cooling distribution system 中文意思是什麼

cooling distribution system 解釋
製冷循環系統
  • cooling : n. ,adj. 冷卻(的)。
  • distribution : n 1 分配,分發,配給;分配裝置[系統];配給品;配給量;【經濟學】配給方法,配給過程;分紅;【法律...
  • system : n 1 體系,系統;分類法;組織;設備,裝置。2 方式;方法;作業方法。3 制度;主義。4 次序,規律。5 ...
  1. From the feature analysis of the radiant floor cooling and underfloor air distribution ( ufad ) was put forward the combined system of radiant floor cooling and ufad, and described the water system, wind system and control modes of the combined system, and presented the air - conditioning principle chart of air distribution system

    從地板輻射供冷與地板送風系統的特性分析出發,提出了地板供冷與地板送風混合式空調系統的概念,並對這一系統的水系統、風系統以及控制方式作了詳細闡述,給出了採用「踢腳」送風的空調系統原理圖式。
  2. A new method is developed to predict the temperature distribution of cooling - plate with non - uniform heat load on the surfaces, meanwhile, two types of cooling - plate used in the environment control system of airplane are studied experimentally under conditions of different reynolds number of air and surface heat loads

    摘要提出了一種新的冷板簡化數學模型,把翅片摺合成導熱系數?各向異性的等效厚度層實芯板,將冷板與空氣的對流換熱作?等效層的穩態導熱問題,計算了表面熱源非均勻條件下冷板的溫度分佈。
  3. This platform is then used to study the temperature distribution and fluctuation of module ' s wall, the fluctuations of thermal control system, temperature and humidity in the cabin for the short and long cycles of the thermal environment changes. this thesis suggests a temperature control method for cooling loops, a temperature and humidity control method of the cabin air and simulates their effectiveness

    用該平臺模擬了艙壁的溫度分佈及波動特點,研究了熱輻射環境的短周期和長周期波動及艙內熱負荷波動對熱控制系統及艙內空氣溫度、濕度造成的動態影響;給出了熱控迴路溫度控制方法,利用最佳去濕流量的概念提出了具有回熱流程的艙內空氣溫度、濕度控制方法,對控制效果進行了動態模擬。
  4. Application analysis of radiant floor cooling combined with underfloor air distribution system

    地板輻射供冷與地板送風混合式空調系統應用分析
  5. A general air - conditioning system is calculated, which indicates that the temperature difference must be less than 12. 8 and 9. 2 and 10 respectively in cool air distribution system, chilled water system and cooling water system

    計算表明,對于常規空調設計參數,大溫差送風的送風溫差不宜超過12 . 8 ;大溫差冷凍水的供回水溫差不宜超過9 . 2 ;冷卻水大溫差技術在冷卻水供回水溫差小於10時總是適用的。
  6. Whether a system is designed for heating, cooling or water distribution, it must be properly adjusted and balanced for optimum design performance

    無論一個系統是用於供熱、製冷或給排水,都必須進行恰當地調節和平衡,達到最優的設計性能。
  7. Cooling tower distribution system

    冷卻塔配水系統
分享友人