dimensional stability test 中文意思是什麼

dimensional stability test 解釋
尺寸穩定性試驗
  • dimensional : adj. 1. 尺寸的。2. 空間的。3. 【數學】因次的；…次（元）的。
  • stability : n. 1. 穩定，穩定性，穩度。2. （船等的）復原力。3. 鞏固；堅定，持久不變。
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Footwear - test methods for insoles - dimensional stability

    鞋靴.鞋墊試驗方法.尺寸穩定性
  2. Test method for dimensional stability of plastic films

    塑料薄膜尺寸變化率試驗方法
  3. Footwear - test methods for outsoles - dimensional stability

    鞋靴.外底的試驗方法.尺寸穩定性
  4. Standard test method for dimensional stability of fabrics to changes in humidity and temperature

    溫度和濕度變化時織物尺寸穩定性的標準試驗方法
  5. The dissertation presents the combined theoretical, numerical and experimental studies on the experimental modeling of the actuator, the design of test rig and control system, the modeling of two - dimensional airfoil aeroelastic system, the control design of active flutter suppression, and the effect of group delay in the digital filter on the stability of aeroelastic closed - loop system

    本文通過理論分析、數值模擬與風洞實驗相結合的方法，研究了超聲電機作動器建模、翼段顫振實驗裝置和控制系統設計、二維翼段氣動彈性系統建模、顫振抑制控制律設計以及數字濾波器群時延對顫振抑制閉環系統穩定性影響等問題。
  6. The two - dimensional axisymmetric subsonic - transonic - supersonic flow in an experimental arcjet thruster is simulated numerically using flux vector splitting method. the profiles of density, velocity, temperature, pressure and mach number can be obtained by the computation. the computation grid and some computed results are given here. the test equipment such as power supply system, ignition system, propellant supply system, arcjet thruster, thrust measuring device and vacuum system are introduced briefly. some working phenomena of the arcjet are observed and discussed. three different kinds of instability appeared in the process of the experiments. except some important parameters are measured, it is found that the operating stability of argon is better than that of nitrogen

    對一實驗電弧加熱式發動機二維軸對稱亞跨超音速流動進行了數值模擬，所採用的方法是矢通量分裂演算法.通過計算可以得出密度、速度、溫度、壓力和馬赫數的分佈.給出了計算所使用的網格和一些計算結果.簡要介紹了實驗所使用的設備，如電源系統、點火系統、推進劑供給系統、電弧加熱式發動機、推力測量裝置和真空系統.對所觀察到的一些工作現象進行了討論.有三種不同的不穩定性出現于實驗過程.除了所測量的一些重要參數，通過實驗發現氬比氮工作更穩定
  7. 3. based on the topography and geologic character of niutoushan arch dam abutment and base, and the interlayer and internal faults, which control the stability of the project, we build the three - dimensional geomechanical model and carry out the upto failure test by overload method. 4

    結合牛頭山拱壩壩肩壩基的地形、地質特徵，以及對穩定起控製作用的層間、層內斷層的分佈狀況，建立了三維地質力學模型，運用超載法對整體模型進行了破壞試驗。
  8. Agglomerated stone - test methods - determination of dimensional stability

    燒結石料.試驗方法.尺寸穩定性測定
  9. Standard test method for dimensional stability of sandwich core materials

    夾層芯部材料尺寸穩定性的標準試驗方法
  10. Standard test method for linear dimensional stability of a gasket material to moisture

    襯墊受潮后線性尺寸穩定性的標準試驗方法
  11. Methods of test for dimensional stability of textile floor coverings - determination of dimensional changes due to changes in ambient humidity

    鋪地織物尺寸穩定性試驗方法.第2部分:環境濕度引起的尺寸變化測定
分享友人
分享到 Line

分享到臉書