dielectric breakdown 中文意思是什麼

dielectric breakdown 解釋
電介質崩潰
  • dielectric : adj. 非傳導性的，絕緣的，介電的。n. 電介質，電介體，絕緣體。
  • breakdown : n 1 崩潰，倒塌；破損，損耗；損傷；損壞，故障；失敗，挫折；中斷，停止。2 【航空】下降；【電學】擊...
  1. In the case of dielectric breakdown, a different type of acceleration occurs.

    在介質擊穿的情況下，出現了一種不同類型的加速。
  2. Having reacted with copper, paa becomes complex. the complex decomposes after heat treating and cause the increase in dielectric constant and reduction in dielectric breakdown strength. otherwise cu2o and cuo emerge from the complex, too

    N與cu反應后，形成絡合物，熱處理時自身降解，擊穿強度降低，介電常數提高； cz在熱處理后從絡合物離解出來形成cllo和cuzo 。
  3. The chemical composition and microstructures of the insulating thin films prepared by different methods were analyzed by x - ray diffraction ( xrd ) and scanning electron micrograph ( sem ) ; other properties such as electric resistance, the breakdown field strength and dielectric properties were evaluated using high resistance meter, voltage resistance meter and precision impedance analyzer respectively

    採用x射線衍射儀（ xrd ）對表面絕緣薄膜的物相組成進行了分析，掃描電子顯微鏡（ sem ）對表面絕緣薄膜的微觀結構進行了研究，並用絕緣電阻測試儀、耐壓測試儀和精密阻抗分析儀分別對絕緣膜進行絕緣電阻率、擊穿場強和介電性能的測試。
  4. Standard test method for dielectric breakdown voltage of insulating liquids using disk electrodes

    用圓盤電極測定絕緣液體介電擊穿電壓的標準試驗方法
  5. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin using vde electrodes

    用vde電極測量源自石油的絕緣油介電擊穿電壓的標準試驗方法
  6. Standard test method for dielectric breakdown voltage and dielectric strength of insulating gases at commercial power frequencies

    在工業用電頻率時絕緣氣體介電擊穿電壓和介電強度的標準測試方法
  7. Test method for dielectric breakdown voltage and dielectric strength of electrical insulating materials under direct - voltage stress

    直流電壓應力下電氣絕緣材料的介電擊穿電壓和介電強度的試驗方法
  8. Test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在工業電源頻率下的介電擊穿電壓和介電強度的試驗方法
  9. 10. 01 test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在工業用電頻率下的介電擊穿電壓和介電強度的試驗方法
  10. Characteristics study of short - pulsed dielectric breakdown in liquids

    液體介質快脈沖電壓下擊穿特性研究
  11. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials under direct - voltage stress

    在直流電壓作用下固體電絕緣材料的介電擊穿電壓及介電強度的標準試驗方法
  12. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials at commercial power frequencies

    固體電絕緣材料在商用電源頻率下的介電擊穿電壓和介電強度的標準試驗方法
  13. This dissertation investigates the breakdown theory and reliability characterization methods of the time dependent dielectric breakdown ( tddb ) for the ultra - thin gate oxide, and the hot - carrier effect ( hce ) in deep sub - micron mosfet ' s

    本文對超薄柵氧化層經時擊穿（ tddb ）擊穿機理和可靠性表徵方法以及深亞微米mos器件熱載流子效應（ hce ）進行了系統研究。
  14. A state monitoring method of power cable based on the analysis of dielectric breakdown characteristic was presented

    摘要在對絕緣介質擊穿特性分析的基礎上提出了一種電力電纜狀態監測方法。
  15. The author ' s main contributions are outlined as following : first, the roles of hot electron and hole in dielectric breakdown of ultra - thin gate oxides have been quantitatively investigated by separately controlling the amounts of hot electron and hot hole injection using substrate hot hole ( shh ) injection method. the changes of threshold voltage have been discussed under different stress conditions

    主要研究結果如下：首先，利用襯底熱空穴（ shh ）注入技術分別控制注入到超薄柵氧化層中的熱電子和空穴的數量，定量研究了熱電子和空穴注入對超薄柵氧化層擊穿的影響，討論了不同應力條件下的閾值電壓變化。
  16. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin under impulse conditions

    在脈沖條件下石油成因的絕緣油的電介質擊穿電壓的標準試驗方法
  17. Standard test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials using impulse waves

    用脈沖波法測定固體電絕緣材料的電介質擊穿電壓及抗電強度的標準試驗方法
  18. 10. 02 test method for dielectric breakdown voltage and dielectric strength of solid electrical insulating materials using impulse waves

    用沖擊波測定電氣固體絕緣材料的電介質擊穿電壓和介電強度的試驗方法
  19. Standard test method for verifying the specified dielectric withstand voltage and determining the dielectric breakdown voltage of a membrane switch

    薄膜開關的規定的介質抗電強度的驗證和介質擊穿電壓測定的標準試驗方法
  20. Dielectric breakdown characteristic and state monitoring method of power cable

    電力電纜介質擊穿特性和狀態監測方法
分享友人
分享到 Line

分享到臉書