dry friction 中文意思是什麼

dry friction 解釋
干磨擦
  • dry : adj 1 乾的，乾燥的；無水分的，干透了的。2 （井、河等）乾涸的，枯竭的；（氣候）乾旱的；無奶的；無...
  • friction : n. 1. 摩擦，阻力。2. 傾軋，沖突，不和 （between）。3. 擦熱皮膚。
  1. Dry friction and wear properties of intermetallics mosi2 against 45 steel

    45鋼摩擦磨損性能的研究
  2. The clutch is a standard dry friction type sized to tolerate the forces required to close the clutch rapidly.

    離合器為標準型干摩擦式，其尺寸由快速合上離合所需要的力的大小決定。
  3. Dry friction occurs when one solid body slides on another.

    一個固體在另一個固體上滑動時出現的現象，稱為干摩擦。
  4. Research on the method of response calculation of labyrinth assembly with dry friction

    帶干摩擦的篦齒封嚴裝置響應計算方法研究
  5. The effects of heat treatment on dry friction and tribological properties under water lubricating are also studied elementarily

    本文還初步探討了熱處理對復合材料干摩擦磨損特性的影響及復合材料在水潤滑時的摩擦磨損特性及磨損機理。
  6. The infrared analysis show that the a small quantity of transition of crystal form from a into y of nylon and its composites happen during dry friction because of the high temperature and strong sheering strength

    紅外分析顯示在干摩擦磨損過程中，磨損表面在高溫及強剪切力的作用下，發生了少量晶型到晶型的轉變。
  7. On the other hand the research about dry friction system response calculation method is limited in passive control system. in this article, the precise solution to the linear quadratic optimal control system with load is analyzed firstly, and then a gradually deduced response solution method of lq control dry friction system is brought forward

    另外人們對干摩擦系統響應計算方法的研究大都局限於不受外載的控制系統，本文在研究外載作用下lq控制系統riccati方程精確解法的基礎上，也提出了干摩擦lq控制系統響應計算的遞推求解方法。
  8. For the use of vibration protection, hysteresis loop is often applied to descript and calculate the parameters of dry friction damping characteristics of metal rubber

    在振動防護領域，通常用金屬橡膠阻尼元件的遲滯回線來描述金屬橡膠的干摩擦阻尼特性。
  9. Dry friction - wear properties and wear mechanisms of the pairs of mosi2 against crwmn steel

    鋼干摩擦磨損特性及磨損機理的研究
  10. Nanotechnology permanent address oil evenly dispersed elements in every aspect of the pre - start before the engine friction protection and avoid machine dry friction. superior high and low temperature performance

    納米技術處理油分子均勻永久分散，在每一次啟動前已對發動機磨擦部位預先保護，徹底避免機器干磨擦，優越的高、低溫性能。
  11. As a kind of material with dry friction damping characteristics, metal rubber is used in many fields

    摘要金屬橡膠作為一種干摩擦阻尼材料，其阻尼特性在很多領域得到了應用。
  12. Then the response calculation formulas of ihb method and the influence of several parameters " changing on the system response are shown in this article. active control method is used in dry friction system at last in the third chapter. on the feedback of speed and acceleration, the active force is applied in accessory structure and main structure separately, the influence of active force is analyzed too

    附加子結構法（ tmd ）是結構抗振的常用的方法之一，文中接著將tmd引入干摩擦抗振系統中，首次提出具有附加子結構的干摩擦抗振系統，並詳細給出了其ihb響應求解的具體公式，分析了各個參數變化對系統響應的影響，然後將主動控制概念引入具有tmd的干摩擦抗振系統中，在速度和加速度反饋的基礎上，將主動控制力分別施加於附加結構和主體結構，分析了它們對系統響應的影響。
  13. Glass - ceramics and glass - ceramic matrix composites have the good potential of studies and application due to their excellent tribological properties under all test conditions, notably with regard to in dry friction

    摘要微晶玻璃及其復合材料在各種摩擦條件下，尤其是干摩擦下優良的摩擦學特性賦予了材料很大的研究開發潛力。
  14. Pairing up with steel and at the condition of dry friction, the pure uhmwpe has an increasing friction coefficient and wear value with the increase of sliding velocity, and so does its composites. the uhmwpe - base composite reinforced by cu powder which makes up 15 % of the composite by weight and the uhmwpe - base composites reinforced by cuo powder which makes up 10 % - 15 % of the composites by weight are more capable of enduring higher sliding velocity than the pure uhmwpe

    在與鋼配副、干摩擦條件下，隨滑動速度的增大， uhmwpe及其復合材料的摩擦系數和磨損量都增大，質量分數為15的cu粉填充uhmwpe復合材料和質量分數為10 15的cuo填充uhmwpe復合材料承受高速的能力強于純uhmwpe 。
  15. Academician prof zhong wan - xie presented precise integration method firstly in 1993, and ordinary differential equation can be solved precisely by this method. in this article, improved precise integration method is given firstly. then on the basis of improved precise integration method, a new method for calculating the response of dry friction system is presented, and the calculation precise degree of this method is tested by the comparison with ihb method

    1993年鐘萬勰院士提出了精細積分法，它可以精確求出常系數常微分方程的數值解，本文首先提出精細積分改進演算法，進一步提高了其計算精度，然後在改進的精細積分法基礎上對于摩擦系統響應的計算方法進行了研究，並用ihb法對這種計算方法的計算精度進行檢驗，結果證明這也是計算干摩擦隔振系統響應的有效方法之一。
  16. In this paper, ptfe and ptfe composited with sicp, sicw, mos2p and sicp + mos2p with various ratios respectively have been obtained by compression molding. under the condition of dry friction, a systematic study has been done on the weight loss and the friction coefficient of composites and the relations between the properties and content of the filling, the load and the sliding velocity

    在干摩擦滑動磨損條件下，對ptfe材料及其復合材料的磨損失重、摩擦系數及磨損機理進行了研究，同時對其與磨損外部條件（載荷、滑動速度）和材料的內部因素（填料的含量、粒徑、種類）的關系進行了較為系統的研究。
  17. Abradability of 40crnimoa steel after composite surface strengthening under condition of high speed dry friction

    鋼表面復合強化后高速干摩擦下的磨損性能
  18. Effects on the dry friction and wear characteristicsof mosi2 by the addition of al

    2材料干摩擦磨損性能的影響
  19. It the seventh chapter, the stability of dry friction system is researched

    第七章對干摩擦系統的穩定性進行了研究。
  20. A research on the properties of the alloyed sic - si ceramic composites in dry friction and wear

    合金化復相陶瓷干摩擦磨損性能的研究
分享友人
分享到 Line

分享到臉書