cracking method 中文意思是什麼

cracking method 解釋
加熱分裂法
  • cracking : adj 分裂的，分解的；〈美俚〉極快的，猛烈的。 cracking distillation 【化學】裂解蒸餾（法）。 crack...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Standard test method for evaluating stress - corrosion cracking of stainless alloys with different nickel content in boiling acidified sodium chloride solution

    沸騰酸化氯化鈉溶液中不同鎳合量不銹鋼合金應力腐蝕裂紋評定的標準試驗方法
  2. Analyzed the reason of stress corrosion cracking on u shape brass tube bundle when it is having penetrative test with ammonia, improved technology of test and gave out the method should be paid attention to during the process of brass tube exchanger

    摘要對黃銅管換熱器管束在氨滲試驗過程中發生應力腐蝕，導致銅管破裂的原因進行了分析，改進了施工方案，並提出了黃銅管換熱器製造過程中對管束進行耐壓試驗時的注意事項。
  3. Standard test method for outdoor evaluation of tire sidewall component cracking resistance

    輪胎側壁組件抗斷裂性能的室外評定標準試驗方法
  4. The quality of furan sand castings is usually better than clay sand castings, however, some defects are also very easy take place with furan sand castings such as blow hole, metal penetration, veining, cracking, slag inclusion, hardness too low, surface recarburation, surface sulphuration, nodularity degeneration etc, which were usually caused by improper raw materials selection, improper method design, incorrect moulding or / and core - making

    摘要呋喃樹脂砂鑄件質量一般比黏土砂鑄件好，但如果原材料選擇、工藝設計、造型和制芯操作不當，也會產生氣孔、粘砂、脈紋、裂紋，夾渣、硬度不足、滲碳、滲硫和球化不良等鑄造缺陷。
  5. The temperature cracks are calculated by use of a crack band model, and the stress and cracking of the concrete wall are computed by using the half - analytical iteration method

    採用裂縫帶模型計算溫度裂縫，用半解析迭代法進行了混凝土墻的溫度應力和開裂計算。
  6. Standard test method for determining whether gas - leak - detector fluid solutions can cause stress corrosion cracking of brass alloys

    測定氣漏檢測器液體溶劑是否能引起黃銅合金應力腐蝕斷裂的標準試驗方法
  7. Test method for determining cold cracking of flexible plastic materials

    測定彈性塑料材料冷裂的試驗方法
  8. Welding and allied processes. cold cracking on implants. test method

    焊接和相關工藝.插銷的冷裂.試驗方法
  9. Flame tube in aircraft engine undergoes high temperature and high speed airflow washing. a hypothesis was suggested, which takes the transient heat transferring as the main reason to the cracking and damage on flame tube. finite element method was adopted to simulate the thermal fatigue and the hypothesis was reproduced

    發動機火焰筒的熱疲勞損傷是導致火焰筒失效的主要原因，本文提出了一種火焰筒熱疲勞損傷假設，認為火焰筒熱疲勞損傷不是由於發動機的運行和停車時冷熱溫度循環造成的，而是發動機啟動時瞬態溫度傳導過程中材料循環塑性變形的結果，利用該假設結合有限元計算模擬了火焰筒產生疲勞損傷的原因。
  10. Standard test method for determining stress - corrosion cracking resistance of heat - treatable aluminum alloy products using breaking load method

    用破壞載荷法測定可熱處理鋁合金製品的抗應力腐蝕開裂特性的標準試驗方法
  11. Method of t - joint weld cracking test

    T型接頭焊縫裂紋試驗方法
  12. Abstract : in this article, it is introduced that a method of rooting has been successfully used in stabing the base of stockhouse of grain, in order to effectively stop sinking and cracking and extend the lifetime of those buildings, which do not have firm base

    文摘:針對浙江省奉化市糧食局米廠大米車間、糧庫基礎托換和鍋爐房基礎加固工程，成功地應用樹根樁基礎托換技術，使沉降和裂縫得到有效控制，危房再現使用價值。
  13. By using the method of fault tree analysis, this paper analyses the causes of fire and explosion of catalying & cracking reactor and regeneration, draws the fault trees of fire and explosion accidents of catalyzing & cracking reactor and regeneration respectively, calculates the structure importance, makes the structure importance arrangement according to the structure importance and the least path set, puts forward the prevention measures, and provides the reliable theoretical basis for the safety control of enterprises

    摘要應用故障樹分析方法，對催化裂化反應器和催化裂化再生器發生火災（爆炸）事故的原因進行分析，分別畫出催化裂化反應器和催化裂化再生器發生火災（爆炸）事故的故障樹，得出最小徑集合，並計算其結構重要度，根據得出的最小徑集合及其結構重要度進行排序，提出預防措施，為企業的安全管理提供了可靠的理論依據。
  14. Finally, in view of the complexity and non - linearity of the pavement in cracking and breakage, the paper tries to explain the formation in the cracks of the pavement and mechanism & process of expansion by nonlinear theories ( like chaos, fractal etc. ) and to describe the whole process of fissures and breakage so as to provide a new thought and method for the study of the cement concrete.

    最後，考慮到路面開裂和破壞的復雜性和非線性，本文採用非線性科學理論（如混沌、分形等）來解釋路面裂縫生成和擴展的機理和過程，從總體上對開裂和破壞的全過程加以描述，為水泥混凝土路面的開裂機理和破壞過程研究提供一種新的思路和方法。
  15. According to different working performance ofjhe partially prestressed structure after cracking under the piling loads, the calculating formulae of the " complete stress " are deduced separately by means of linear - elastic or nonlinear analysis method

    根據部分預應力構件在荷載分期作用下不同的受力性能，分別用線彈性方法和非線性分析方法推導了預應力構件開裂截面全應力的計算公式。
  16. Standard test method for determining susceptibility to stress - corrosion cracking of 2xxx and 7xxx aluminum alloy products

    測定高強度鋁合金製品應力腐蝕斷裂敏感性的標準試驗方法
  17. Standard test method for rubber deterioration - surface cracking

    橡膠變質的標準試驗方法.表面龜裂
  18. Weldability testing - method of cracking test for welded tee joint

    型接頭焊接裂紋試驗方法
  19. Plastics - determination of resistance to environmental stress cracking - bent strip method iso 4599 : 1986 ; german version en iso 4599 : 1996

    塑料.耐環境應力龜裂測定.彎形條塊法
  20. But, for the reflective cracking of asphalt pavement with half rigid base course and the cracking of the ac overlay above joints ( cracks ) in existing pcc pavement, the results of research show that the fatigue life of ac layer is mainly the life of the crack propagating stage. so the theory and method of fatigue destructive mechanics ( fatigue fracture mechanics and fatigue damage mechanics ) should be used to study and design the pavement structures instead of traditional fatigue mechanics

    而對於半剛性基層反射裂縫和舊水泥混凝土路面瀝青混凝土加鋪層接縫（裂縫）開裂，研究發現，瀝青結構層的疲勞壽命主要為裂縫擴展階段的壽命，此時不應採用傳統的疲勞力學進行研究和結構層設計，而應採用疲勞破壞力學（疲勞斷裂力學和疲勞損傷力學）理論與方法。
分享友人
分享到 Line

分享到臉書