cooling theory 中文意思是什麼
cooling theory
解釋
冷卻理論-
Based on the simulation model theory of temperature and stress fields presented in this article, a large simulating program for high rccd has been developed, which can numerically simulate all kinds of temperature control measures, including water pipe cooling, heat insulating in winter, reducing place temperature of concrete, spraying water brume, and long interval over - watering surfaces overflowing in flood season.
基於本文提出的溫度場和徐變應力場模擬模型理論，編制了高碾壓混凝土壩的三維有限元模擬計算程序，在程序中考慮了各種溫控措施的數值模擬，包括：水管冷卻、冬季保溫、降低混凝土的澆築溫度、夏季混凝土表面噴水霧、施工汛期壩頂面過水等。 -
The transmittance is central to the theory of radioactive cooling.
透過率是輻射冷卻理論的中心。 -
The coupling from the pulse jet in the nozzle to the unsteady flow in the tube was discussed. and the relations between the parameters of gas charge and discharge, structure, working, flowing in tube and ideal cooling efficiency were established. the theory foundation of the influence of pulse jet on the flowing in the tube and characteristic would be built
探討了脈動射流與管內非定常流動的耦合問題，建立了脈動射流有關參數如進、排氣參數、結構參數、運行參數等和振蕩管內流動參數及理想製冷效率之間的普遍聯系，為研究脈動射流參數對振蕩管內流動及其性能的影響打下了理論基礎。 -
Puts forward an improved method based on the theory in which the enthalpy difference is considered as the driving force in heat transfer under wet cooling conditions and thinks that the method can halve the testing work, require less for the experiment devices and reach higher accuracy
認為該方法遵循了焓差是濕工況下換熱推動力的規律，試驗工作量減少一半以上，對試驗裝置的要求降低，由試驗數據整理出的公式用於表冷器熱力計算完全可以滿足空調常用范圍內的要求。 -
An enclosed single tube thermal separator was designed and by means of which the influence of single element of q, l, f, on the performances of thermal separator was investigated experimentally. on the basis of the comparison between the theoretical analyses with the results of the experiment, a relatively systematical theory of the cooling mechanism and peak oscillating effect of the thermal separator was founded
設計了一臺封閉式單管熱分離實驗裝置，對q 、 l 、 f 、 、激波吸收器等因素對熱分離機性能的影響進行了單因素實驗；對理論分析和實驗結果進行了比較，形成了較為系統的熱分離機製冷機理和峰值振蕩理論。 -
Based on the conclusions that have been admitted, the paper improves the drain - back system optimization theory, studies the different vacuum extractor system, builds a optimum model of the cooling spray system, optimizes the recovered system of the blow down water with a new structure, converts the accessory steam system and proves it in theory
本文在總結已有研究的成果的基礎上，完善了回熱系統結構優化的理論，研究了不同真空抽氣系統的優劣，建立了噴水減溫系統的優化模型，引入新的結構對排污回收利用系統進行優化，改造了輔助蒸汽系統並從理論上進行證明。 -
3 the design theories of cooling pipe of play down internal temperature of mass concrete about diameter, length, arrange method, rate of flow, current velocity, reduce heat time, temperature disparity to in and out, reduce heating result etc. 4 the theory of influence about concrete internal temperature and concrete crack because of transform of mixture ratio and pulverized fuel ash sophisticate quantity
西安建築科技大學博士生論文一;一;一一『一一一3降低大體積混凝土內部溫度常用的冷卻水管的管徑、長度、布置方法、水流量、流速、降溫時間、進出水口的溫差、降溫效果等的設計計算理論。 4配合比及摻加料對混凝土內部溫度和混凝土開裂的影響理論。 -
The piezoelectric - pump driven by piezoelectric - stack is a newly development trend, it can accommodate frequency and pressure in a large scale and control the output flux in precision. this pump will widely apply to transfusion, feed oil and clean the equipment in industrial automation, and scientific research, lab, chemical preparation and cooling of cpu etc. driven theory of piezoelectric - stack because the piezoelectric - stack is the core part of the pump that we designed, we should pay more attention to driven principle of the piezo - stack so that we can using it correctly. this paper introduces piezoelectric material and interrelated parameter, output characteristic and driven principle and driving type of piezoelectric - stack
壓電疊堆泵是一種以壓電疊堆作為驅動元件的微型泵，它是隨著mems的發展而發展起來的。本文提出利用壓電疊堆與柔性鉸鏈放大機構配合來驅動微型泵的橫隔膜，以達到泵送流體的目的。本文在查閱國內外大量文獻的基礎上，總結了國內外壓電疊堆泵的研究現狀，分析了壓電疊堆的動靜態特性，提出一種以壓電疊堆作為驅動源的壓電流體泵的構想。 -
This paper briefly presents the theory of the inner evaporative cooling system with pump in generator and a suit of simulation software developed based on it using c computer language
本文簡要介紹了汽輪發電機定子繞組內部蒸發冷卻的技術原理，著重介紹了一套基於此基礎之上的用c語言開發的模擬軟體。 -
For the first time, it puts forward a conception of. thermal dynamic simulation and sets up a supposed analytical theory for scuffing failure and cylinder scoring of piston assembly and cylinder liner. that is followed with the simulation of scuffing failure and cylinder scoring of internal combustion engine under the condition of stopping cooling water supply and over loading
首次提出了熱動態模擬的概念，第一次大膽假設了活塞組、缸套擦傷、拉缸時的分析理論，模擬出了在中斷冷卻水和超負荷狀態下柴油機的擦傷、拉缸。 -
This paper presents the characteristics of htsc ( high temperature superconductor ) materials, design and manufacture of a htsc filter and a low noise amplifier, which works at low temperature, and the basic theory of a cooling system
本文介紹了高溫超導材料的基本特性，超導濾波器及低溫低噪聲放大器的設計、製作與調試，並且詳細的介紹了製冷系統，最終設計研製出了「高性能接收機前端」 。 -
Through analysis and discussion on experiment theory and structure of calorimeter, the precision and veracity of apparatus can be efficiently enhanced with improvement on cooling emendation which is very important to calorific value measurement
本文通過對恆溫式氧彈儀試驗原理和結構的分析和探討，對測定發熱量過程中至關重要的冷卻校正計算進行改進，有效的提高了儀器測量的精確度和準確度。 -
Based on the theory of gas dynamics and thermodynamics, the cooling mechanism and the formation and running rule of shock wave in the tube of the thermal separator was explored
從熱力學及氣體動力學角度出發，探討了熱分離機的製冷機理、激波的形成與運動規律。 -
4. the paper proved that when the cooling channel belongs to the transitional region from macro - scale to micro - scale, whether the macro - scale theory or the micro - scale theory will be used depends on the accuracy that the researcher reqired, and does not need to depend on the knudsen number
4 、當冷卻通道屬于宏觀尺度到微觀尺度的過渡區域時，求解計算是採用宏觀理論還是採用微觀尺度的理論，主要是看研究者對求解答案的精度要求，而不必一定按照kn數進行判斷。 -
Ultrasonic plastic welding theory is generated by the generator 20khz or 15khz pressure, high - frequency signals, the system can be adopted for the high - frequency signals into mechanical vibrations, and in plastic products working, through working surface and internal friction among elements spread by the department of the interface temperature, when the temperature reached the melting point of her own, that the working interface rapid melting, and then fill in the gaps between the interfaces when shock stop working at a certain pressure and cooling will be a perfect welding
的高壓高頻信號通過換能系統，把信號轉換為高頻機械振動，加於塑料製品工件上，通過工件表面及內在分子間的磨擦而使傳處到介面的溫度升高，當溫度達到此工件本身的熔點時，使工作介面迅速溶化，繼而填充于介面間的空隙，當震動停止，工件同時在一定的壓力下冷卻定形成完美的焊接.點擊數： 723錄入時間： 2006 - 5 - 14 -
Based on the characters of structure of the project, the structural style selection is given and analysis program of the latticed shell of double - layer hyperbolic pyramid cooling tower is programmed by the finite element theory and vb 6. 0 advanced programming language, which includes of 15 programs and directly aims at cooler tower and gives the forcing property by the computing program of the latticed shell of double - layer hyperbolic developed. analysis of static stress and temperature stress is given out by means of three dimens ions members finite element and numerical analysis, optimum design of member sections is given out by full stress, analysis of geometric nonlinear is given out by nonlinear finite element, analysis of earthquake stress is given out by the mode decomposition response - spectrum method, the latticed shell cooling tower compared with the reinforced concrete structure finally
該軟體包括15個程序，其針對性強，直接針對冷卻塔，對該結構進行了受力分析，具體分析包括：採用空間桿件有限元和數值分析方法對結構進行了靜力分析與溫度應力分析；採用滿應力法對應用於冷卻塔的桿件截面進行了優化設計；採用非線性有限元分析方法，並利用荷載增量法對該結構進行幾何非線性分析；採用振型分解反應譜法對網殼的自震特性及地震反應作了一定的研究；並且將具體工程的研究結果與鋼筋混凝土結構冷卻塔進行對比。 -
By testing, the total thermal of the microchannel heatsink for cooling high power semiconductor diode laser arrays is 0. 645 / w, which is consistent with the result of theory counting
通過測試，所制得的無氧銅微通道熱沉冷卻半導體激光器的總熱阻為0 . 645 ~ 0c w ，與理論分析基本吻合，滿足散熱要求。 -
Then, current perception threshold system is discussed in details including three main aspects : physiological background, theory of udtr and forced choice method and experiment basis providing the evidence for us to substitute heating, cooling and vibration signals with 5hz, 250hz, 2000hz sine current signals, respectively. the most important part of this thesis is the design of the system
然後詳細論述了定量電流感覺測量系統的理論基礎，包括三個方面：生理學基礎；閾值檢出演算法（ udtr和forcedchoice方法）的理論基礎；實驗基礎，即大量實驗表明， 5hz ， 250hz和2000hz的正弦交流電流刺激分別可以代替加熱，致冷和振動信號。 -
The channel scale on transpiration cooling for the platelet thrust chamber of liquid propellant rocket engine is approaching micron dimension. it is very possible that micro - scale effects will occur in the flow and heat transfer of the channel. in the past, researchs on flow and heat transfer in the platelet micro - channel are mostly based on macro - scale theory
液體火箭發動機推力室壁面發汗冷卻通道的尺度已達微米量級，通道內的流動與換熱很可能存在微尺度效應，以前的相關研究都以宏觀尺度的理論為依據，其研究結果的合理性需要進行微尺度效應的分析。 -
Based on analysis on determining principal and process, we particularly discuss caloric emendation during the course of measurement and apply newton cooling theory to explain thermal exchange between inner and outer barrels due to temperature difference
論文通過對恆溫式氧彈儀測定發熱量原理和過程的分析，詳細探討了測量過程中的熱量校正問題。
分享友人