cooling time 中文意思是什麼

cooling time 解釋
冷凍時間
  • cooling : n. ,adj. 冷卻（的）。
  • time : n 1 時，時間，時日，歲月。2 時候，時刻；期間；時節，季節；〈常pl 〉時期，年代，時代； 〈the time ...
  1. Test study on two biocides, namely quaternary ammonium salt and isothiazolinelcetone, commonly used in circulatory cooling water system has been carried out, obtaining the relationship among dosage, actuation time duration, and the killed persontage, and putting forward the principle and points needing attention for selecting the biocide

    摘要對火電廠循環冷卻水系統常用的兩種殺菌劑季胺鹽及異噻唑啉酮進行了試驗研究，得出加藥量、作用時間與殺菌率的關系，並提出殺菌劑的選擇原則和注意事項。
  2. When a cryogen spurt is applied to the skin surface for an appropriately short period of time ( on the order of milliseconds ), the cooling remains localized in the epidermis, while leaving the temperature of the deeper vessels of hemangiomas unchanged

    摘要激光治療血管瘤成功的先決條件是經由選擇性光熱效應破壞皮下擴張的血管而不造成表皮的傷害。
  3. This article choosed out organic phase change materials, and, the solid - liquid - equilibrium of eleven binary system including fatty alcohol / fatty acid, n - octadecane / fatty acid, n - octadecane / fatty alcohol system were determined by cooling curve, and, t - x phase diagrams of these systems were drawn. the result shows that all these systems are simple eutectic, at the same time, the entropy of phase change of every system in the eutectic point is determined by using differential scanning calorimetry ( dsc ). and n - octadecane / fatty acid systems were calculated theoretically

    本文初選出部分有機相變貯能材料，採用步冷曲線法測定了12醇-羧酸系列、 18烷-羧酸系列、 18烷- 12醇體系共11組體系的二元固液相平衡關系，繪制了這11組體系的t - x相圖，測定結果表明，這幾組體系均為簡單低共熔體系；同時利用差熱掃描量熱法（ dsc ）對上面各組體系低共熔點處的相變焓進行了測定；並對18烷-羧酸系列進行了熱力學理論預測。
  4. At the same time of ensuing heat - exchange area and cooling effect, the condenser is matched perfectly with vehicle

    在保證換熱面積及製冷效果的同時與主機車型達到最佳匹配
  5. To reduce the marking distortion, using the vertical 2 - dimension galvanometer distributing and f field lens focalize, the distance of the second galvanometer to the machining plane is the focus f. to avoid too hign temperature to distroy the resonance cavity because of too long marking time, cooling system and self - protector is used in the design

    為減少打標畸變，採用垂直二維振鏡分佈， f物鏡聚焦，將激光束經第二個振鏡反射後到加工平面的距離為焦距f ，為了避免打標時間過長，溫度過高破壞諧振腔，在設計中加上冷卻系統和自我保護裝置。
  6. This is no time to engage in the luxury of cooling off or to take the tranquilizing drug of gradualism

    現在決非侈談冷靜下來或服用漸進主義的鎮靜劑的時候。
  7. This is not time to engage in the luxury of cooling off or to take the tranquilizing drug of gradualism

    現在決非侈談冷靜下來或服用漸進主義的鎮靜劑的時候。
  8. Annealing cooling processes are classified in accordance with material and thickness of each steel coil in annealing plan, then multi - input and single - output modeling problem for cooling time prediction of hood - type annealing furnace is simplified to a group of single - input and single - output modeling problem

    摘要按照退火計劃內各鋼卷的鋼種和厚度對退火中的冷卻工藝進行分類，將罩式退火爐冷卻時間預報的多入單出建模問題化為一組單入單出建模問題。
  9. The max. temperature, cold runner result shows the max. temperature across the cold runner temperature profile calculated at the end of cooling time

    冷卻結束時，冷澆道斷面上最高溫度分佈情況（與頂出溫度相比，判斷此時是否頂出） 。
  10. Kelvin ' s calculation pointed to the the existence of an internal heat supply which has kept the earth hot long after the radiative cooling time

    開爾文的計算指出了存在的一個內部熱量供應，其中至今仍保持著地球上的熱點，只要經過輻射冷卻時間。
  11. Fuzzy c - means algorithm is used to cluster the production data in batch annealing process, then the exponent least square algorithm is used to get the relationship between cooling time and weight of clusters

    採用模糊c均值聚類方法對退火生產數據進行處理，再基於得到的聚類數據點進行指數最小二乘回歸。
  12. The gelation with complete cooling time of 40min had a high yields and encapsulation efficiency, and the process may be contrplled. the micropcms was stable and its diameter was uniformity. the thermal profile of microcapsule was not affected by the ratio of gelation, but the thermal was not good enough

    結果表明：以明膠-阿拉伯樹膠為壁材制備的相變儲熱微膠囊平均粒徑均勻；壁材完整，包覆效果較好；熱分析顯示，相變儲熱微膠囊具有自調溫功能，但明膠-阿拉伯樹膠為壁材的微膠囊熱穩定性較差。
  13. Poor thermal exchange between mould cavity and part during cooling time

    冷卻時，模腔和製品間的熱交換差
  14. Study of the calculating method of cooling time for interrupted quenching

    雙介質淬火冷卻時間計算方法的研究
  15. The kelvin cooling time for the earth is then about 30, 000 years

    在開爾文的冷卻時間，地球是那麼大約3 . 0萬年。
  16. Increase in cooling time is proportional to the square of the increase in thickness

    冷卻時間增加同厚度增加的平方成正比。
  17. Increase cooling time

    增加冷卻時間
  18. Raise cooling time

    增加冷卻時間
  19. Welding parameter. ( reference values for electric socket welding - welding time and cooling time

    熔接參數（參考數值為電承插熱熔，熱熔時間和冷卻時間
  20. Practical application shows that the method can achieve more correct cooling time prediction of annealing furnace and meet the need of worksite

    現場應用表明，該方法能夠較為準確地實現退火爐冷卻時間預報，滿足了現場要求。
分享友人
分享到 Line

分享到臉書