earthquake axis 中文意思是什麼

The result show, most of the medium - strong earthquakes faults are dip - slip reversed, distribution of the main stress p axis is sector from west to east ; there are large difference between kuche and baicheng region in seismic activities, but the characteristic of cluster is same in the two region ; the distribution of medium - strong earthquakes is nw direction in baicheng region, it show, there can have a concealed fault ; small earthquake clusters ' activities can reflect the effect that local medium - strong earthquakes to the secondary small structure around it

結果表明：南天山東段中強震震源斷錯以傾滑逆斷為主，主壓應力p軸由西到東呈扇形分佈；相距較近的庫車與拜城地區地震活動存在較大差異，但均存在明顯的成叢性分佈特點；拜城地區中強地震分佈呈北西向可能預示著該區存在隱伏斷裂，小震群活動則可能反映了局部中強震對周圍次級小構造的影響。

The meaning of cqc ( t ) algorithm is the difference in time domain between the peak value location in time axis of input earthquake and model response of structure, which is called delay time. through the delay time calculating of a series of oscillators with different damp ratio and natural vibration frequency, it is found that it will bring biggish error if the cqc algorithm applied on the structure which has long period, and the time dependent cqc ( t ) algorithm could solve the problem easily

Cqc （ t ）方法的意義在於輸入地震動峰值與結構模態響應峰值在時間軸上的時間差，我們稱之為延遲時間，通過計算具有不同周期和阻尼比結構的延遲時間，發現對于自振周期比較長的結構， cqc方法會帶來比較大的誤差，而基於時程的cqc （ t ）方法能夠解決這個問題。

Under the horizontal earthquake action and wind force, aim at " the pure frame structure with rectangle columns ", " the pure frame structure with special - shaped columns ", " the frame - truss structure with special - shaped columns " and " frame - shear wall structure with special - shaped columns ", earthquake action analysis was done by the spacial finite element method through the changes structural parameter. analyzing systematically " structure vibration mode ", " vibration period ", " structure lateral rigidity ", " seismic action force ", " seismic response force ", " floor seismic shear force ", " lateral horizontal displacement of structure " and " members internal force ". results indicate : ( 1 ) based on equal area, the special - shaped columns replaced the rectangle columns, the structural lateral rigidity enlarges, the lateral displacement minishes obviously, the earthquake response increase slightly, the biggest increasing amount of frame columns axis - compress ratio is smaller than 0. 08. the whole aseismic performance of structure has improved ; ( 2 ) when the section ' s length and section ' s thickness ratio of special - shaped columns is smaller than 3. 6, the structure benefits to resist seismic action ; ( 3 ) the angle of horizontal seismic action with the whole coordinate is 0 degree, structure earthquake response is bigger, belonging to a control factor of structure aseismic design ; ( 4 ) the frame - truss structure with special - shaped columns and the " a " - brace has the biggest lateral rigidity ; ( 5 ) the frame - shear wall structure with special - shaped columns have bigger lateral rigidity and smaller displacement, members internal force enlarged just rightly, have much superiority of resisting seismic action ; ( 6 ) in the higher seismic fortification criterion region ( 8 degree of seismic fortification intensity ), aseismic disadvantageous building site ( iii type site ), adopting special - shaped columns structure system, should reduce possibly the building ' s self - weight in order to reduce the earthquake response ; ( 7 ) the response spectrum method of computing seismic response and the time - history analysis method have similar analysis result

西安理工大學碩士學位論文在水平地震作用下，並考慮風荷載組合，分別對「矩形柱純框架結構」 、 「異型柱純框架結構」 、 「異型柱框一析架結構」及「異型柱框-剪結構」等四種結構體系，通過改變結構參數，運用空間有限元方法，進行地震作用計算。系統地分析研究「結構振型」 、 「振動周期」 、 「結構側向剛度」 、 「結構地震反應力」 、 「樓層地震剪力」 、 「結構側向位移」 、 「層間位移角」 ，以及「構件內力」 。結果表明:在等面積原則下，異型柱代換矩形柱后，結構剛度增大，側向位移明顯減小，地震反應力略有增加，框架柱軸壓比最大增幅小於8 % ，結構整體抗震性能有所提高;當異型柱肢長肢厚比小於等於3 . 6時，結構有利於抗震;水平地震作用力與整體坐標夾角為0度時，結構地震作用效應較大，屬結構設計的控制因素之一;異型柱框一析架結構採用「人」字斜撐，側向剛度大於「八」字斜撐和「人一八」字混合斜撐;異型柱框一剪結構側向剛度大、位移小，構件內力增大適中，是一種抗震性能優越的結構體系:在抗震設防烈度較高地區（ 8度）和抗震不利的建築場地（ m類場地） ，採用異型柱結構體系時，應盡可能減輕結構自重，降低地震作用力;分別採用「振型分解反應譜」法和「時程分析」法進行地震作用計算，兩種方法所得結果基本一致。

To obtain the stress level at the earthquake source, this paper sets forth the solution of the stress magnitude at the earthquake source by seismic stress drop and the stress axis deflections before and after large earthquakes

摘要為求解震源處應力量值，運用大地震造成的應力方向偏轉和地震應力降給出了求取震源處應力大小的方法。

The axis direction stress in tunnel entrance is not slighting under earthquake loading

指出在地震作用下，洞口段隧道襯砌軸向力不可忽視。