displacement of volume 中文意思是什麼

displacement of volume 解釋
排水體積
  • displacement : n 1 轉位,移動;取代,置換;(人的)流離失所。2 撤換,免職。3 【機械工程】(活塞)排氣量;【航海...
  • of : OF =Old French 古法語。
  • volume : n. 1. 卷,冊;書籍;【歷史】書卷,卷軸。2. 〈常 pl. 〉大塊,大量,許多。3. 體積;容積;分量,額;【物、樂】音量;強度,響度。
  1. This paper presented a new type of triswach ( trimaran small waterplane area center hull ) with small length displacement volume ratio which has low powering requirements at high speed

    摘要提出了一種阻力性能優良、船長排水量系數小的高速小水線面三體船型。
  2. The displacement method, on the other hand, can be used to obtain accurately the cubic volume of any part of the tree.

    另一方面,排水法可用來精確求得樹木任一部分的立方材積。
  3. Be aimed at the characters of fluvial layered pool, such as serious intrastratal and interlayer heterogeneity, small water flooding volume and low oil displacement efficiency in its high water - cut stage, the fine research work on reservoir heterogeneity model are carried out, and the research is done on the base of geological, logging, production testing materials and production date and with a center of the research of remaining oil. the west 7th block, gudong oilfield is in case. the forming mechanisms of remaining oil and its distributing feature in this area are revealed

    本文針對我國陸相沉積層狀油藏層內及層間儲層非均質性嚴重、高含水期水驅波及體積小、驅油效率低等特點,以剩餘油研究為中心,藉助于數學地質統計及聚類分析等方法,綜合利用孤東七區西的地質、測井、生產測試資料和生產動態信息等,深入開展了儲層非均質模型的精細研究,揭示了在不同規模非均質模型上剩餘油的形成機理和分佈特徵。
  4. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響,對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響,弄清了氮氣輔助蒸汽增產的機理主要表現在:氮氣輔助后增加攜熱能力,降低殘余油飽和度,氮氣的壓縮膨脹作用分散和改變了原油流動形態,增強了原油流動性;擴大蒸汽的波及體積,補充地層能量,提高回採水率,強化蒸汽蒸餾效應。
  5. The next this text is based on the appearance theories, according to the characteristics that the temperature dispersion of super thick mass concrete planceer of high - rise building primarily is an even difference in temperature and an even constringency, suppose the level shears are line with the displacement, adopting a big physical volume concrete of planceer in flexibility foundation for plank computing model, from theoretically deducing the difference in temperature of mass concrete contracting should basic formula of dint, and analysis the crack rule and the influence factor of mass concrete temperature contract, and bringing up the theory calculation method about temperature stress of mass concrete and the biggest whole method that sprinkle the length, at the same time according to basic formula of the temperature stress of mass concrete and the concrete construction experience, bringing five technique measures to prevent the temperature crack of mass concrete

    其次本文以唯象理論為基礎,根據高層建築超厚底板大體積混凝土承受的溫差主要是均勻溫差和均勻收縮的特點,闡述了大體積混凝土溫度應力理論計算的簡化方法和最大整澆長度的計算方法,同時根據大體積混凝土溫度收縮應力基本公式和大體積混凝土結構施工經驗,提出了防止大體積混凝土溫度裂縫的五項技術措施。最後本文以廈門郵電大廈3 . 5m超厚底板施工為實例,從大體積混凝土溫度應力計算、混凝土保溫材料厚度計算、混凝土配合比的確定,鋼筋工程、模板工程、混凝土的泵送和澆築以及大體積混凝土內部溫度的監測和後期養護等方面進行了理論應用。
  6. Vacuum technology - positive - displacement vacuum pumps - measurement ofthe volume rate of flow pumping speed

    真空技術.真空正排量泵.體積流量的測定泵速
  7. When the axial compression ratio increases more than 0. 42, the variation of the displacement ductility ratios is small ; when the stirrup ratio per unit volume increases more than 1. 9 %, the displacement ductility increases slowly ; with increasing the shear span ratio a, the displacement ductility increases for, < 1. 5, decreases for > 1. 5

    當軸壓力系數增加到0 . 42以後,位移延性的變化較小;體積配箍率增加到1 . 9 %后,位移延性的增長減緩;當剪跨比小於1 . 5時,型鋼混凝土柱的延性系數隨剪跨比的增加而提高;但當剪跨比大於1 . 5時,隨著剪跨比的增加,型鋼混凝土柱位移延性系數有所降低。
  8. Then, under the condition of satisfied the output volume request, a designing method of parametrically designing hydraulic motor with multi cylindrical gear is proposed aiming at minimal cubage with by means of visual c + + 6. 0 software, a calculating method of parametrically designing hydraulic motor with non - circular planetary gear is proposed aiming at maximal unit displacement and the minimal pulsation ratio by means of visual c + + 6. 0 software, and some designing method examples are provided for verifying the accuracy and possibility of those design methods

    再次,在滿足排量要求條件下,以體積小為設計目標,利用visualc + + 6 . 0軟體對圓柱多齒輪式液壓馬達進行了參數化設計軟體的開發;另外,以單位體積排量最大為設計目標,以流量脈動率最小為約束條件,利用visualc + + 6 . 0軟體對具有圓柱行星齒輪的非圓行星齒輪液壓馬達的參數化設計軟體進行了開發。
  9. Measurement of volume displacement of vibration structure based on pvdf piezoelectric sensors

    壓電傳感器測量振動結構體積位移
  10. With the digital control, volume of compressive oil provided by hydraulic power unit in actuator can be regulated to modulate the test load value. in conformity with the idea, we developed two systems - force and displacement control system in this paper

    根據這一設計思想,我們依據被控參量開發了兩個液壓加載分系統:力控制系統和位移控制系統,以滿足不同的試驗需求。
  11. Thirdly, a calculation formula of distortion settlement is established by considering soil structure damage and plastic drain board restraining displacement of soft foundation. starting with discussing the main factors affecting settlement of consolidated foundation, a reasonable method to modify the calculated settlement of soft foundation by layer - wise summation method is presented here. with calculable coefficients of volume deformation, lateral displacement and structure damage to modify the settlement will be closed to measurer settlement

    ( )在土體損傷理論的基礎上建立了考慮結構損傷、排水板加筋作用的瞬時沉降計算公式,分析了影響土體沉降的主要因素,提出了對按單向分層總和法計算的固結沉降量進行體積應變、側向位移、土體結構損傷三項修正的方法,以上述三個修正系數取代原來單一的綜合經驗系數,使沉降計算值與實測值更接近。
  12. Positive - displacement vacuum pumps - measurement of performance characteristics - part 1 : measurement of volume rate of flow pumping speed

    容積真空泵.性能特性的測定.第1部分:容積流量的測定
  13. 3. with the consider of one mgo concrete arch dam in guangdong province, its construct course was simulated and its thermal field, autogenous volume expansion field, strain field, stress field and displacement field were also analyzed. at the same time, the simulated analysis theory and accuracy and rationality of the program were validated in comparison with the prototype observation data

    3 、結合廣東某外摻mgo混凝土拱壩,對其施工過程進行了模擬,完成了壩體的溫度場、自生體積膨脹場、應變場、應力場及位移場的實時模擬分析,同時結合原型觀測資料的分析,對模擬分析成果進行了驗證。
分享友人