critical high temperature 中文意思是什麼

critical high temperature 解釋
臨界高溫
  • critical : adj 1 批判的，批評的；（在某方面）有鑒定力的 （in）。2 吹毛求疵的；愛挑剔別人的 （of about）。3 ...
  • high : adj 1 高的〈指物，形容人的身高用 tall〉；高處的；高地的。2 高級的，高等的，高位的，重要的。3 高尚...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  2. The method for measuring the plane strain fracture toughness klc has been introduce to high polymer bonded explosives ( pbx ) by systematically studying technologies concerning the shape of specimen, the depth and its machining of crack, the loading rate, the measurement of critical fracture load, and the computation of klc, etc. the method has been used to test and study klc of three typical high polymer bonded explosives which are j2, jl, j3 respectively both at normal temperature and unmoral temperature

    本文以高聚物粘結炸藥為研究對象，對測試高聚物粘結炸藥的平面應變斷裂韌度所涉及的樣品形狀、裂紋深度及裂紋制備、加載速度、臨界斷裂載荷p _ q的確定及平面應變斷裂韌度k _ （ ic ）的計算等方面進行深入研究，建立了較為完善的炸藥平面應變斷裂韌度測試方法。
  3. Compared with bst materials, especially in thin films, ps t has smaller ferroelectric critical size, lower crystallization temperature, and compatible fabrication with si micro - electronics, so it can meet the need of the high quality si - based integrate circuit ( ic ). moreover, it is important to promote the development of the miniaturization and integration for the modern devices

    與bst相比，特別作為薄膜材料， pst的鐵電臨界尺寸較小，晶化溫度較低，制備工藝與si微電子工藝兼容，更能夠滿足高性能的si基集成電路的需要，對推動現代器件發展的小型化和集成化具有十分重要的意義。
  4. In this paper, the research progress of ac losses of high temperature superconductors and the existing problems on ac losses investigation are introduced ; the characteristics of the critical current and ac losses of hts tapes, stacked tapes and hts coil, such as electro - magnetic characteristics, the anisotropy, the mechanics characteristics and the effects of insular layer between stacked tapes and the influence of frequency of ac transport current etc, are investigated

    本文在系統介紹高溫超導體的交流損耗及其研究現狀與存在問題的基礎上，從理論和實驗兩方面，研究了bi系高溫超導單根帶材、多根超導並聯組合帶材、及超導線圈的臨界電流與交流損耗的特性：重點研究了交流損耗與臨界電流的電磁特性、機械特性、各向異性特性、及帶間絕緣層與傳輸電流頻率對交流損耗的影響等。
  5. Results show that the levitation force is generated between the high temperature superconductor and the magnetic field under the critical temperature. the value of the levitation force is determined by the temperature and the gradient of magnetic field. that is the smaller of the gap, the larger of the levitation force when the temperature is fixed, and the value of the levitation force is an exponential function of the gap

    研究表明，當高溫超導體的溫度低於其臨界溫度時，在磁場中開始受到力的作用；受到的懸浮力大小由溫度和磁場梯度共同決定；即溫度一定時，懸浮間距越小，對應的磁場梯度越大，懸浮力就越大，力的大小與懸浮間距成指數關系；而當懸浮間距一定時，溫度越低，對應的懸浮力也越大，且超導體剛進入超導態的一段溫度區間懸浮力增大最快。
  6. We calculate the stress fracture limit, critical index limit and melting limit in a high power double clad fiber laser. the results show that the average output power decreases when the temperature is too high. to maintain the pumping efficiency and the output power, some cooling methods should be used when the output power reaches a certain level

    給出了熱效應對雙包層光纖激光器影響的裂解極限、臨界折射率極限和熔化極限與光纖結構參數和泵浦功率的表達式，理論分析和數值模擬結果表明對于高功率的雙包層光纖激光器溫度很高時激光增益下降，在一定的功率水平上需要進行外界的冷卻，以保證泵浦激光的效率和高功率的激光輸出。
  7. The finding of high temperature superconductor ( hts ) made a lot of scientists research and study it, then critical temperature of hts was on the increase

    高溫超導材料的發現，引起了眾多科學家的關注並進行研究，使得高溫超導體的臨界溫度提高到液氮溫度以上。
  8. This segregation behavior of sn accords with the mechanism of non - equilibrium segregation. it can be obtained through the theoretical calculations that the critical time of sn non - equilibrium segregation is 124 seconds at 750 and the critical cooling rate is 8 / s when cooling from 1320. it is suggested that controlling the cooling rate during continuous casting to avoid the critical cooling rate ( 8 / s ) and avoiding high stress near the trough temperature ( 750 ) may control the form

    通過研究殘留元素sn的偏聚機制及其對o . 15wt . % c鋼熱塑性的影響，對試驗鋼進行脆性預測:建議在該鋼的連鑄過程中彎道矯直溫度盡量避開塑性谷底溫度750 ，二冷區的冷速盡量避開臨界冷卻速率8 / s ，從而可以減少該低碳鋼連鑄坯表面裂紋和橫向裂紋，提高其成材率。
  9. According to the failure factors, the mechanism, the processes, the critical conditions, the aftereffects etc, the main steam pipe ' s failure patterns are divided into five types : frangibility, toughness, high temperature, creep, fatigue, the processes and characters of each type is analyzed and summarized

    根據主蒸汽管道失效因素、失效機理、失效發展過程、失效臨界條件、失效後果等幾個方面，確定了主蒸汽管道失效的五種形式，即脆性失效、韌性失效、高溫失效、疲勞失效和蠕變失效，並對每種失效形式的過程和特徵進行了分析。
  10. With the decoupling average technique and high - temperature approximation, we obtain the graph of the system magnetization evolving, which clearly exhibit the critical slowing phenomena of xy model near the phase transition region

    運用退耦平均技術，在高溫近似下數值模擬得出的平均磁化強度的時間演化，清楚地展示了xy模型在相變發生區域內的臨界慢化現象。
  11. The company produces the carbon black by using the large - scale innovated reaction stove and using the on - line high temperature pre - heater and raw oil pre - heater to enhance the reaction conditions to improve the quality ; the company is equipped with the excellent wasted goods recycling system controlled by dcs to lift up the pass percentage which helps the whole technological level to reach to the advanced level at home ; in a addition, the critical equipments are imported from the us ; and the company keeps up the technical innovation like generating the electric power by utilizing the produced gas on the course of carbon black production with the effect as raw materials saved and the pollution minimized resulted as well

    炭黑生產工藝採用美國大陸炭技術，執行gb3778 - 2003標準，主要生產n220 n330 n660等系列的11個品種的濕法造粒炭黑，年生產能力60000噸。該項目採用大型新工藝夾套反應爐，利用在線高溫空氣預熱器和原料油預熱器，強化反應條件，提高產品質量。公司設有精製及廢品回收系統，提高成品的合格率。
  12. At the logic synthesis stage, we make some research on the principles of logic synthesis at first, then by utilizing tsmc0. 25um process, choosing the worst case that the workable temperature can be high to 125 degrees centigrade and the supply voltage is as low as 2. 25v, and introducing the wireload library for effectively simulating delay and power consumption of wire connection, and taking the same clocks as in simulation, the critical path is 15. 3ns and the chip area is 0. 395mm2

    在進行邏輯綜合時首先對邏輯綜合的原理作了一定的了解，然後利用tsmc的0 . 25 m的工藝庫，工作電壓為2 . 25v ，工作溫度最高可達到125攝氏度的最壞情況下，進行邏輯綜合時引入了wireload庫以便有效的模擬連線所引起的延遲及功耗，採用與模擬時相同的時鐘，關鍵路徑為15 . 3ns ，晶元面積為0 . 395mm ~ 2 。
  13. The results indicates that superconducting mgb2 thin films can be prepared by hfcvd in a single - step with the maximum critical transition temperature tc of 36k ; the best critical transition temperature tc of thin films grown by hpcvd in a single - step is 34k. the optimal zero resistance temperature tco of thin films fabricated ex situ is 37 k by post - annealing of precursor b film at 800 for 1 h under high mg vapor pressure

    實驗結果表明，用hfcvd法在400原位制備了臨界溫度為36k的mgb2超導薄膜；用hpcvd法在700原位制備了臨界溫度為34k的mgb2超導薄膜；將300制備的前驅物b膜在mg蒸氣中800保溫1h非原位退火，制備了臨界溫度為37k的mgb2超導薄膜。
  14. The difference at low temperature and the concordance at high temperature still appear. analysis is made and all the results are shown in the form of graph. the result shows the tendency of the critical temperature ' s changing to the given particle number, when the quantum effect is major, is more slow than that got by the integral method

    並利用所得能級找出了相互作用系統中粒子的狀態分佈、相互作用對激發態占據數的影響、不同作用下基態占據與溫度的關系以及相互作用對系統轉變溫度的影響，然後用圖形表現出有相互作用時和無相互作用時所得結果的區別。
分享友人
分享到 Line

分享到臉書