distortion angle 中文意思是什麼

distortion angle 解釋
畸變角
  • distortion : n. 1. 歪扭，扭曲。2. 【電學】（信號、波形等的）失真；【物理學】（透鏡成像產生的）畸變；【醫學】扭轉，變形。3. 竄改，歪曲，曲解。adj. -al
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角，隅，角落；棱，嬗角。2 【數學】角，角位，角的度數。3 【機...
  1. This dissertation is dedicated to the algorithm research of image registration applied to navigation. information such as attitude angle of aircraft is used to emendate the large - geometry - distorted image, so the research of this dissertation is based on the hypothesis that images used have small geometry distortion

    針對圖像匹配在導航中的應用，提出了對于存在大的幾何失真的圖像利用飛行器本身信息進行幾何校正的方法，所以本文演算法的研究都是基於小的幾何失真這一假設的。
  2. Image coordinate and galvanometer pendular angle are kept in the computer according to the f9 field lens characteristic, enter pupil excursion and f6 characteristic error are ignored, that the image of laser scanning point move acceding to unlinearity relation is deduced theoretically. for deducing the distortion, error compensation is considered in the software

    像點坐標與振鏡擺角按f物鏡特性的線性關系存儲在計算機，在忽略了入瞳漂移和f特性誤差后，從理論上推導出二維垂直振鏡分佈中激光束掃描點的像點按照復雜的非線性關系運動，為了減少幾何畸變，在軟體設計中給出誤差補償。
  3. To make the image height of f - theta lens in proportional to the scanning angle, it is primary to introduce barrel distortion

    本質上f - theta鏡頭通過引入桶形畸變，使得像高線性正比于掃描角。
  4. Adjustable shearing angle reduces the distortion of plate material

    上刀架採用內頃結構，便於落料，提高了製件的精度。
  5. Numerical examples show that, pulse deformation and broadening, spectrum redshifting, narrowing and distortion take place with increasing diffraction angle in the near field, and the pulse form changes with propagation distance in the near field, but is preserved in the far field

    數值計算例說明在近場隨衍射角的增大會出現脈沖變形、加寬、譜紅移、變形、變窄等特性，脈沖形狀在近場隨傳輸距離變化而變化，但在遠場保持不變。
  6. By testing the corrected image map, the mean error of point position was 1 meter, the maximal error was 2 meters, length distortions on x and y axis orientation were not more than 1 % and angle distortion was almost not existing

    經檢驗，單點定位平均偏差為1m左右，最大偏差為2m左右，在x 、 y方向上的長度變形均不大於1 ，基本沒有角度變形。
  7. At the same time, this paper analysize the effect of mechanism of distortion of slope, the destoryed - type of slpoe, the manner of reinforcing slpoe and the charge of construction on installed angle of anchor bar

    同時本文分析了在巖質邊坡錨固工程中邊坡的破壞機理、加固方式、施工費用等對錨桿最優安裝角的影響。
  8. Abstract : this paper analyzes theoretically the effect of the reversed cone angle and length of the plug on restraint and elimination to the distortion of the internal spiral ribs, and put forth the design methods of the plug in drawing rifled tube

    文摘:從理論上分析了芯棒倒錐角和芯棒長度對內螺旋凸筋形狀畸變的抑制和消除作用，提出了採用倒錐形等螺距芯棒拉拔內螺紋管時芯棒幾何參數的設計方法。
  9. The in - plane equivalent elastic modulus and tensile strength of stitched composite laminates are studied, and it ' s found that the in - plane equivalent elastic modulus decreases with the increase of stitch density, stitch thread diameter, maximal misalignment angle and the distortion width, and the range is about 5 %. the tensile strength of stitched composite laminate increases with the increase of stitch step and decreases with the stitch space. the

    研究結果表明：隨著縫紉密度、縫紉線直徑、最大纖維偏轉角和縫紉變形區寬度的增加，縫紉復合材料層合板面內等效模量逐漸降低，最大降幅一般在5 %左右；縫紉復合材料層合板的拉伸強度隨縫紉針距的增加而增大，隨縫紉行距的增加而降低，因此縫紉密度對拉伸強度的影響程度要看具體的縫紉針距和行距。
  10. Study of the harmonic distortion in testing circular division ruling error using constant angle method

    常角法檢測圓分度刻劃誤差諧量失真的研究
  11. The study of this paper indicates that, the combined binarization method can keep details well and tolerate the abominable state ; the method to estimate skew angle based on radon transformation is very exact, and the distortion of corrected image is also very little ; the vlp location method based on wavelet analysis and intensity moment has a high location exactness and a soon processing time ; and intelligent character recognition machine can accomplish the function of self - adaption, self - correction, self - study, etc

    本文研究表明：混合二值化方法能較好的保留圖像細節，抗噪聲能力強；基於radon變換估計傾斜角度的方法檢測角度精確，校正後圖像失真較小；基於小波分析和亮度矩的車牌定位方法定位準確率高，速度快；仿人智能字元識別器則能實現識別字元過程中的自適應、自校正、自學習功能等。
  12. ( 5 ) rock mass stability analysis on dam abutment of xia luo - yu damsite as follows : in left dam abutment, sideslip control structure has been relatively integrate, and low dip angle jointing did n ' t develop, so integrate sliding deformation control structure could n ' t been formed in three - dimensional space and rock mass stability could n ' t been influenced badly ; in right dam abutment, indicate rock mass distortion was caused by the rock mass mechanics condition, such as specific rock mass structure, compression stress concentrate with high strength and especial landform and so on

    （ 5 ）對下落魚壩址壩肩巖體穩定問題的分析得出：左壩肩巖體雖然具有相對較完整的側滑控制結構，但由於緩傾角節理不發育，故在三維空間上不能形成完整的滑移變形控制結構，亦不會對壩肩巖體穩定性產生嚴重影響：右壩肩巖體復雜變形，是在特定的巖體結構、高強度的壓應力集中及特殊的地形等不可或缺的巖體力學條件下產生的。
  13. In the paper, li5mn4o83 + li5mn12o24 -, li5mn16o32 +, li17mn16o329 + clusters selected by " seed atoms " were calculated theoretically by means of the quantum chemical dv - xa calculation method. form the angle of electronic structure, the status of lithium ion and the electrochemical properties of lixmn2o4 were discussed preliminarily according to different conditions ( x = l, 2 ). based on calculation results, it ' s found that the jahn - teller distortion, which was thought to lead to poor cyclability, occurred during the discharge of lixmn204, and we also confirmed the formation of a novel phase with low energy after overdischarge ( x = 2 )

    為了從微觀上認識錳系正極材料的結構和電化學性能之間的關系，本文提出了採用量子化學離散變分x （方法，對結合「種子原子法」選取的li5mn4o83 + 、 li5mn12o24 - 、 li5mn16o32 + 、 li17mn16o329 +等錳系正極材料的原子團簇進行了理論計算，從電子結構上初步探討了鋰離子嵌入正極材料后的存在形式以及鋰離子的嵌入對電極材料電化學性能的影響，同時還從結構上對鋰離子電池的循環性能和容量進行了初步的討論。
  14. Firstly, with uniaxial symmetrical rectangle cross section, the warping displacement function and tangential displacement function under anti - symmetrical load are supposed. then taking shear deformation into account and with potential principle, the governing differential equation for distortion angle subjected to uniformly distributed distortion load is established

    首先，以單軸對稱矩形截面薄壁桿件為研究對象，假設其在反對稱荷載作用下翹曲位移和切向位移的分佈函數，考慮剪切變形的影響，利用最小勢能原理建立單位均布畸變荷載作用下的畸變角微分方程。
  15. Based on the reservoir bank protection project, the reconnaissance design, the construction, distortion slope body technical and so on, and according to the ecological prospecting and the forecast appraisal achievement of mountainous area reservoir runned for many years, through actual investigation of the collapses of the bank, the distribution distortion, the types and forming conditions, the collapses formation mechanism of the bank and the types of the pattern are analyzed, and of the bank collapsing parameter of each kind of gneiss under and above water stable angle of slope and so on are confirmend

    摘要利用已運行多年的山區型水庫地質勘探、預測評價成果，在掌握庫岸防護工程的勘察設計、施工及變形坡體的監測等技術資料的基礎上，通過對塌岸及變形的分佈、類型及形成條件等方面問題的實測調查，分析塌岸效應的形成機制及模式類型，確定各類巖土體的水下及水上穩定坡角等塌岸參數。
  16. The penman considers, from the angle of a broad sense of corporate governance which is defined in the text, if we explore the deep causation from all kinds of problems in the process of security markets developments in our country, the ultimate reason is lack of supervision in listed companies, detail behaviors are inside supervision inefficiency caused by irrationality of the framework of possession system and control power, failure of supervision framework inside company, the graveness of control by inner persons, excess low - down deal, lack of property in the state - owned companies, and outside supervision inefficiency caused by limitation of market function and framework and information opacity because of man - made division of stock power, infirmness of outside market system under the condition of insufficient competition, distortion of government system because of improper government interference

    筆者以為，從本文定義的一個廣義的公司治理角度，探尋我國證券市場發展過程中種種問題產生的深層原因，上市公司治理缺失是根源所在，具體表現在：上市公司所有制結構和控制權結構不合理、公司內部治理機構失靈、內部人控制嚴重、內幕交易泛濫、國有控股上市公司所有者缺位等問題所導致的內部治理失效；以及，股權人為分割造成的市場功能性和結構性缺陷與信息不透明、競爭不充分條件下外部市場機制弱化，政府不當干預情況下的政府機制扭曲等等導致的外部治理不力。
  17. The phasemeters will be calibrated by applying two digitally synthesized low distortion sine waves generated by the laboratory s phase angle standard

    本所將用本所相角標準所提供的兩個數字合成低失真正弦波，對相位計進行校正。
  18. Multi - angle analysis accounting information distortion

    企業會計信息失真問題的多視角分析
  19. The distortion of in - plane fibers is considered to be the main reason for the effect of stitching on the in - plane mechanical properties, and the fiber distortion region, the resin - rich pocket and the through - thickness reinforcement section are taken into account. the fiber misalignment angle and the inhomogeneous fiber volume fraction caused by stitching have been determined within the lamina. the elastic constants of a lamina are calculated using a micromechanical model, then the constitutive equations of the stitched composite laminates can be composed

    從縫紉孔附近纖維變形的細觀結構出發，建立的纖維彎曲模型，以面內纖維的彎曲變形作為縫紉影響層合板面內力學性能的主要原因，同時考慮了纖維變形區、厚度增強區以及樹脂富集區的影響，得到單向板內任意一點處的纖維偏轉角和纖維體積百分含量。
  20. It is clearly that only two geometrical parameters i. e. maximal misalignment angle ( ) and distortion width ( s ) need to be determined experimentally

    纖維彎曲模型（ fdm ）只有兩個幾何參數（最大纖維偏轉角和變形區寬度）需要由實驗確定。
分享友人
分享到 Line

分享到臉書