copper electrode 中文意思是什麼

copper electrode 解釋
銅電極
  • copper : n 1 銅；紫銅。2 銅幣，銅錢，〈pl 〉零錢。3 銅器；銅罐，銅壺，銅鍋；銅管；銅製品。4 （紫）銅色。5 ...
  • electrode : n. 1. 電極。2. 電焊條。adj. -less 無電極的。
  1. Determination of copper in water by a l - cysteine modified gold electrode

    半胱氨酸修飾金電極測定水中銅離子的研究
  2. 1 ) the synthesis and structural characterization of 5, 10, 15 - tris ( penta - fluorophenyl ) corrole and its corresponding [ 5, 10, 15 - tris ( pentafluorophenyl ) corrolato ] manganese ( iii ) ; 2 ) the synthesis and structural characterization of series of porphyrin and metalloporphyrins as follows : chloro [ 5, 10, 15, 20 - tetra ( p - methyl - phenyl ) - porphinato ] manganese ( iii ), chloro [ 5, 10, 15, 20 - tetra ( p - methyl - phenyl ) - porphinato ] iron ( iii ), [ 5, 10, 15, 20 - tetra ( p - methyl - phenyl ) - porphinato ] copper ( ) and - oxo - bis [ 5, 10, 15, 20 - tetra ( p - methyl - phenyl ) - porphinatomanganese ( iii ) ]. 2. in the third charpter, a highly selected silver electrode based on 5, 10, 15 - tris ( pentafluorophenyl ) corrole has been prepared, and its response was compared with that of metallo corrole counterpart and 5, 10, 15, 20 - tetra ( phenyl ) porphyrin

    3 、制備了以-氧-雙（ 5 ， 10 ， 15 ， 20 -四（對甲基苯基） ）錳卟啉載體的鉬酸根選擇性電極，並與5 ， 10 ， 15 ， 20 -四（對甲基苯基）鐵卟啉、 5 ， 10 ， 15 ， 20 -四（對甲基苯基）錳卟啉、 5 ， 10 ， 15 ， 20 -四（對甲基苯基）銅卟啉電極的響應性能進行了比較，對電極的膜組份進行了優化，並分別考查了電極的選擇性、 ph值影響、穩定性和壽命等，並將該電極應用於腐蝕抑制劑中鉬酸根的測定。
  3. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  4. The electrode was found to decrease the solubility of dithizone in alkalescence solution and effectively minish the lose of deoxidize state of metal. third, a potentiometric sensor was prepared by adding copper diethyldithiocarbamate directly into the carbon paste mixture, and the electrode was found has nerst response to copper ion in solution. and in our research two pharmaceutical selective electrodes were fabricated by coating polyvinyl chloride ( pvc ) which contained electroactive material on carbon rod electrode

    第二，利用- cd與環氧氯丙烷形成的交聯聚合物（ - cdp ） （不溶性）包合了雙硫腙，然後將- cdp與雙硫腙包合物樹脂作為修飾劑制備了碳糊修飾電極，利用陽極溶出伏安法（ asv ）測定了pd ~ （ 2 + ） ，實驗發現通過包合降低了雙硫腙在堿性溶液中的溶解度並且減少了金屬還原態的流失，取得了較好的效果。
  5. Introduction cl21s are non - inductively wound with meatllized polyester film stacked as the dielectric electrode with copper - clad steel leads and epoxy resin coating

    Cl21s為無感結構，用金屬化聚酯膜作電介質電極繞制而成，導線採用鍍錫銅包鋼線，使用環氧樹脂包封。
  6. Appliance of iron alloy sacrifice electrode in seawater pipe made of copper or other alloy

    鐵合金犧牲陽極在銅及其合金海水管路中的應用
  7. Study on the adsorptive - voltammetric behavior of the complex of copper and cps at paste carbon electrode

    銅鐵試劑絡合物在碳糊電極上的吸附伏安行為
  8. Experiment shows that the long effect copper electrode can be used as measuring stray current corrosion on buried metal structure in metro concrete structure

    實驗證明，長效銅硫酸銅電極可以在地鐵的混凝土結構中用於測量理地金屬結構的雜散電流腐蝕。
  9. Selecting 45 # steel and copper as the workpiece material and electrode material, respectively, experiments have been carried out, the results showing that uedm is a method with a high material removal rate ( mrr )

    分別採用選拔45 #鋼作為工件材料，銅作為電極材料進行實驗，結果顯示uedm是一種具有高材料切除率（ mrr ）的加工方法
  10. Cbb88 are non - inductively wound with electrode of double - layer metallized polyester film and dielectric of polypropylene. wrapped with polyester tape and sealed with wpoxy resin, usetinned copper leads

    Cbb20為無感結構，用聚丙稀膜作為電介質和鋁箔作為電極繞制而成，導線採用鍍錫銅線，外層用聚酯膠帶包裹，兩端使用環氧樹脂密封。
  11. In this article, the micromorphological structure of pva - copper gradient composite film ( mpgcf ) obtained from the electrochemical reduction of a swelling cathode films ( scfs ) was studied by the scaning electronic microscope and the relationship between the micromorphological structure of the composite film and the electrochemical conditions such as the weight ratio of pva to cuc12, the material of the electrode, the concentration of the medium solution, the dring time of scf, the power voltage, the time of the electochemical reaction etc, investigated

    本文採用「溶液還原法」制備了一種新型的聚合物基金屬梯度復合材料（ mpgcf ） ? pva /銅梯度復合膜。通過掃描電子顯微鏡觀察了梯度復合膜的形態結構並研究了其形態結構與電化學條件之間的關系。然後在此基礎上，探討了梯度復合膜的形態結構與力學性能之間的關系。
  12. Copper alloys for resistance welding electrode

    電阻焊用銅合金電極材料
  13. Effects of additive agent on the morphology of superfine copper powders for mlcc electrode

    電極用超細銅粉形貌的影響
  14. Mef are non - indluctively wound with metallized polyester film as the dielectric / electrode with copper - clad steel leads and epoxy resin coating they are suitable for blocking, copling decoupling filtering, by - pass and timing circuits, they find application in telecommunication, date processing, industrial instruments. and automatic control system epuipments

    Mef為非感應式，用鍍金屬聚酯薄膜作為電介質/電極，導線採用鍍錫銅包線和環氧樹脂包封.本品適合於耦合、濾波、整流和計時電路中，在遠程通訊、數據處理、工業儀表和自動控制系統的設備中得到了運用。
  15. Are non - inductively with wound polyester film as the dielectric and aluminum foil as the electrode with copper - clad steel leads and epoxy resin coating

    為有感結構，用聚酯薄膜作為電介質和鋁箔為電極繞制而成，導線採用鍍錫銅包銅線，使用環氧樹脂包封。
  16. Are non - inductively wound with polypropylene film as the dielectric and aluminum foil as the electrode with copper - clad steel leads and epoxy resin coated

    為無感結構，用金屬化聚丙烯膜作為電介質和鋁箔為電極卷繞而成，導線採用鍍錫銅包銅線，使用環氧樹脂包封。
  17. Are non - inductively wound with metallized polypropylene film as the dielectric and aluminum foil as the electrode with copper - clad steel leads and epoxy resin coating

    為無感結構，用聚丙烯薄膜作為電介質和鋁箔為電極繞制而成，導線採用鍍錫銅包銅線，使用環氧樹脂包封。
  18. Aluminum oxide dispersion strengthened copper electrode produced by mechanical alloying

    機械合金化法制備彌散銅電極
  19. After studying the precision of fdm process, a rapid edm electrode fabrication technology based on fdm is developed, the technology, which combined pulse - reverse electroforming with strengthening of copper wire - arc spraying, can obtained compact crystal electrode ' s working part, and strengthened filling part which has big adhesion strength, better electricity and heat conductivity, the edm performance of the obtained electrode reaches that of electrolysis copper electrode

    繼fdm工藝精度研究后，開展了快速模具製造技術的研究，建立了基於fdm原型快速製造電加工電極的工藝。該工藝將脈沖電鑄和電弧噴塗紫銅背襯相結合，獲得了結晶緻密的電極工作層和結合強度高、導電與導熱性良好的電極背襯層，得到的電極達到了常規機加工紫銅電極的電加工性能。
  20. By formation of epoxy coating on n - dodecanethiol self - assembled monolayer on copper substrate, self - assembled monolayer was introduced between epoxy coating and copper electrode

    通過在正十二硫醇自組裝單層膜表面制備環氧樹脂塗層的方法，在塗層銅基體界面引入自組裝界面層。
分享友人
分享到 Line

分享到臉書