critical length 中文意思是什麼
critical length
解釋
（纖維的）致斷長度。-
Study on critical length for bedding rock slope
順層巖質邊坡臨界坡長求解研究 -
Study on the load transfer and the critical length of single cement - soil pile
水泥土樁單樁荷載傳遞及臨界樁長研究 -
Critical length of grade
披道臨界長度 -
On critical length of flexural slumping rock layer in layered rocky slope and its influencing factors
順傾邊坡巖層滑移彎曲臨界長度及其影響因素分析 -
The cracking with these two types of underfill might become unstable and lead to catastrophic failure at the end. the critical length was about 12m for the assembly with no - flow underfill and 20m for the package with capillary - flow underfill at 20 ?
模擬表明，山固化溫度冷卻到室溫時，所研究的倒裝焊封裝在填充不流動膠時晶元斷裂臨界裂紋長度為12pm ，而填充傳統底充膠時為20hm 。 -
Based on the bedding features of weak intercalations in sandstone plates near the top of underground cavity, the probable failure scale of bedding sliding, the probable settlement, the folding places and the critical length of sandstone beams are computed seperately, then the stability of underground cavity is analysed
針對地下工程頂部層狀砂巖中存在順層發育軟弱夾層的情況，分別對開挖后可能出現的層間滑動破壞范圍、巖板的沉降、折斷和臨界長度進行計算，並分析其穩定性。 -
Then, by using the great fem programme and the drucker - prager model, the thesis establishes the pile - soil model of super - long piles, analyzes the mechanism of bearing and deformation of super - long piles under vertical loading systemically, studies the characteristics of q - s curve, bottom resistance, pile shaft resistance and critical length of super - long piles in detail, acquires some practical guidance conclusion. secondly, with a practical engineering, the author expatiates the bearing characters of super - long piles farther. the thesis points that super - long piles are frictional piles under the condition of working loading
然後應用大型有限元程序，採用土的drucker - prazer模型，建立了超長樁分析計算的樁土模型，系統分析了超長樁在豎向荷載作用下的承載機理和變形特性，研究了超長樁的荷載?沉降特性，端阻、側阻的發揮性狀以及超長樁的有效樁長，得出了具有實際指導意義的結論。 -
It is the key of ebfs, therefore, furthermore calculation about link are carried out in this thesis, introduced achieved research, summarized the affect of link on whole capability in the first, the second, numerical calculation are proceeded on link with ansys : with the purpose of discussing yielding mode critical length of link, established five different specimens ; with the purpose of discussing the influence of h / tw of web, b / tf of flange and h / b, established eighteen different specimens ; with the purpose of discussing the affect of stiffener, established four different specimens, and elaborated the affect of stiffener on link based on achieved test researches
因此，本文對耗能梁段進行進一步計算分析，概述耗能梁段對整體性能的影響，並利用有限元程序ansys對耗能梁段進行數值計算：針對耗能梁段的屈服類型建立5種不同長度的模型，計算討論耗能梁段屈服類型的長度劃分；針對耗能梁段腹板高厚比、翼緣寬厚比以及梁段截面形狀等因素共建立了18種模型進行計算分析；針對加勁肋對耗能梁段的作用建立了4種模型，並結合已有的試驗闡述了加勁肋對耗能梁段的影響。 -
Two concepts of critical length of slope and maximum buckling place is defined here to evaluate its stability. applications of two practical projects demonstrate this method ' s accuracy and feasibility. at the same time, all the factors which maybe infect the slope ' s stability, such as the mechanical performance of joint and rock, physical and geometrical character of slope, are considered
並以兩個實際工程實例驗證了本文方法的精確性及可行性；與此同時，本文對各影響因素如結構面的力學特性、巖體的力學特性及坡體的一些物理幾何特徵對該類邊坡穩定性的影響作了分析。 -
Three independent maturity genes were shown to influence the critical night length for floral initiation.
證明有三個獨立的成熟度基因影響著花發端的臨界夜長。 -
Second, we discuss the influence of environmental referance potential temperture and thermal wind on mesoscale symmetric instability. we find the expression of disturbance stream function and criterion of symmetric instability by analytical method and conclude that change caused by environmental referance potential temperture with height and thermal wind make critical richardson number and disturbance critical half - wave length of symmetric instability larger, that is to say, they benefit the occurance of symmetric instability. third, we study nonlinear perturbation analysis of mesoscale vertical circulation and evolution equation by means of f - plane. non - hydrostatic balance and filiter model
第二，討論了環境位溫與熱成風因子對中尺度對稱不穩定的影響。運用解析的方法求出了擾動流函數的表達式和對稱不穩定的判據，發現環境參考位溫隨高度的變化與熱成風因子使得對稱不穩定臨界理查遜數及擾動的臨界半波長都變大，這有利於對稱不穩定的發生。第三，採用f平面、非靜力平衡、濾聲波模式，討論了中尺度垂直環流非線性攝動分析及演變方程。 -
Abstract : methanesulfonic acid method was used to prepare five acylated chitins. except heptanoyl chitin, four of them, i. e. acetyl chitin, propionyl chitin, butyryl chitin and hexanoyl chitin, had high degree of substitution ( from 1. 5 to 2. 0 ) and exhibited lyotropic liquid crystalline behavior and cholesteric phase. as the length of the side chain increased the critical concentration ( w / w ) somewhat increased from 0. 21 to 0. 26 because the chain rigidity dropped. the critical concentration values of all the four derivatives were much higher than that of chitin ( 0. 12 ) due to the decrease of intramolecular hydrogen bonds. the four acylated chitin can form typical banded texture after being sheared. there minimum concentrations to form banded texture of them were evidently different, varied from 0. 25 ( for acetyl chitin ) to 0. 37 ( for hexanoyl chitin ). these results further indicated that liquid crystallinity decreased while the length of flexible side substituents increased
文摘:四種羧酰化甲殼素即乙酰化、丙酰化、丁酰化和己酰化甲殼素在二氯乙酸溶液中均呈現膽甾型溶致液晶相.臨界濃度隨側基長度增加而略有增加，衍生物的臨界濃度明顯都比原甲殼素高許多，這些規律都可以用鏈剛性的變化來解釋.四種羧酰化甲殼素在剪切時均能形成條帶織構，而且能形成條帶織構的最低濃度有明顯差別，隨側基長度增加而提高，進一步表明側基較長，液晶性減少 -
With this length of time survivable injuries would have become critical and most probably would have resulted in the loss of life
在這樣長的時間里，存活的受傷員的情況將變得非常緊急，很可能最終失去生命。 -
This paper introduces common background knowledge of intersection, mainly describes traffic control design principle, such as signal timing and lane channelization. it also summarizes the same point between signal timing and lane channelization in nature and illustrates that it is optimal cycle length and signal phase that is the critical part of signal timing
=本文介紹了交叉口的一般背景知識，重點闡述了平面信號交叉口的交通控制的設置原理，包括信號配時原理和路口渠化原理，概括了信號配時和路口渠化原理的本質相同點。 -
5. the injury degree of so2 on plant is a funition of the exposure time and so2 concentration. the injury critical concentration depends on the exposure time, and the time length is closely relevant to so2 concentration
植物受so _ 2的傷害程度是暴露時間和so _ 2濃度的函數，其中傷害的臨界濃度取決于暴露時間，而其時間的長短與so _ 2濃度密切相關。 -
The his - tagged peacl - gfp purified from the supernatants could polymerize into green fluorescent filamentous structures with diameter, length and shape being identical to that of muscle f - actins, which could be labeled by tritc - phalloidin ( a specific agent for staining actin microfilaments ), and were identified as having a 9 nm diameter by negative staining, corresponding with that of the muscle f - actins ( 7 - 10 nm ). under polymerization conditions, his - tagged peacl - gfp polymerized with kinetics similar to those of skeleton muscle actin, that is, an obvious lag nucleation period at the beginning of polymerization and an s - like typical polymerization curve could be obtained. the critical concentration is 0. 75 umol / l near to that of chicken muscle actin ( 0. 56 umol / l ) under the same condition
熒光標記結合熒光顯微觀察表明：從可溶性上清中純化的his - taggedpeac1 - gfp聚合形成的微絲不僅可以直接在熒光顯微鏡下觀察，也可被微絲的特異標記物鬼筆環肽所標記，而且其直徑、長度以及形態上與已知的聚合肌動蛋白熒光絲一致；電鏡負染的結果進一步證實其直徑為9nm ，與傳統微絲直徑相當（ 7 ? 10nm ） ；聚合曲線有明顯的停滯期，為典型的s型聚合曲線，聚合臨界濃度為0 . 75 mol l ，這一結果與已有報道相似。 -
In addition, a new analytical method was used to solve the shear strength of the fiber / epoxy interface. the result showed good agreement with that from the kelly - tyson equation. meanwhile, according to the sfc tests of the single fiber reinforced epoxy matrix composites treated by four types of surface treatments, the interfacial adhesion conditions were estimated by critical fiber length, interfacial shear strength and single fiber microdamge mode
此外，文中對單纖維復合材料斷裂實驗運用了新的解析方法，求解了玻璃纖維環氧復合材料界面的剪切強度，與kelly - tyson等式方法求得的界面剪切強度有著很好的一致性；同時，對四種不同表面處理劑處理的單纖維復合材料斷裂實驗進行了分析，從臨界纖維長度、界面剪切強度和單纖維斷裂實驗中纖維斷點周圍基體形貌評價了界面的粘結情況。 -
The strength of fibre - matrix interfacial bonding affects the overall composite strength and mode of failure, and the critical fibre length
界面壓焊影響總力和失敗模式，及有關纖體長度的纖維基的力。 -
Treated with 8h light / d, the critical number of photoperiods needed to induce flowering in salicornia bigelovii torr. is 13. flowering reversion occurred when treated with 13 - 18 photoperiods and then transposed to long day - length ( 17h light / d )
短日照處理促進畢氏海蓬子開花，這一點與justin等的結果一致，其開花的臨界日長為15小時； 2 -
When the rate is great, the length of border rose sharply, if it reached the critical value, the increase became slow
對于較大生長速率時，邊界長度開始迅速上升，達到臨界值后，仍然會有增加，但趨勢變得較為平緩。
分享友人