crystalline rate 中文意思是什麼

crystalline rate 解釋
結晶速率
  • crystalline : adj. 水晶的，由水晶做成的；結晶的，【化、礦】結晶質的；透明的。n. 結晶質，結晶體，晶態；（眼球）水晶體。
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  1. When ph value < 0. 5, faster deposition rate, faster growth rate of crystallizing nucleus, which causes bigger crystalline granularity and bad surface quality of the deposits such as crassitude or darkling

    Ph 0 . 5時，沉積速度過快，晶核成長速度快，晶粒粒度較大，鍍層表面粗糙、發黑，表面質量差。
  2. The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of

    對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。
  3. When sn2 + concentration in the bath is lower, sn2 + activity is not enough causes slow deposition rate and slow growth rate of crystallizing nucleus, so crystalline granularity deposited is smaller ; when sn2 + concentration in the bath is higher, the dispersive ability of the bath decreases and the surface quality of the deposits sets worse

    鍍液中sn ~ （ 2 + ）濃度較低時，離子活度不夠，沉積速度慢，晶核成長速度慢，使沉積的晶粒粒度較小； sn ~ （ 2 + ）濃度過高，鍍液分散能力降低，使鍍層的表面質量下降。
  4. The growing rate of crystalline show powerful relationship to the temperature

    這是因為晶粒長大速率與溫度呈指數關系的緣故。
  5. Calcium phosphates ( cp ) have been studied extensively for cell cultures and have been found to possess good osteoconductive properties. cp can be dissolved in vivo and be absorbed or displaced by tissue. the degradation rate of cp varies in different crystalline phases, which enables to adjust the degradation rate of biomaterials

    鈣磷酸鹽如磷酸三鈣具有骨誘導性，在體內有較大的溶解度，易發生水化作用，並通過體液的侵蝕和細胞的吞噬作用被機體部分或完全吸收而被取代，不同晶型的鈣磷酸鹽在體內的降解速率不同，可調整材料的降解速率。
  6. The investigation presents a new method of dipping sic kiln furniture into 2 saturable solution or into the saturable solution of ca3 ( po4 ) 2 and a1po4 in order to beneficial to its crystalline structure change and its properties, to make it packed and decrease its porosity. it can also hinder the diffusion of oxygen so as to decrease the oxidation rate and lengthen the useful life. the mechanism of dipping two kinds of phosphate saturable solution were studied and proved by the results of scanning electron microscope

    本研究首次採用sic窯具材料浸漬ca _ 3 （ po _ 4 ） _ 2飽和溶液和浸漬ca _ 3 （ po _ 4 ） _ 2與alpo _ 4混合飽和溶液的方法，目的在於有利於窯具材料晶相結構的轉化和性能的優化；能堵塞材料的氣孔，降低透氣率，阻礙o _ 2擴散，降低氧化速度，延長窯具材料的使用壽命。
  7. To characterize the particle size of the srce03 products, some methods used to determine the crystalline grain size and crystal lattice distortion rate of nanostructured powder based on xrd data were studied. it was found that some methods had their shortage. to rationalize the calculation, a proper treating method was recommended

    為了表徵所制備的納米srceo3粉體的粒度，本論文對利用粉晶x射線衍射技術表徵納米粒于的粒度和晶格畸變的方法進行了研究，發現已有的某些方法中存在的不合理性，針對表徵方法的合理化提出了自己的見解。
  8. Higher bath temperature and more deposition time, faster deposition rate, faster growth rate of crystallizing nucleus, which causes bigger crystalline granularity ; ph value and bath temperature are also key factors affecting the size of crystalline granulatrity

    鍍液溫度越高、時間越長，沉積速度越快，晶核成長的速度就越快，沉積晶粒的粒度也越大。鍍液ph值和sn ~ （ 2 + ）離子濃度也是影響晶粒粒度大小的關鍵因素。
  9. The blood sugar feeds the crystalline cellular structure, which has a much higher metabolic rate, so much higher in fact that you could not eat enough to sustain the crystalline form

    血糖供養給新陳代謝頻率高得多的水晶細胞結構，事實上如此之高，你無法進食足夠來維系水晶形體。
分享友人
分享到 Line

分享到臉書