dead voltage 中文意思是什麼

dead voltage 解釋
無效電壓
  • dead : adj 1 死的;無生命的,無生物的。2 無感覺的。3 (炭等)已熄滅的;無生氣的,呆滯的,停頓的;冷落的...
  • voltage : n. 【電學】電壓,電壓量,伏特數。 the working voltage (電氣的)耐壓限度。
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中,作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  2. The digital inverter amplifier is controlled by the dsp chip tms320fl240. the high performance of digital voltage and current control loops and the improved digital pi control arithmetic based on the current prediction techniques is achieved in the software. and the dead - time of inverter also is compensated

    系統中逆變器的控制採用tms320fl240晶元來實現,在軟體中實現了電壓電流的雙環控制,提出並在逆變中應用了電流預估計的pi控制演算法,並對控制死區進行了補償。
  3. Novel dead - time compensation strategy for space voltage vector pwm inverter

    一種新穎的空間電壓矢量調制逆變器的死區補償方法
  4. Compare to other kindred products, besides adjustment of speed, the new calibrater can adjust teeth number and voltage of fanout. the new calibrater can also output a pulse one cycle which simulate cylinder top dead center

    這種標定器與國內外同類產品相比,除了轉速可變外,還有一些創新之處:齒數可調、輸出幅值可調、同時可以輸出每周一個的上死點參考信號。
  5. This paper put forward a method of using amending sine value in the spwm sine table. this method can correct the distortion of the output voltage waveform, which resulted from the dead time used to the voltage type whole bridge main circuit. the inverter system adopts digital fuzzy controller with feed forward correction and which proportion coefficient and integral coefficient is changeable, so dynamic response is improved

    本文提出了一種採用修補spwm正弦表值的方法,用以改善電壓型全橋逆變主電路因上下橋的功率器件切換時先關斷后導通的死區時間而引起的輸出電壓波形畸變;逆變系統採用帶前饋校正的變比例變積分系數的模糊控制器,提高了系統的動態響應指標;系統設計了完善的保護措施,並具有市電電網的故障診斷功能。
  6. ( 2 ) each state of the total switching period has been studied in detail, in which the voltage of block capacitor and current of leakage inductance of main transformer and keeping time of each state have been discussed, then the condition of zero voltage switching is attained, which gives theory guidance for setting reasonable dead time, finally, the possibility of zero voltage switching is proved by simulation of saber software

    ( 2 )對不對稱半橋在一個完整的開關周期內各個狀態分析,描述了隔直電容電壓和變壓器漏感電流的變化規律,各個狀態的持,然後得出實現zvs的條件,從而為設置合理的死區時間提供了理論指導,最後用saber軟體進行了模擬,驗證了零電壓開關實現的可能性。
  7. Specific issues examined are : compensation for the variation of the stator resistance, the offset error of the dc bus voltage, the voltage error generated by the forward voltage drop the dead time of the switches, improvement of the steady state performance, and the speed sensorless control for the pmsm dtc drive system are of major concern in this thesis

    定子電阻變化,直流母線電壓漂移,開關器件反向相電壓降、逆變器死區時間引起的電壓誤差的補償,提高系統穩態運行性能以及永磁同步電機直接轉矩控制的無速度傳感器運行方案等問題都是本文研究的重點。轉矩的快速響應是直接轉矩控制演算法的一個卓越的性能。
  8. High - voltage alternating current circuit - breakers - guide for short - circuit and switching test procedures for metal - enclosed and dead tank circuit - breakers

    高壓選擇電流線路斷路器.金屬封閉的和不通電的箱式線路斷路器短路和開關試驗設備指南
  9. The a / d and cap circuits on dsp sample the voltage and current signals coming from the signal sampling circuit and the speed signal of the motor respectively. the " dead time " register of the dsp prevent directive - through of the igbts on the up and the down bridge arms

    利用dsp上的死區寄存器設置ipm驅動信號的死區時間防止上下橋臂igbt的直通;利用板上集成的a / d轉換器採集經過板級外圍電路處理的電路信號;利用板上的捕獲單元cap採集通過轉速計的輸出從而得到電機的轉速。
  10. Slave cpu receives the spwm data and output the spwm wave by query the spwm table. the dead time is generated by hardware to prevent the h bridge arm from short directly. the power out module is protected for over current, over voltage and over heat

    逆變器採用雙cpu結構,使用spi進行連接,主cpu完成輸入、輸出和spwm波形數據的計算,從cpu接收到spwm數據后使用查表方法輸出spwm波形,使用硬體電路生成死區時間防止橋臂直通,對輸出功率模塊進行了過流、短路、過壓、過熱保護。
  11. Three kinds of the usual methods of rotor flux estimation are compared and analyzed, and the method of rotor flux estimation based on the voltage model is studied in detail. and the output phase voltage is reconstructed by means of the dc - bus voltage and the switching states of the inverter, the effect of the dead time and saturating voltage - drop of the switches on flux estimation is discussed. and the method of synchronizing instant speed identification is also studied deeply

    本文對三種常用的轉子磁鏈觀測方法進行了對比分析,在此基礎上著重研究了基於電壓模型磁鏈觀測方法,分析了利用直流母線電壓和逆變器三相開關管的狀態進行輸出電壓重構方法,討論了死區時間和開關管飽和壓降對磁鏈觀測結果的影響,深入研究了同步瞬時轉速辨識方法。
分享友人