discharge by pump 中文意思是什麼

discharge by pump 解釋
用泵卸車
  • discharge : vt 1 發射(炮等),打(槍),射(箭)。2 起,卸(貨)。3 排泄,排出,放出(水等)。4 釋放;解除,...
  • by : adv 1 在側,在旁,在附近。2 (擱)在一邊,(放)到旁邊,(存)在一旁;收著。3 (由旁邊)經過,過...
  • pump : PUMP =politically upwardly mobile personality 政治新星,政治上有望晉升人士。n (淺口無帶的)輕舞...
  1. Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious

    摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲,在稠油泵出口安裝金屬伸縮節和緩沖罐,有效地降低了震動和噪聲。
  2. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合控制實驗系統和實驗方法;介紹了實驗採用的流量控制的pid演算法;並測定了執行器控制閥和閥芯位移相關的系數;做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗;通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。
  3. With the tridimensional finite element method the tridimensional seepage was computed, by the analysis and the computation of tridimensional seepage, the discharge method of the cushion could be asserted, at the same time, the discharge of pump drainage and the up - lift of cushion bottom could be got

    通過三維有限元法計算水墊塘三維滲流場,通過三維滲流分析計算,確定了水墊塘排水方案,並得到水墊塘底板的揚壓力值及抽排系統的排水量。
  4. Results indicate that flow deviation in discharge passage is formed by co - action of pump outflow circulation and secondary flows in outflow curved pipe, hydraulic loss of discharge passage increases and pump assembly efficiency decreases because of flow deviation

    結果表明:水泵出流環量和出水彎管二次流共同作用形成了出水流道偏流,偏流使出水流道水力損失增大,泵裝置效率下降。
  5. Feluwa hose diaphragm piston pumps offer the possibility of continuously feeding discharge and / or suction pulsation dampeners by means of the unique in - built pump piston compressor

    Feluwa軟管隔膜活塞泵藉助于獨一無二的內置活塞壓縮機,提供了向進口和/或出口緩沖器連續補充氣體的可能性。
分享友人