ejector exit 中文意思是什麼
ejector exit
解釋
引射器噴口-
Abstract : optimum distances between primary nozzle exit and mixing tube inlet, static pressure recovery of the mixing flow in mixing tube 、 total pressure distributions at the exit of mixing tube 、 pumping coefficients and total pressure losses of the exhaust ejector systems with four different types of primary nozzles have been measured in the experiments
文摘:對4種主噴管組成的排氣引射系統的引射系數和總壓損失、各主噴管出口與混合管進口之間的最佳間距、混合氣流在混合管內的靜壓恢復及混合氣流在混合管出口處的總壓分佈等進行了測量和對比。 -
The results indicate that with decrease of exit area of secondary nozzle, the bypass ratio is decreasing, and the static pressure in integrated ejector combustor is increasing, and mixing condition becomes better. there exists an optimal exit area of secondary nozzle to get maximum thrust of rocket ejector
結果表明：引射能力隨著二次噴管出口面積的減小而減小；整體式引射燃燒室壓強隨著二次噴管出口面積的減小而上升，混合隨之更為充分；存在一個最優的二次噴管出口面積，使發動機推力最大。 -
It is shown that when the exit area of secondary nozzle and the fuel / oxidizer ratio is fixed, the increase of mass flow rate of secondary flow lead to the decrease of velocity of mixed flow, and increase of total mass flow rate. the synthetical result of these two phenomenon cause the increase of thrust of rocket ejector, but the increasing magnitude is relatively small, indicating that these is no necessary to claim large bypass ratio in rocket ejector design. in the comparison between two configurations, the typical one has better performance, indicating the importance of pressure ratio
結果表明：在固定二次噴管出口面積和氧燃比的條件下，二次流（引射空氣流）流量的增加引起混合氣體出口速度的下降和總流量的增加，二者綜合作用使發動機推力增加，但增幅不大，表明在設計發動機結構和工作參數時，不必過分追求大的引射系數；兩種結構的性能對比分析表明了增壓比對引射火箭性能的提高具有重要意義；對引射火箭的熱力循環分析同樣表明，增壓比對于提高發動機性能非常關鍵。
分享友人