discharge valve control 中文意思是什麼
discharge valve control
解釋
排放閥控制-
To provide necessary data for design bypass pipe, an enlargement to bi liu river reservoir, the following problems have been studied by hydraulic model and theoretical analysis : the energy losses in water head of the bypass pipe system and of the flow - control valve and their scale effects, measurement and calculation of the discharge of the bypass pipe system during the bypass pipe system operation with and without the new water power station, the hydraulic characteristics of the water tunnel and draw - off pipe, the flow rate of the aqueduct bridge and the draw - off pipe and the water elevation of the flow in the aqueduct bridge during the old water power station operation with and without the new water power station
大連市碧流河水庫供水工程取水頭部由引水渡槽、節制閘、進水閘、泄水閘等建築物組成。由於本工程場地條件限制，增設旁通管后布置非常緊湊，管道急轉角度大且轉彎距離較小，對于管內水流流態是否滿足要求，需要經過模型試驗進行論證，以確保工程的可靠性。旁通管具有上水與泄水要求，對其過流能力也要經試驗確定，為碧流河水庫增建旁通管設計提供依據。 -
Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。 -
The definitions and the conditions of cavitation erosion and flash vaporization have been discussed in detail ; the paper also shows examples of different definitions in different books, which cause the complexity of calculating discharge factor and the damage to control valve ; suggests relevant measures to avoid the damage in real working condition
摘要對氣蝕和閃蒸的定義、產生的條件進行了詳細論述，以規范不同版本書籍在概念上的模糊不清，以及由此造成的調節閥流量系數計算的復雜性和對調節閥的損害，以便採取相應措施，在實際工況條件下加以避免。
分享友人