crank end 中文意思是什麼

crank end 解釋
連桿頭
  • crank : n 1 【機械工程】曲柄；（刑具）旋盤。2 （言語或思想的）奇特的轉折；狂想，幻想；〈美俚〉想法古怪的...
  • end : n 1 端，尖，末端，終點。2 邊緣；極點，極限。3 結局，結果。4 目的。5 最後，死。6 【紡織；印染】經...
  1. At the other end of the technological spectrum, the american bible society produces an audio device, powered by a battery or hand crank and no bigger than a couple of cigar boxes, that can broadcast the bible to a crowd of a hundred

    而在技術頻譜的另一端，美國聖經公會生產了一種音頻設備，採用電池或手搖發電，不過兩個雪茄盒大小，就能向上百的人群播放聖經。
  2. The crank end of the connecting rod is sometimes called the rod " big end "

    連桿的曲軸有時稱為「大頭」 。
  3. The crank end of the connecting rod is sometimes called the rod "big end".

    連桿的曲軸有時稱為「大頭」。
  4. Maximize the stitch length, and turn the handwheel until walking foot 1 reaches its front end position. now, loosen screw 2 in the center shaft bell crank

    把縫跡調到最大，轉動飛輪，在外壓腳1前進到最前的位置擰松中軸輪緊固螺絲2 。
  5. Cycles. pedal axle and crank assembly with square end fitting. assembly dimensions

    自行車.帶方頭配件的腳蹬軸和曲柄組件.組裝尺寸
  6. The research in this paper is mainly focused on the dynamic - balance theory of motor crank - set, dynamics of vibration unit of balance machine and test methods of dynamic balance diagnostic system. a dynamic balance test system is developed at the end of this paper, which is used for single cylinder motor

    本文所做的主要工作圍繞著對發動機曲柄連桿機構動平衡理論的研究、平衡機振動系統部分的動力學研究以及提出一種對發動機曲柄連桿機構做動平衡測試的測試方法來展開，最終建立了一套用於單缸發動機曲柄連桿的動平衡測試系統。
  7. Cycles - specification for dimensions of bottom bracket axle and crank assembly with square end fittings

    自行車.第14部分:帶方頭配件的底托架軸和曲柄組件尺寸規范
分享友人
分享到 Line

分享到臉書