cooling trough 中文意思是什麼
cooling trough
解釋
冷卻槽-
This utility model publicizes one kind of energy - saving heating stove belonging to heating stove technology, especially involving in a type of hot water energy - efficient heating stove, which mainly composed by the furnace body, the firebox, and the trough for releasing ash. on the furnace body is equipped with the hot water exportation, the cooling water inlet, the chimney, and the mouth for releasing ash. in the furnace body is equipped with the heater pipe, the thermal baffle, the furnace grate and the air throttle. in front part of the furnace body is equipped with the firebox door and the air throttle for entering. in front part of the trough for releasing ash is equipped with door. this energy - saving heating stove overcomes the deficiencies of the existing technology to provide good burn, smoke - free and dustlessness, and not to stop up the chimney and not to produce gas, which extremely suits to the households heating in rural areas
本實用新型公開了一種節能採暖爐，屬于採暖爐技術領域，尤其涉及一種熱水型節能採暖爐，主要由爐體、燃燒室、泄灰槽構成，爐體上設有熱水出口、冷水進口、煙筒、泄灰口，爐體內設有加熱管、隔熱板、爐箅子、內風門，爐體前部設有燃燒室門和進風門，泄灰槽前部設有泄灰槽門，本節能採暖爐克服了現有技術的不足提供了一種燃燒好、無煙無塵，不堵煙筒又沒煤氣的環保型節能採暖爐，非常適合於農村家庭採暖使用。 -
This segregation behavior of sn accords with the mechanism of non - equilibrium segregation. it can be obtained through the theoretical calculations that the critical time of sn non - equilibrium segregation is 124 seconds at 750 and the critical cooling rate is 8 / s when cooling from 1320. it is suggested that controlling the cooling rate during continuous casting to avoid the critical cooling rate ( 8 / s ) and avoiding high stress near the trough temperature ( 750 ) may control the form
通過研究殘留元素sn的偏聚機制及其對o . 15wt . % c鋼熱塑性的影響，對試驗鋼進行脆性預測:建議在該鋼的連鑄過程中彎道矯直溫度盡量避開塑性谷底溫度750 ，二冷區的冷速盡量避開臨界冷卻速率8 / s ，從而可以減少該低碳鋼連鑄坯表面裂紋和橫向裂紋，提高其成材率。 -
The segregation mechanism of tramp element sn during continuous cooling and isothermal aging and its influence on the hot ductility of low carbon steel are discussed and the brittleness during continuous casting of the sn - doped low carbon steel is forecasted. at a strain rate of 10 - 2s - 1 and a cooling rate of 10 / s, there exists a third ductility trough for both steels at 750
在應變速率和冷卻速率分別為10 ~ （ - 2 ） s和10 s的條件下進行熱模擬拉伸時，兩種試驗鋼均在750時出現由先共析鐵素體沿奧氏體晶界呈薄膜網狀析出所引起的第類脆性谷底。
分享友人