crystalline coating 中文意思是什麼

crystalline coating 解釋
晶質塗層
  • crystalline : adj. 水晶的，由水晶做成的；結晶的，【化、礦】結晶質的；透明的。n. 結晶質，結晶體，晶態；（眼球）水晶體。
  • coating : n. 1. 被覆，表皮，塗層；包覆物；（食品上的）面衣，糖衣；塗料。2. 上衣料；細呢，花呢。
  1. Cementitious capillary crystalline waterproofing coating ( abbreviated ccwc ) is a new type of cement - based waterproofing materials, which is characterized by its very good adhesive performance and impermeability to water, self - rehabilitating ability, permanent waterproofing effect, good aging resistance and corrosion resistance, simple construction method and harmless to hunman etc. ccwc consists of ordinary portland cement, quartz sand and reactive substances and other supplementary ingredients, whose reactive substance can permeate into the internal part of concrete structures through water and produce insoluble crystals filling capillary pores or crack of the concret through reaction with cement hydrates and unhydrates

    水泥基滲透結晶型防水材料是以硅酸鹽水泥或普通硅酸鹽水泥、石英砂等為基材，摻入活性化學物質而組成的一種新型防水材料。摻入的活性化學物質以水作載體向混凝土內部滲透，與混凝土中未水化的水泥及部分水泥水化產物發生結晶反應，生成不溶於水的結晶體，堵塞毛細孔道，使混凝土緻密、防水。這種防水材料具有粘結力強、抗滲性能好、自愈合能力強、防水效果持久、耐老化、耐腐蝕、易施工、對人類無害等特點。
  2. Preparing anti - reflective coating and hydrogen passivation are two key procedures in the process of high efficiency crystalline silicon solar cells

    減反射膜的制備和氫鈍化是制備高效率的晶體硅太陽電池的非常重要工序之一。
  3. Research on surface and grain boundary passivation mechanism obtained effects of surface recombination on crystalline silicon solar cell performance and the theoretical expression of grain boundary recombination velocity. the limit ratio of short - circuit current increment for anti - reflection coating utilization on solar cells was obtained. the crystalline silicon solar cell spectral response, contact resistance and minority carrier lifetime measurement systems were established

    鈍化機理研究獲得了表面復合對不同表面摻雜濃度晶體硅太陽電池性能的影響、表面和界面復合速度的理論表達式；研究得到了減反射膜對太陽電池短路電流增量比的極限；建立了太陽電池光譜響應、柵線電極接觸電阻和少子壽命等測試系統。
  4. To make cds / k4nb6o17 powder on the base of the k4nb6o17 powder which by the courses of ion exchanging, amine intercalation, sulfuration etc. to obtain cds / k4nb6o17 thin film through the same course of making cds / k4nb6o17 powder on the base of k4nb3o17 thin film on the quartz which made by the spin coating and after heat treatment. to make experiments with additives ( na2so3, 0. 1mol / l ) of photocatalytically decomposing water into h2 and o2 to evaluate the photocatalytic activities of the catalyst knb6o17 powder, cds / k4nb6o17 powder, k4nb6o17 film, cds / k4nb6o17 film. the crystalline structures of the midst powder and film productions were investigated by using the x - ray diffraction ( xrd )

    本課題的主要內容是：高溫固相反應合成具有層狀結構的k _ 4nb _ 6o _ （ 17 ）晶體材料，然後以此為母體材料，通過離子交換、層間胺插入、硫化處理等過程制備出cds / h _ 4nb _ 6o _ （ 17 ）粉末形式的光催化材料；通過旋轉塗覆法在石英玻璃基片上制備了k _ 4nb _ 6o _ （ 17 ）薄膜，採用一定的熱處理制度后對薄膜分別進行離子交換、層間胺插入、硫化處理等處理過程制備了cds / h _ 4nb _ 6o _ （ 17 ）薄膜形式的光催化材料。
  5. Brushed with the thickness of 1. 5 ~ 2. 0mm. it can improve the impermeability pressure up 3 times that of blank samples ; the crystalline reaction can continuously carry out, sealing the crack and waterproofing for ever if water is existent ; very good environmental adaptability, and can be used as normal at ph 3. 0 ~ 12. 0 ; moreover, the contrast tests of the performance of pt coating with two kinds of widely used waterproofing coating xypex and coprox were also carried out in this paper. test results show that the properties such as impermeability, self - rehabilitating ability and corrosion resistance are superior to those of the counterparts

    試驗結果表明， pt防水塗料具有如下的性能特點：具有良好的防水性能，塗刷厚度1 . 5 2 . 0mm ，抗滲壓力可提高3倍以上；在有水的條件下，結晶反應可以不斷進行，能實現自愈合、永久性防水；具有很強的環境適應性，在ph值3 . 0 12 . 0條件下均可正常使用；此外，本文還進行了pt防水塗料與同類型防水材料xypex和防水寶（二者都是目前應用廣泛的防水塗料）的性能對比試驗。
  6. With plating time going on, the nano - polycrystal gathering grows in two dimensions, and the new nano - polycrystal layer appears simultaneously on the formerly formed nano - polycrystal surface. because the boundary and defect densities in quenched and tempered 45 steel is higher than those in annealed steel, the nano - polycrystal gatherings formed at its surface at the beginning of electro - deposition are more concentrated, and then their size is smaller. the microstructure of the ni - p alloy coating has closed relation with its phosphorus content with the increase of phosphorus content, the microstructure of coating turns from nano - crystalline to the amorphous

    隨著施鍍時間的延長，納米晶聚晶體在橫向二維生長的同時，在納米晶聚晶體的表面上也進行著三維方向的新的一層聚晶體的生長；在調質態45鋼表面，由於其具有比較高的晶界和缺陷密度，因此在沉積初期，納米晶聚晶體的成核密度也較大，從而在二維方向聚晶體的尺度較小，鍍層沉積初期表現為緻密細小的鱗片狀組織。
  7. Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively

    利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究，結果顯示，所制備的薄膜為六方纖鋅礦型結構，具有高c軸擇優取向性；表面均勻、緻密，薄膜材料由許多星狀晶粒組成，晶粒尺寸大約為10 - 30nm左右；薄膜可見光透過率平均可達90 % ；對薄膜厚度以及電學性能進行了測定后發現：單次鍍膜厚度約為75 - 240nm ， al ~ （ 3 + ）離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內；分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。
  8. Increasing the reaction time, zirconium phosphate becomes the main crystalline of the coating. the coating surface is coarse, loose and two many cracks and micro - holes exist in the section image of the coatings. the ceramic coatings

    正向脈沖作用增加，有助於膜層內- al _ 2o _ 3含量增多、膜層增厚，但是膜層由於生長過快而較粗糙、多孔。
  9. On the basis of analyzing characteristics of the cement - based capillary crystalline waterproof materials, the article points out that both waterproofing and leak - stopping ability of this kind of materials should be simultaneously functioned in order to enhance quality of coating layer, ensure its thickness and effectiveness

    在分析水泥基滲透結晶型防水材料應用特點的基礎上，指出在此類材料的應用中，應重視同時發揮其防水和堵漏的功能，提高防水塗層質量，保證塗層厚度，以確保應用效果。
  10. The results show that the improved structure has obviously reduced pressure drop and increased axial speed of the nozzle, as a result the wallop of electroplating solution is improved and the thickness of diffused layer reduced, the electrodeposition process improved, and what is more, the coating structure has been compacted, crystalline particles fined and the performance improved

    結果表明，結構改進后，明顯減小了壓力損失，提高了噴嘴的抽向速度，電鍍液沖擊鍍件的沖擊力得到提高，有效地減少了擴散層的厚度，改善了電沉積過程，而且使鍍層組織緻密，晶粒細化性能得到提高。
  11. The first, we studies the composition and structure of the coatings by means of the x - ray diffraction and sem. the xrd spectra demonstrates that the ni - p - ptfe - sic composite coating is non - crystalline

    用掃描電子顯微鏡和x -射線衍射圖譜研究了該鍍層的組成和結構。 x -射線圖譜表明ni - p - ptfe - sic鍍層為非晶鍍層。
  12. If phosphorus was adequacy in composite powder, co - p alloy coating becomes non - crystalline. the quality of composite powder was better, and the stabilization of solution is improved with the increase of the ph from 9. 5 to 11. 0

    硫酸鈷濃度18 40g / l ，次亞磷酸鈉濃度20 40g / l ，可以得到鍍覆均勻、分散性好的復合粉末；增加其濃度，復合粉體的鍍覆質量得以提高。
分享友人
分享到 Line

分享到臉書