dehydration process 中文意思是什麼

dehydration process 解釋
脫水工藝流程
  • dehydration : 除濕，脫水，乾燥
  • process : n 1 進行，經過；過程，歷程；作用。 2 處置，方法，步驟；加工處理，工藝程序，工序；製作法。3 【攝影...
  1. The dehydration process leads to fairly extensive decomposition of the product.

    脫水過程會導致產物相當程度的分解。
  2. The results of the uni - factor experiments and perpendicular experiments show their best mechanic synthesizing craft as followed : nvp ( 10 % wt ), kh570 ( 20 % wt ), hema ( 70 % wt ), initiator ( 0. 2 % wt ), crosslinker ( 20 % wt ), reacting 20 hours under 80 c. the factors which influenced organic silicon modified pvp hydrogel soft contact lens material ' s swelling capabilities were researched, which included temperature, monomer content, ion concentration etc. the experiments showed the equation swelling content ewc improved with the increase of nw, droped with the increase of kh570 and ion concentration, improved then droped with the raise of temperature, and hydrogels got the least ewc at 45 c. experiment carried on todiscuss water dehydration mechanism of organic silicon modified pvp hydrogel soft contact lens materials, which showed dehydration process could be divided into evaporating stage and diffusing stage

    正交實驗結果表明， nvp ? hema ? kh570共聚物的機械性能最佳時，其合成工藝條件為： nvp用量10 （質量百分含量，下同） ， kh570用量20 ， hema用量70 ，引發劑aibn用量0 . 2 ，交聯劑nmba用量0 . 2 ，反應溫度為80 ，反應時間16h 。討論了單體配比、溶脹溫度、離子濃度等因素對有機硅改性pvp水凝膠軟接觸透鏡材料溶脹性能的影響。實驗得出：水凝膠材料的平衡溶脹度ewc隨單體nvp含量的增加而增大， ewc隨kh570用量的增加而減小，隨離子濃度的增大而略微降低，隨溶脹溫度的升高先稍微下降後有所提高， 45時平衡含水量最低。
  3. Effects of placing time and carbonization time of lime white on dehydration process of calcium carbonate suspension

    石灰乳放置時間和碳化時間對碳酸鈣懸浮液脫水過程的影響
  4. The oil - dehydration process is a complex, mimo, variable coupling seriously, disturbance vnying frequently manufacturing process, which practically has less measurable information

    聯合站油水分離過程是復雜的、多輸入多輸出的、變量之間耦合嚴重、干擾變化頻繁、實際可測信息很少的生產過程。
  5. The high iodine value, high ccl4 adsorption intensity, the high mechanicalstrength, mainly uses in except the dehydration in the bacterium, theorganic matter pollution and so on, uses in the water depthpurification, disinfection antiseptic processing, applies to pure foodproducts factory, the pharmaceutical manufacturing plant and so onwater works, mineral spring water works, brewery water qualitypurification and the power plant waits till the process water thedepth purification

    高碘值，高的亞蘭吸附力，高機械強度，主要用於除去水中細菌、農藥殘留、氯離子、有機物污染等，用於水的深度凈化，消毒滅菌處理，應用於純水廠、礦泉水廠、啤酒廠等食品廠、制藥廠的水質凈化及發電廠等到工業用水的深度凈化。
  6. Application of classified thickening process in tailings dehydration of beiminghe iron mine

    旋流分級濃縮工藝在北?河鐵礦的應用
  7. Add preservatives and deoxidants to the mixture solution, and go throuth the process of separating by sinking in the container ; owing to the density difference between oil and water, the mixture solution inside the conatainer will be separated of itself, and the result is that crude oil floats on the surface, while water sink to the bottom, but the separated crude oil still has water content which will be removed through electric dehydration

    「在混合液中加入防腐劑和脫氧劑，然後進入容器進行沉降分離，由於油水密度不一樣，混合液在容器中自然地分離，原油浮在上面，水沉在容器下面，分離后的原油仍含有少量的水，再進行電脫水分離。 」
  8. We can recover sericite by taking nonferrous metal tailing as raw material and using the flotation process to separate ， then with dehydration and heating. the sericite can be widely used in chemical industry. while is the process going along ， the environmental benefit and economical benefit and social benefit will be obtained

    本文簡要敘述了幾種微孔狀非金屬礦物的理化特性、在水處理方面的應用以及污水處理過程中吸附有機污染物的影響因素。
  9. Abstract : the effects of placing time and carbonization time of lime white on dehydration process of calcium carbonate suspension have been tested. the results indicate that the longer placing time and carbonization time are, the harder dehydration process of calcium carbonate suspension is, and that the effect of carbonization time is more remarkable than the effect of placing time

    文摘:測試了石灰乳放置時間和碳化時間對碳酸鈣懸浮液脫水過程的影響.結果表明，石灰乳放置時間和碳化時間越長，碳酸鈣懸浮液的脫水過程越困難，並且碳化時間的影響比放置時間的影響還要顯著
  10. Abstract : we aimed at resolving a practical problem, i. e. the parameters in the process of oil dehydration and transpotation are coupling. for this purpose, the use of multi _ variables state feedback predictive control arithmetic to control the pressure and oil _ water interface system of free water dehydrator was studied. the result of control is satisfactory. the pressure and interface are stable, and the quality of dehydration is good

    文摘:針對聯合站游離水脫除器脫水轉油過程中參數關聯嚴重這一實際問題，研究了將多變量狀態反饋預測控制應用於游離水脫除器油水界面和壓力控制系統，控制效果令人滿意，壓力、界面穩定；脫水質量合格
  11. Study on catalyst and process conditions of 1, 4 - butanediol dehydration for producing tetrahydrofuran - gas phase method

    丁二醇氣相脫水環化制四氫呋喃催化劑和工藝的研究
  12. The machine uses caterpillar transference structure, hence the good cleaning result, the high speed, the satisfactory spotlessness, the reduction of labor intensity, the decrease of the intermediate links, and the completion at once of the whole process : form the parts, demagnetism, their cleaning, their dehydration spray, to their blow - drying

    該機為履帶式傳送結構，清洗效果好、速度快、清洗潔凈度高、降低勞動強度、減少中間環節、能在生產線上一次性完成從零件的退磁、清洗、脫水噴、吹乾全過程。
  13. The lakeview dehydration facility can process up to 8, 000 pounds of plant material per hour

    15湖景鎮的脫水設施每小時能處理8 ， 000磅植物原料。
  14. Applicable for wastewater sludge dehydration and manufacturing process

    適用於廢水所產生之污泥脫水及製程用途。
  15. Till the third generation, dwt series dryer for vegetables dehydratin has been developed. we are making advanced ptrductive equipment for customers. according to the characteristics of raw materials to be dried and the process requirements of sustomers and combined the accumulated experience for more ten years, we have made the most suitable and the dryer for begetables dehydration to supply customers, the series equipment had won cnp, its patent number is

    深入用戶進行調試研究，得到第一手實踐資料並結合國外先進技術，不斷改進完善設備，到目前為止，已開發了對第三代dwt系列蔬菜乾燥產品的特性，用戶工藝要求，結合十幾年來積累的經驗，為用戶設計製作出最適用、品質最佳的蔬菜乾燥設備。
分享友人
分享到 Line

分享到臉書