core winding 中文意思是什麼

core winding 解釋
芯繞組
  • core : CORE ＝Congress of Racial Equality 〈美國〉爭取種族平等大會。n 1 果心。2 （事物、問題等的）中心，...
  • winding : adj. 1. 卷繞的；繞線的，繞組的。2. 迂迴曲折的，蜿蜒的。n. 1. 卷繞起來的一盤（繩索等）；卷繞動作；絡紗。2. 彎曲，紆曲；不正行為。3. 【采】卷揚，提升；【電學】繞組，繞法；線圈。
  1. The winding can be mechanized convolute arrond the stator core

    同時沒有沖剪下腳料產生，提高了定子硅鋼片材料利用率。
  2. Being added an anti - phase compensating winding, this device, which is placed between high voltage line and first insulator, makes the synthesized magnetic field in magnetic core reach a dynamic balance, and thus solves the problems from remanence and assures the measurement accuracy

    其漏電流傳感器增加一個反相的補償線圈，使得電流傳感器磁芯內的合成磁場達到動態平衡，解決了由於剩磁而帶來的問題，保證了測量精度。
  3. This paper uses field methods to calculate the winding loss and the modified steinmetz experiential equation for core loss calculation

    鐵心損耗的計算是基於steinmetz經驗公式來進行的。
  4. In the models, the iron core nonlinearly of the traction transformer and the magnetic hysteresis effect without the b - h curve are considered. having tested by digital simulation, the winding parameter has not changed in the state of external fault or magnetizing inrush etc. but the winding parameter has obviously changed in state of inter fault or inter - turn fault. ( 3 ) the rules three phases converted to two phases of traction transformer in electric railways are developed in this paper

    （ 3 ）利用牽引變壓器磁鏈平衡方程，建立了基於系統辨識理論的雙繞組單相接線牽引變壓器、阻抗匹配平衡牽引變壓器及scott （斯科特）接線牽引變壓器的「灰箱」模型，該模型考慮了牽引變壓器鐵芯非線性和磁滯效應，但又不直接反映在模型中，並且無需鐵芯的b - h曲線數據。
  5. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。
  6. The haskell was made by winding hundreds of feet of elastic thread on to a central core. it was then coated with gutta percha

    這種橡膠中空球是將幾百英尺的彈性線以同心纏繞成的球體，然後用橡膠塗層。
  7. An a. c. voltage of 2000 volts is applied between the winding and ground to test the integrity of the insulation between the winding and core iron

    在線圈繞組和地線上加上2000伏交流電以測試線圈繞組和芯鐵之間的絕緣的整體性能。
  8. Air - core winding

    無芯線圈
  9. The no - loading emf of prototype and the no - loading emf of conventional generator are contrasted and analyzed, in the condition of considering the influence of damping winding and core saturation

    並在考慮鐵心飽和、考慮阻尼繞組影響情況下，將傳統發電機的空載電勢與電力發生器樣機的空載電勢進行了比較、分析。
  10. Considering the influence of damping winding and if core is saturated or not, the no - loading emf waveform of a conventional generator having the same size with the prototype ( except the stator slot ) is analyzed, and the waveform deviation factor is taken out

    對一臺具有與電力發生器樣機相同尺寸（除定子槽形）傳統發電機的空載電勢波形進行了分析。分析了不考慮鐵心飽和、考慮阻尼繞組影響和考慮鐵心飽和、考慮阻尼繞組影響兩種情況下，它的空載感應電勢，求取了空載電勢波形畸變率。
  11. According to the no - loading waveform deviation factor, the prototype conforms to the national design standard and practical needs in the engineering. more important, the high voltage is achieved. in the condition of considering core saturation and damping winding influence, the influence to powerformer of the no - loading tooth harmonic emf is smaller than conventional generator, and the waveform deviation factor of the former is smaller, too

    由求得的樣機空載電勢波形畸變率可知，該樣機滿足國家設計標準和工程實用要求，更重要的是，實現了產生高壓的目的；考慮鐵心飽和、考慮阻尼繞組影響情況時，電力發生器與具有相同尺寸（除定子槽形）的傳統發電機相比，空載齒諧波電勢對電力發生器的影響較小，前者的空載波形畸變率較小。
  12. The paper discusses the work princinple of ldcsm, adopts singlechip as core control cell, puts forward two kinds of control schemes, analyzes and study the technique scheme, hardware and software design of each control system separately in detail, on the basis of the centralized winding electrifying trait and pulse stepping control method of two phase hybrid linear dc step motor ( hdclsm )

    論文在討論了直線直流步進電動機工作機理的基礎上，根據兩相混合式直線直流步進電動機（ hdclsm ）集中繞組的通電特點和脈沖步進控制方法，採用單片機為核心控制單元，提出了兩種數字控制方案，分別就每種控制系統技術方案、硬體電路、控制軟體設計等技術內容進行了詳細地分析和研究。
  13. The series of current transformers are resin insulated ， fully enclosed and busbar type. the iron core is circular and the secondary winding goes around the core before casting by epoxy

    本型電流互感器的鐵心為圓環形，二次繞組勻繞制在鐵心圓周上，用環氧樹脂混合料澆注成形。
  14. The thermal model used in this paper can figure out the temperature rise of the winding and core respectively

    本文採用的熱模型包含兩個熱源和三個熱阻，可以分別計算出平面變壓器繞組和鐵心的溫升。
  15. Areas for future research include : measuring core distortion and losses, primary winding coupling ( for class b applications ), tests with feedback, and last, but not least, listening tests

    進一步的研究領域還可以包括：測量鐵芯失真和鐵損，初級繞組耦合（ b類應用） ，在有反饋的環境下測試，還有，聽感測試等等。
  16. Based on the relevant theoretical researches, the loss property of the magnetic core material and winding were analyzed in this thesis. and 500 khz high frequency switching mode power supply transformer was made of pc40 magnetic core material for the first time in this thesis, which has good application perspective and can lead to enormous economic profits

    本文在理論研究的基礎上，仔細分析了磁芯材料及繞組的損耗特性，首次採用pc40磁芯材料設計了500khz高頻開關電源變壓器，這在工程上有良好的應用前景和經濟效益。
  17. 1. nizn ferrite was developed for using in mini high frequency dc - dc converters and inductors. we measured and analysed the parameters of the nizn ferrite, which we concern about when designing the dc - dc converter. 2. the low loss sample of nizn ferrite were chosen for design - optimization of the high frequency transformer. based on the relevant theoretical researches, the loss properties of the magnetic core material and winding were analyzed in this thesis

    因此，以nizn功率鐵氧體材料為開關電源芯材為基礎，並優化各種開關電源的設計已成為國際上的熱點和技術瓶頸，本論文正是以上述背景為研究目標而開展工作的，主要進行的工作和創新有: 1 .對研製的新型高頻低功耗的功率nizn材料進行參數的測試，並針對dc - dc變換器設計關心的參數對芯材特性進行了分析，選擇在特定頻率下，功耗較小的nizn材料磁芯樣品作為變壓器優化設計的預備磁芯。
  18. Using stable heat transferring theory, a thermo hydraulic model has been built, which has considered the influence of the core temperature and cooling hydrogen temperature. and bring forward a modifying method, which let the model can be used in the varying winding current condition

    在此基礎上本文提出了溫度傳遞延時的修正方法，使基於穩態傳熱的溫度水力模型可以應用到定子電流發生變化的情況，解決了定子電流變化時模型精度差的問題。
  19. The iron core of the product is annular. the secondary winding go uniformity around the core. the clip clamps the core

    本型零序電流互感器的鐵心為環形，二次繞組均勻繞制在鐵心上，用夾件夾緊鐵心，夾件備有安裝孔。
  20. The essential features of digicone control system are the use of a microprocessor to control the winding unit. we related the hardware structure and the software design in core of mcs - 51 microprocessor and give the designing way of digicone technology

    文章中著重敘述了以mcs - 51單片機為核心的數控卷繞裝置控制系統，對該控制系統的硬體結構和軟體設計作了比較詳盡的敘述。
分享友人
分享到 Line

分享到臉書