dry reaction 中文意思是什麼

dry reaction 解釋
干反應
  • dry : adj 1 乾的,乾燥的;無水分的,干透了的。2 (井、河等)乾涸的,枯竭的;(氣候)乾旱的;無奶的;無...
  • reaction : n 1 反作用,反應;反沖;反動力。2 【政治學】反動,倒退;復古(運動)。3 【化學】反應,【物理學】...
  1. Permeable durability reinforcing agent used for concrete surface is a material sealing surface of concrete, and it can permeate into inner of concrete and fill or block the pores of concrete surface with dry crystal or emulsoid generated by reaction between it and chemical compound in concrete

    混凝土表面用滲透型耐久性增強劑是一種針對混凝土表面的滲透封閉型材料,其可滲入混凝土內部,並通過乾燥結晶或與混凝土內部相關物質反應生成乳膠體將混凝土表層的孔隙填充、堵塞,對已有混凝土結構的防護具有重要意義。
  2. Copper - nanosized tibi composites were prepared by in - situ process. the microstructure, mechanical and electrical properties, and dry sliding wear behavior and electric sliding wear of cu - nanosized tib _ 2 in - situ composites was investigated ; mostly task as follows : the thermodynamic data for the reactions between b and ti in the molten liquid of copper were analyzed, the copper matrix composites reinforced by in - situ tibi nanoparticles were prepared by reactions of 8263, carbon and titanium in copper - titanium melt, and copper - titanium, copper - boron in alloy melt, respectively, which controlled the reaction temperature, reaction time and solidification process. the rnicrostructure and mechanical and electrical properties of the in - situ composites were investigated by using optics microscope, tem and xrd

    本文採用原位反應法制備了cu -納米tib _ 2原位復合材料,在此基礎上分析了原位復合材料的微結構,進行了干滑動摩擦磨損和電接觸滑動磨損實驗,完成的主要工作如下:從熱力學的角度出發,分析了陶瓷tib _ 2顆粒在銅基體中原位生成的熱力學條件,並用電解銅、工業純鈦、 b _ 2o _ 3 、 c (還原劑)以及cu - ti 、 cu - b等合金為原料,通過控制適當的反應溫度、反應時間和快速凝固等工藝手段,制備了cu -納米tib2原位復合材料。
  3. Microstructure of the composite layer was analyzed with help of optical microscope, scanning electronic microscope ( sem ), electronic probe microanalysis ( epma ) and x - ray diffraction ( xrd ). the compacting of the billet and the forming mechanism of the carbide reinforcement were studied based on thermodynamics and kinetics of reaction, sintering theory and the result of dta. at the same time, the wear - resistance of the composite layer was studied under condition of dry sliding friction

    利用光學顯微鏡、掃描電子顯微鏡、電子探針以及x -射線衍射儀,分析了表面復合層的基體組織結構;運用反應熱力學、動力學、粉末燒結理論和燃燒合成理論,結合差熱分析結果,探討了表面復合層壓坯的燒結緻密化原理和碳化物增強相的形成機理;利用坯塊在真空燒結爐不同溫度下的燒結出來的顯微組織分析,模擬出坯塊的燒結過程中的化學反應過程。
  4. Sintering speed increased greatly with the help of great quantity of heat of the molten iron, the great quantity of heat sent out from the carbonizing reaction and a little quantity of liquid, this sintering type is an instantaneous sintering, the sintering compacting can carry completely in a few minutes, the degree of sintering compacting is very high. ( 6 ) the vc - fe surface composite has high rigidity, it ' s rigidity exceeds 60hrc, under condition of dry sliding friction and overloading

    鑄造燒結時,過熱鐵水的巨大熱流密度沖擊、粉料壓坯中的碳化反應的放熱以及壓坯中少量液相的產生使壓坯的燒結速度大大提高,此時屬瞬間液相燒結,在十幾分鐘內燒結過程即可完成,可達到很高的緻密化程度。 ( 6 )鑄態下vc一fe表面復合材料具有很高的硬度,其鑄態硬度) 60hrc 。
  5. With the carbon content of dry ash - free basis increasing, the ignition activation energy increase and the reaction rate fall

    乾燥無灰基固定碳含量增加,其著火活化能逐漸升高,反應速率逐漸降低。
  6. The work mainly consists of four parts : the first part is to use oxidation and lpcvd technique to produce sio2 mask film and si3n4 insulation film in order to enhance the heating efficiency of micro chamber, and guarantee the carry out of the reaction. the second part is to use the combination of dry etching and wet etching to produce reaction micro chamber, it is the container which carry out the pcr reaction, and dna sample carry out amplification reaction here. the third part is to use the sputtering, photolithography to produce heaters and temperature sensors which heat the reaction micro chamber and provide the temperature condition for the pcr reaction

    首先,利用氧化工藝和lpcvd技術,生長sio _ 2掩膜層和si _ 3n _ 4絕緣層,以提高反應腔的熱效率,保證擴增反應的順利進行;其次,用濕法腐蝕和干法刻蝕相結合的方法加工微型腔體,使之作為dna樣品進行pcr擴增反應的容器;第三,用濺射、光刻等工藝在微型腔體底部製作微型加熱器和溫度傳感器,實現對反應腔體的加熱及其溫度的精確測量,提供pcr擴增反應所需的溫度條件。
  7. The experiment suggested that under the dry condition, during the 12 - hour - touched, the reaction between the sapphire and the three type of the basalt melt is not obvious, and the sapphire bands can be seen obviously, although the temperature amounted to 1360 ?. on the basis of this experiment, we would like to give some advice on sapphire - color - changed research

    實驗表明,盡管溫度高達1360吧,但在干係統條件下,在12小時的接觸過程中,沒有觀察到藍寶石與三類巖石(即上述含礦,不含礦及其過渡類型)的熔漿有明顯的交代跡象,且藍寶石的環帶依然清晰可見。
  8. The chemical reaction principle and the process of preparing iron oxide red by dry process were introduced

    摘要介紹了用工業廢鐵制取氧化鐵紅的化學反應機理及生產工藝過程。
分享友人