grid flexibly and also make special calculation to certain nodes, which cannot be accomplished by the general commercial software ; ( 3 ) in the boundary ( water - cooled wall ) condition processing, the third boundary condition is selected for the temperature calculating, linking the combustion process inside the furnace with the flow and heat exchange of water inside the water - cooled wall, so the heat absorbing and the influence of the water - cooled wall to combustion process and heat transfer of furnace are explicitly explained
與其它通用的cfd軟體相比，經論文作者所改進的燃燒過程數值模擬軟體的特點在於： （ 1 ）能夠結合爐子結構、運行參數及燃料等，調整模型中相應的參數及處理方法； （ 2 ）可以靈活的安排網格節點，對某些節點進行特殊處理； （ 3 ）在邊界（水冷壁）條件的處理上，溫度選用了第三類邊界條件，把爐內燃燒過程和水冷壁內工質的流動和換熱聯系了起來，使得水冷壁內的吸熱情況對爐內的燃燒和結渣的影響充分體現出來。
分享友人