cross bearings 中文意思是什麼
-
When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved
分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。 -
Piezo - electrical ultrasonic motors were used to drive the linear slideways supported by the cross roller bearings, position information was fed back by the optical encoders, the total closed - loop control system was constituted
伺服機構採用壓電超聲電機直接驅動由滾柱導軌支承的直線工作臺，通過高精度光柵尺構成全閉環反饋。 -
The implement of direction finding cross location and errors analysis are on the focus. the multi - warships bearings - only tracking algorithm based on direction finding cross location and distributed multi - warships bearings - only tracking are also presented. ( 6 ) the observation prerequisite of single warship bearings - only tracking is analyzed, and optimal maneuver of the observer warship is discussed
5研究了多艦純方位跟蹤的演算法，把多艦純方位跟蹤分成集中式跟蹤和分散式跟蹤兩類，並分別進行了分析比較，重點研究了測向交叉定位法的實現及誤差分析，給出了基於測向交叉定位的多艦對運動輻射源的跟蹤演算法和基於信息融合的多艦純方位分散式跟蹤演算法。 -
Fixing by cross bearings
交叉方位定位
分享友人