elasticity bearing 中文意思是什麼
elasticity bearing
解釋
彈性軸承- elasticity : n. 1. 彈力，彈性；伸縮力，伸縮性，靈活性。2. 開朗的性情。
- bearing : n 1 忍耐，忍受。2 態度，舉止，風采，姿態。3 關系，影響，方面，聯系 （on; upon）; 意義。4 〈常 pl ...
-
According to the load behavior and defection degrees of existed reinforced concrete bridge, the calculating modeles for normal section strength and bearing capacity for reinforced concrete bridge are established by the elasticity analysis and nonlinear analysis of grade stiffness degeneration
根據既有鋼筋混凝土橋梁的受力特點和損傷程度，採用兩種方法：即《規范》法分析理論和分級剛度退化非線性分析理論，分別建立了既有鋼筋混凝土橋梁正截面強度計算和承載能力評定的計算分析模型。 -
This paper first conducts the research to the steel wire roller conveyer ball bearing rolling body and the steel wire roller conveyer spot contact question, gives the main geometry parameter of the zone of contact by the hertz contact theory, stress extreme value as well as contact body elasticity approach quantity formula, and acts according to the practical application to carry on the simplification, calculates the main parameter of the bearing zone
本論文首先對鋼絲滾道球軸承滾動體與鋼絲滾道的點接觸問題進行研究，由hertz接觸理論給出接觸區的主要幾何參數，應力極值以及接觸體彈性趨近量的計算公式，並根據實際應用進行簡化，計算出課題所研究軸承接觸區的主要參數。 -
The way to eliminate chaos phenomenon through adjusting system parameters is indicated. the nonlinear dynamic behavior of journal bearing - rotor system in large parameter space is studied in numerical integral method and floquet theory and the first and second bifurcation behavior of nonlinear rotor system are discussed ; the concept is advanced that realizing the controllable nonlinear stiffness with sfd with the soft - nonlinear of sma in the super - elasticity state to make the vibration amplitude of system always be in the small solution state to reduce the vibration amplitude of rotor system
運用數值積分方法結合floquet理論對滑動軸承-轉子系統的大參數范圍非線性動力學特性進行了全面的研究，詳細地討論了系統的一次和二次分岔行為； 5 ）提出了用形狀記憶合金在超彈性狀態下的軟非線性，結合擠壓油膜阻尼器實現系統剛性的非線性可控，降低系統在非定常狀態下的最大振幅的構想。 -
The paper deduced the deformation and flexural bearing capacity formula by the theory of elasticity - plasticity, ultimate - state method
本文分析研究中用彈性理論、彈塑性理論、極限狀態方法推導組合板受彎承載力和變形計算公式。 -
Then, mechanical responses of pavement structures were analyzed with elasticity theory, based on actually applied pattern of heavy loading, analysis method of ultimate bearing capacity of pavement structures was proposed, and the factors affecting ultimate bearing capacity were analyzed also, which provided a theoretical basis for the restriction of alex load
其次，根據實測荷載作用面積和計算輪胎接地壓力，計算了重荷載作用下水泥混凝土路面結構的力學響應，提出了分析混凝土路面極限承載力的方法，並分析了極限承載力的影響因素，為限載提供了理論依據。 -
The fifth chapter makes a technological analysis to the engine bolt on the whole and put forward the application of plasticity out of shape district control law and elasticity out of shape district corner control law to the keys parts of the engines, including connecting rod and main bearing
第五章對發動機螺栓緊固技術作了技術分析，提出了塑性變形區控製法和彈性變形區轉角控製法在發動機關鍵部位螺栓，如連桿、曲軸主軸承蓋上的應用。 -
Adding the eccentric brace to the reinforced concrete frame is for strengthening the side stiffness and improving the load - bearing and energy consume ability. when the braced frame resists external force, there is higher side - stiffness at the state of elasticity
在鋼筋砼框架結構中加入偏心支撐，其主要目的是提高鋼筋砼框架的抗側剛度、改善框架結構的承載力和耗能能力。 -
And under the three load cases, the critical load of the cable - stayed arch bridge taking into account double nonlinearity is much smaller than taking into account linear elasticity or geometrical nonlinearity. therefore if we want to estimate the limit bearing capacity exactly, the double nonlinearity must be considered
在三種加載工況作用下，考慮雙重非線性的臨界荷載遠小於線彈性和僅考慮幾何非線性臨界荷載。因此，採用線彈性和僅考慮幾何非線性方法均會過高地估計結構的極限承載力，要準確評估出結構的極限承載力必須考慮雙重非線性。
分享友人