diffusion coefficient 中文意思是什麼

diffusion coefficient 解釋
擴散率
  • diffusion : n. 1. 散布，發散。2. 傳播，普及。3. 冗長。4. 【化學】滲濾。5. 【物理學】擴散，漫射。
  • coefficient : adj. 共同作用的。n. 1. 共同作用；協同因素。2. 【數，物】系數，率；程度。
  1. If the velocity of atoms is near to zero, the light for ces will tend to confine the atoms near to nodes and antinodes. the stability depends on the magnitude of the negative slope of the light force, the depth of the potential well and the momentum diffusion coefficient. it is important to select the parameters, e. g

    如果通過激光冷卻能使原子速度降至很小甚至為零，光壓力的作用將使原子被較穩定地囚禁于激光駐波場的節點和反節點處，其穩定程度取決于該處光壓力曲線負斜率的大小、對應勢能的勢阱深度以及動量擴散系數的大小，因此，如何在實驗中合理選擇激光強度、失諧量等顯得尤為關鍵。
  2. For same mineral, desorption of 125i " on it was weaker than 125io3 ", and sorption of 125i i25io3 " on galenite is irreversible. apparent diffusion coefficient da of 125i " in the mixed material were determined by the pass - through diffusion way, da values under atmosphere was given : da = 7. 29x10 - 12m2 ? s - 1

    大氣條件下，隨體系固液比的減小，固相的量相對在下降， 125i -在礦物材料上的kd值減小；隨材料粒度的減小，材料的比表面積增加， 125i -在礦物材料上的kd值有所增加。
  3. For a soil or rock of water - lacked, a heat transfer theoretical model is developed, which is a steady or unsteady, the results show that reservoir temperature, thermal diffusion coefficient, inlet temperature, flow rate of and run time of ground source heat pumps have an effect directly on heat transfer process of dhe. it can deduce that intermit running is favorable for this type of soils and rocks

    對于貧含水地下巖土層建立了穩態與非穩態傳熱的理論模型，分析結果表明，巖土層的熱儲溫度、導溫系數、埋地換熱器進水溫度、流量以及地源熱泵系統的運行時間或開停機比，都對埋地換熱器的傳熱過程產生直接影響，可以推斷，對于該類型巖土層的地源熱泵系統，採用間歇運行將是有利的。
  4. A transfer model is established, which can be used to study the interaction between the land surface physical processes of inhomogeneous region and the structure of atmosphere boundary - layer over urban and rural terrains. the model has simulated surface heat flux, surface temperature, temperature profiles, height of mixture layer and so on. and the differences between urban area, suburban area and rural area have been compared. this model mainly depends on the parameters below : surface albedo, surface roughness coefficient, moisture available coefficient of soil, thermal capacity and thermal diffusion coefficient of errain, cloudage. the result shows that this model can simulate the structure and eigenvalues of atmosphere boundary layer and their changes in a day. parameters used in this model aim at beijing city, and the time is at the beginning of september. to other cities, or other time, the parameters should be adjusted accordingly. in addition, being adjusted, the model can also be used for other homogeneous and inhomogeneous terrains

    模式主要依賴于以下參數和物理量：地面反照率下墊面粗糙度土壤的可含水量下墊面的熱容量和熱擴散系數雲量等參數。結果表明，本模式能合理地模擬不同地表熱量平衡地表氣溫混合層高度湍流交換系數湍流動能位溫廓線等，以及它們的日變化。該模式所取參數主要針對北京市，時間為九月初，對于其他城市，參數應作相應的調整。
  5. At the same time, the intrapartical diffusion and liquid internal mass transfer can been enhanced by ultrasound field, owing to additional stirring, the increasing rate of intraparticle diffusion coefficient is enhanced, while that of the liquid film mass transfer coefficient is reduced under ultrasound field

    模型研究表明： freundlich ?兩相阻力模型計算得到濃度與實驗測定值非常吻合，超聲場能有效地強化浸取粒內擴散與液膜傳質，攪拌作用下超聲強化液膜擴散的的能力降低，強化粒內擴散的能力增強。
  6. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  7. The voltage of lithium - intercalation reaction, impedance and structural stability of intercalation - type cathode material were analysed and calculated. theoritical results show that the reaction voltage depends on the content of lithium and the bond energy, and that the key ways to lower the electrode impedance are to increase the electronic conductivity of the electrode and the diffusion coefficient of lithium ion in the host and to decrease the size of powder. in addition, the thermal stability of lithium - insertion structure can be improved by using crystallographic co - lattice theory and doping treatment

    本文從嵌入式陰極材料的嵌鋰反應的電壓、阻抗及結構穩定性的分析和理論計算著手，得到了電壓取決于基體中各種離子間的鍵能及鋰含量、降低電極阻抗的關鍵是提高電子型導電性和li ~ +在基體中的擴散系數及減小粉末粒度的理論依據及其利用晶體的共格原理和摻雜改性的方式來提高材料嵌鋰結構的熱穩定性的設計思路。
  8. Diffusion coefficient of lithium in artificial graphite, mesocarbon microbeads, and disordered carbon

    中間相炭微球及無定形碳中的擴散系數
  9. Using simulation experiments and einstein ' s equation, this paper established a method correcting measured gas diffusion coefficient in strata condition

    利用模擬實驗和愛因斯坦方程建立了一套實測天然氣擴散系數的地層條件校正方法。
  10. Study on the self - diffusion coefficient for the long ch

    高壓下長鏈分子的自擴散系數研究
  11. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  12. Permeability of concrete and its correlation with chloride ion diffusion coefficient under different test conditions including water pressure method and tension method are studied

    本課題主要研究混凝土在水壓法及張力法試驗條件下水在混凝土中的滲透行為以及同氯離子擴散系數相關性。
  13. Water pressure method can distinguish permeability of concrete with different strength or air content, and penetration length or permeability coefficient has good correlation with chloride ion diffusion coefficient. tension method also can distinguish permeability of different concrete, but it has discreteness compared with water pressure method

    通過研究水壓法對于不同滲透性混凝土發現:水壓法能夠較好的區分不同強度、不同含氣量的混凝土的滲透性，滲透高度及滲透系數與氯離子擴散系數的相關性較好。
  14. A lot of results are made from calculating of case for geothermal reservoir property of earth energy within 200 2000 ( m. ) ， it is helpful to analysis influence of permeability coefficient, kinematic viscosity and thermal diffusion coefficient of soils and rocks on heat transfer performance

    在地表熱能熱儲物性為200 - 2000 （ m . ）的范圍內進行的理論計算，得到了許多重要結果，為分析巖土層滲透系數、流體運動粘度和導溫系數等對傳熱量的影響打下了良好基礎。
  15. The effect of gas rates, liquid flow - rates, downcomer width, weir height and the addition of surface active agent on the liquid mean residence time, t, effective diffusion coefficient, de, and froth height, hf were studied. results obtained showed that for two systems, the t in the downcomer of ctst plate is 20 - 50 % smaller than that of fl valve plate, and the de is 40 - 70 % smaller than that of fl valve plate

    通過對氣速、液體流量、降液管寬度、堰高和表面活性劑加入的影響進行分析得出下面結論：在相同的操作條件下，對于兩種物系， ctst塔板降液管的液體停留時間比f1浮閥塔板的約小20 50 ，有效擴散系數比f1浮閥塔板的小40 70 ，泡沫高度低110 150mm 。
  16. Theoretical analysis and numerical experiments show that the improved nine - point scheme not only has completely overcome the second drawback mentioned above that the original nine - point scheme can not apply to the parabolic problem with diffusion coefficient drastically varying, but also has partly improved the applicability of the scheme when performed over irregular grids

    （ 2 ）針對九點格式的上述缺點提出了改進方案。改進后的九點格式完全克服了原格式不適用於熱傳導系數劇烈變化的拋物問題的缺點，同時部分改善了該格式對不規則網格的適應性問題。
  17. The diffusion coefficient is scaled up with porosity percent. the gas diffusion is simulated using diffusion equation in fractal porous media. dispersion process in porous media is analyzed and simulated by use of monte carlo method in this paper

    第四章將蒙特卡羅（隨機模擬）方法應用於多孔介質中的物質傳輸過程，採用通道逾滲模型，對不同孔隙通道聯結率下的彌散規律進行了分析。
  18. Based on the thermodynamics for getting activity coefficient, a symmetry equation was established for calculating inter - diffusion coefficient. the calculated data coincide well with the experimental ones found in literatures

    T匕較而臺，二種復合材料中scs一6sic / tizainb的界面反應程度較輕，與熱力學預測結果一致。
  19. The diffusion coefficient of bovine serum albumin ( bsa ) was studied by dynamic light scattering in different ionic strength solutions

    利用動態光散射技術研究了牛血清白蛋白分子的擴散系數在不同強度離子溶液中隨著蛋白分子濃度變化的規律。
  20. Meaning of ions diffusion coefficient in sapphire diffusion heat treatment

    離子擴散系數在藍寶石擴散熱處理改色中的作用
分享友人
分享到 Line

分享到臉書