double current circuit 中文意思是什麼

double current circuit 解釋
雙流電路
  • double : adj 1 兩倍的，加倍的。2 雙的，二重的，雙重的；對，雙，兩，復。3 雙人用的；折疊式的。4 （意義）雙...
  • current : adj. 1. 通用的，流行的。2. 現在的，現時的，當時的。3. 流暢的；草寫的。n. 1. 水流；氣流；電流。2. 思潮，潮流；趨勢，傾向。3. 進行，過程。
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. The technology of alternating - current - boosting by way of constant current is successfully used to charge capacitors with 25 kilojoules of energy in only eight seconds. rail - gap switch with performances of long life and highly steady state are designed. and the high voltage pulse generator, which can produce low - excursion and fast - rise pulses, are designed by using double trigger circuit and hydro - thyristor as switch

    在大功率恆流充電技術上，成功的應用了交流調壓式恆流技術，可以在8s內讓電容器儲存25kj的能量;設計出了長壽命、高穩定的軌道開關;採用氫閘流管做開關，使用雙觸發電路，研製出了低抖動、快前沿的高壓脈沖發生器（點火機） ;採用單片機和pld ，研製出了精度為10ns的延時同步機。
  2. The paper synoptically and comprehensively introduces eddy current theory, equivalent circuit, excitation coils, test circuit and application of the eddy - current sensors. a feasible solution of motor core height control based on silicon steel sheet thickness measuring with double eddy - current sensors is presented

    論文在系統全面的分析了電渦流傳感器的基本原理、等效電路、激勵線圈、測量電路及應用后，提出將雙探頭測厚系統應用於電機鐵芯疊控制。
  3. The signal sampling circuit fulfill the tasks of sampling signal and changing the double polarities signal to the single polarity signal ; the drive circuit receives the pwm signals from dsp and pass the signals to ipm through optical - couple devices ; the protective circuit safeguard the system against high current, high voltage, low voltage and high temperature on the ipm model

    其中信號處理電路主要完成採集輸出電流和中間直流環節電壓信號，並對採集到的電流信號進行極性變換處理的功能；驅動電路接收dsp輸出的高頻驅動信號，通過耦合器件直接驅動ipm模塊；保護電路利用採集到電氣信號對整個系統實施保護，包括過電流、過電壓、欠電壓、 ipm模塊過熱等。
  4. According to the test conditions, the double polarity inputting mode is adopted in the circuit of voltage - frequency converting part ; storage batteries are used in the optical emission part of optical fibre isolating and transmitting device, that can guarantee isolation between the main circuit and the testing system ; the 89c51 singlechip is used in the singlechip testing - controlling unit, the peripheral circuits are extended, data are transmitted through the serial port in this part ; the p opular software delphi5. 0 is used in the pc part, the communication between singlechip and pc by serial port, plotting of current wave, regulation of data ; the optical - electrical isolating and triggering are used in the controlling part, this can guarantee the veracity and reliability of breakers triggered, this triggering mode is also used in the triggering of the main closing breaker, the tested breaker and the assistant breaker, the triggering signals are sent out by a singlechip

    壓頻轉換部分電路中根據實際情況採用了雙極性輸入方式；光纖隔離傳輸裝置的光發射部分電源採用了蓄電池供電，確保了主迴路與測試迴路的完全隔離；單片機測控部分採用了89c51單片機，擴充了外圍電路，通過串口向pc機傳送數據； pc機與單片機之間的串口通訊、波形繪制、數據管理等都採用了軟體delphi5 . 0編寫。該測試系統中預留了輸出口，可以對合成迴路中的主合閘開關、被試開關、輔助開關進行觸發，信號由單片機發出，控制部分採用了光電耦合隔離觸發的方法。軟體設計主要集中在對電流信號的數據採集、數據處理、數據傳送、人機界面、波形繪制和數據管理，軟體部分又可分為單片機和pc機程序設計兩大部分。
  5. Obtained by emtp program and the egm, this paper studies on lightning protection performance on 500kv double circuit transmission line the distributed parameter model of tower is built when analyzing the back stroking lightning protection performance for double circuit line, it can truly reflect the spreading course of lightning current on the tower, furthermore, considering the randomness of working voltage ' s phase when lightning strokes the top tower and supposing the probability of lightning appearing arbitrary phase in a cycle of ac is equal, this paper brings forward the statistical method to calculate the rate of back stroking on double circuit line

    本文利用emtp程序、擊距法對500kv同桿雙回線路的耐雷性能進行了研究。在分析同桿雙回線路的反擊耐雷性能時，建立了桿塔的分佈參數計算模型，此模型可以真實地反映雷電流在桿塔上的傳播過程。並針對雷擊塔頂時，導線運行電壓相位角的隨機性，本文假定雷擊出現于交流一周期的任一角度區間內的概率相等，提出了利用統計法計算同桿雙回線路的反擊跳閘率。
  6. According to the space vector modulation method of the equivalent structure of the ac - dc - ac transformation, the transformation relations of the matrix converter are deeply investigated. the ac - ac direct conversion control and the double - space - vector pwm scheme of the matrix converter are deduced, the four - step current commutation strategy of matrix converter is expatiated, the design method of input filter and over voltage protection circuit is analyzed, and the modeling and simulation of a three - phase matrix converter are implemented

    從等效交-直-交變換的空間矢量調制方法出發，深入分析了矩陣式變頻器的變換關系，導出了交-交直接變換控制規律和雙空間矢量脈寬調制技術，闡述了矩陣式變頻器的換流控制策略，分析了輸入濾波器和過電壓保護電路的設計方法，實現了矩陣式變頻器的建模和運行分析。
  7. Studies the work principle and key technology of the boost pfc circuit in theory, designs a small power digital boost pfc converter, this converter works in average current control means and based on tms320lf2407 dsp, adopts current and voltage double closed loop control and pi control arithmetic

    從理論上分析和研究了數字控制boostpfc電路的工作原理和關鍵技術，設計了一款小功率基於tms320lf2407dsp的平均電流控制型的數字控制boostpfc變換器，該變換器應用了電壓、電流雙閉環控制和pi控制演算法。
  8. The results that increasing of bias current and shunted resistance and lowing critical current and connected inductance can decrease the transmission time are shown ; ( 4 ) a new type of circuit, ladder shape multiplayer jtl. structure is provided by author, thus output signal of rsfq circuits can be amplified before transfer to room temperature electronics system. it has highly gain of amplify relatively and the double peak structure are avoided through decreasing parasitic capacitance

    （ 4 ）針對目前超導與室溫介面電路的電壓放大器存在的「雙峰」和放大增益效率較低的不足，提出了一種全新的階梯式多層jtl電壓放大電路結構，較好的解決了以上的問題，通過初步的模擬分析證實，該電路的構思極負有創新性。
  9. Compared with all kinds of mixer circuits and emphasized on improving linearity of the mixer, double balance current switch circuit has been chosen for mixer

    對比分析混頻器的各種拓撲結構，從提高混頻器的線性度出發，折衷考慮功耗、線性度、增益等因素的影響，選取雙平衡電流開關電路作為混頻器的核心單元。
  10. Electrical characteristics for balanced double - current interchange circuits for general use with integrated circuit equipment in the field of data communications

    在數據通信領域中通常同集成電路設備一起使用的平衡雙流介面電路的電氣特性
  11. Electrical characteristics for unbalanced double - current interchange circuits for general use with integrated circuit equipment in the field of data communications

    在數據通信領域中通常同集成電路設備一起使用的非平衡雙流介面電路的電氣特性
  12. The ferrites can be used in ac current and voltage circuit andcommunication circuit, because they absorb the transient energy effectively. furthermore, changing the arrangement of the primary winding coil and the secondarywinding coil and using the double screen for auxiliary current and voitage transformercan be adopted to " induce the common mode transient

    指出鐵氧體磁環/磁珠對交流電流/電壓迴路、通信迴路的共模瞬變騷擾有較好的抑制作用。此外通過改變原副方繞組的布置以及採用雙層屏蔽等技術減小輔助變流器/變壓器原、副方繞組的耦合電容也能夠抑制共模瞬變騷擾。
  13. The paper research small - signal model of pfc circuit and build the simplified average - small - signal model of the system. the thesis develop design method of pi regulators which are applied in double closed - loops system. furthermore, the sampling algorithm of votage and current variables is also analysed in this paper

    文中對pfc電路的小信號模型進行了研究，並建立了系統的簡化平均小信號模型，在此基礎上，以系統的動態特性和穩定性為設計指標，具體給出了雙閉環系統中pi調節器的設計方法。
  14. Adopting the short circuit electric current of to formate the test prove that this contact turn on and cut off performance. according to ablation situation of contact surface after testing, have analysed that coil type double - pole amf influences electric arc

    採用短路電流合成試驗驗證了這種觸頭的開斷性能，根據實驗后觸頭表面的燒蝕情況，分析了線圈式兩極縱向磁場在大電流時對電弧特性的影響。
分享友人
分享到 Line

分享到臉書