cyclic compression 中文意思是什麼

cyclic compression 解釋
反復壓縮
  • cyclic : adj. 1. 周期的；輪轉的，循環的。2. 【化學】環狀的；【植物；植物學】輪列的，輪卷的。3. 組詩的；故事始末的。
  • compression : n. 1. 壓縮；壓緊；濃縮，緊縮。2. 加壓；壓抑。3. （表現的）簡練。4. 應壓試驗。
  1. While cyclic deformation experiment under constant strain control is performed in 400, the material shows the continuous hardening until cyclic invalidation. ( 3 ) back stress attained by kwl " s method is used to analyse the bauschinger effect during an incremental step cyclic test and cyclic deformation test under constant strain control, it is shown that back stress increases with increasing plastic strain and the numbers of cycle, and the back stress is uniform, regardless of tension or compression conditions. ( 4 ) as far as recrystallized zircaloy - 4 plate is concerned, the back stress in transverse direction is higher than that in rolling direction due to the higher schmid factor in rolling direction

    對于再結晶狀態的zr一4合金板材試樣來說， t方向（橫向）試樣的背應力要高於r方向（軋制方向）的背應力，原因在於r方向的schmid因子高於t方向的schmid因子; 400下， zr一4合金的背應力要明顯低於室溫下的背應力;含氫200pg / g的zr一4合金的背應力大小與無滲氫的zr一4合金背應力相比，無明顯區別;固溶處理后， zr一4合金的背應力大小發生了變化，在較高塑性應變下，背應力均高於固溶處理前的背應力。
  2. In this thesis, four types of steel beam - rectangular cfst column connections, including normal welded flange plate ( wfp ) connection, bolted flange plate ( bfp ) connection, stiffened end plate ( sep ) connection and double split - tee plate ( dst ) connection, were designed based on the configuration of steel frame connection. total 8 models, 2 models of each kind of connections were tested under low - reversed cyclic loading at the end of cfst columns. the relationships between force and displacement at the end of columns, the relationships between the moment and rotation of the joints, degradations of strength and stiffness, ductility, failure mechanism and failure characteristics of these four connections under different axial - compression ratios were presented

    本文借鑒鋼框架節點構造，設計了四種類型矩形鋼管混凝土柱與鋼梁連接節點，包括常規栓焊（ wfp ）節點、翼緣全螺栓連接（ bfp ）節點、雙t板連接（ dst ）節點以及加勁端板連接（ sep ）節點，進行了四類節點8個模型試件在柱端低周反復荷載作用下的抗震性能試驗研究，比較了不同軸壓比下節點的滯回性能、強度與剛度退化、延性、破壞機理與破壞特徵，主要結論有： 1 、節點的位移滯回曲線與轉角滯回曲線為塊型分佈，沒有或略有捏攏現象，耗能能力強； 2 、軸壓比對節點滯回曲線有顯著影響，全部節點都有顯著的剛度退化； 3 、位移與轉角骨架曲線在峰值荷載後有較長的水平或下降段，具有良好的延性性能； 4 、從整體抗震性能上看，翼緣全螺栓連接節點、雙t板連接與加勁端板連接節點都優于常規栓焊節點，可在實際工程中加以推廣。
  3. Based on the analysis of the combustion in cylinder, the thorough research of multiparameters ( engine speed, load, ignition timing, injection timing, injection nozzle type, compression, ignition pattern etc. ) on methanol engine combustion cyclic variations is made on a 1130 single - cylinder diesel engine fueled with methanol

    在燃用甲醇燃料的1130單缸柴油機上，通過缸內燃燒分析，對影響甲醇發動機循環變動的各種因素（轉速、負荷、點火提前角、噴油提前角、噴油嘴類型、壓縮比、點火方式等）進行了詳細的研究。
  4. Saturated sand are testes in the laboratory under the undrained cyclic loading condition with static - dynamic dual purpose triaxial compression test apparatus, which is designed under the cooperation of hohai university and marui co. ltd japan. the results indicate that the stress path approaches from a initial stress point to the failure lines as cyclic loading goes on, and eventually converges on a certain limiting stress path in the vicinity of the failure lines. the stress - strain curve, however, does not converge on a closed hystersis loop ; the shear strain rapidly increases in looser sand or gradually and continually increases in denser sand

    利用河海大學與日本圓井株式會社共同研製的新型的多功能靜動三軸儀進行了飽和砂土循環扭剪不排水試驗，研究表明，對于松砂，剪應變幅度快速地由微小增加到百分之幾甚至百分之十幾，對于緊砂，剪應變幅度逐漸地由微小增加到百分之幾甚至百分之十幾；經試驗初步研究表明用初始有效平均正應力歸一化的有效應力路徑很好的一致性。
  5. It is concentrated on the investigation of the laws of damage initiation and development, under the conditions of monotone loading, cyclic loading, varies confinement pressures and triaxial equi - compression

    主要是根據試驗結果，對經歷各種荷載歷史后的損傷隨荷載歷史的發展演化規律進行了深入的研究。
  6. In this dissertation, the effect of texture, heat - treatment, and hydrogen on the lcf behavior of zircaloy - 4 and the cyclic deformation behavior for zircaloy - 4, n18 alloy and n36 alloy have been investigated systematically using fully - reversed tension - compression loading under strain control ( r = min / max = - 1 ), while the evolvement of the friction and back stresses versus the number of repeated working cycles and the plastic strain amplitude has been studied, and the thorough discussion combined with the analysis result of fatigue sub - structure, friction and back stresses, and fatigue fracture has been given to the mechanism underlying the lcf behavior of alloys

    本文採用對稱拉壓循環變形方法（ r _ = _ （ min ） _ （ max ） = - 1 ） ，系統研究了織構、熱處理狀態、氫對zr - 4合金低周疲勞性能的影響， zr - 4合金、 n18合金和n36合金的循環變形行為，並研究了摩擦應力、背應力隨循環周次、塑性應變幅的變化規律。結合疲勞亞結構和疲勞斷口的分析結果，深入探討了影響合金低周疲勞行為的作用機制。
  7. Testing study on fatigue deformation law of red - sandstone under triaxial compression with cyclic loading

    周期荷載作用下紅砂巖三軸疲勞變形特性試驗研究
  8. Merely the fatigue strength in uniaxial tension or compression under constant - amplitude cyclic loading is given in the existing design code. the design result by using the fatigue strength in the code is apt to conservative under variable - amplitude or triaxial cyclic compression loadings, but sometimes apt to dangerous in uniaxial or triaxial tension - compression fatigue loadings

    現行規范中，僅有混凝土單軸、等幅波動拉伸和抗壓強度指標，採用這些指標進行設計，會導致設計結果有時偏於保守，如變幅及多軸壓疲勞；而有時又偏於危險，如單軸及多軸波動拉-壓疲勞。
  9. Seals. elastomer base mastics used for sealing. determination of adhesivness - cohesion characteristics by cyclic tensile - compression tests

    縫隙.密封縫隙用彈性膠泥.循環試驗測定附著粘度性能.拉伸.壓縮
  10. Bituminous mixtures - test methods for hot mix asphalt - cyclic compression test

    瀝青混合料.熱混瀝青的試驗方法.循環壓力試驗
  11. Bituminous mixtures - test methods for hot mix asphalt - part 25 : cyclic compression test

    瀝青混合料.熱混瀝青的試驗方法.第25部分:循環壓力試驗
  12. Bituminous mixtures - test methods for hot mix asphalt - part 25 : cyclic compression test ; german version en 12697 - 25 : 2005

    瀝青混合物.熱混瀝青的試驗方法.第25部分:循環壓力試
  13. The main contents are followed below : ( 1 ) for the aim of knowing the characteristics of main factory building structure frame columns of large - scale thermal power plants, nine high strength concrete frame columns with high axial compression ratio and six slender ordinary strength concrete frame columns with high axial compression ratio were tested under low reversed cyclic horizontal loading for the very first time, and thus the influencing factors of normal section bearing capacity, such as concrete intensity grade, axial compressive ratio, slendemess ratio, the type of stirrups and stirrup ratio, etc, the anti seismic deformation capability of frame columns were acquired

    本文主要研究的內容有： （ 1 ）首次針對火電廠主廠房結構框架柱的特點，對9個高軸壓比高強混凝土框架柱和6個高軸壓比普通混凝土框架長柱進行了低周反復水平加載試驗，獲得混凝土等級、軸壓比、長細比、配箍形式及配筋率等對框架柱的抗彎及抗剪承載力、抗震變形能力的影響因素。
分享友人
分享到 Line

分享到臉書