electrode carrier 中文意思是什麼
electrode carrier
解釋
電極夾-
Gold nanoparticles were chemically adsorbed on the pvc - nh2 matrix membrane ph electrode surface containing n, n - didecylaminomethylbenzene ( damab ) as a neutral carrier and urease was then immobilized on the gold nanoparticles
首先將納米金組裝在含有中性載體damab的pvc - nh2膜表面，然後通過化學吸附作用將脲酶固定在納米金上制得脲酶電極並用於檢測汞離子。 -
The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field
具體工作可以概括如下：首先，研究了vcsel的熱場特性，分析了電流擴展，材料參數和工作條件對于溫度分佈的影響；其次，從電極電壓入手，計算出激光器中的等勢線分佈，並對不同深度處的電壓和電流分佈進行比較，研究了高阻區的不同位置和不同厚度、限制層和出射窗口半徑的大小對電流密度、載流子濃度和溫度分佈的影響；再次，實現了電、光、熱耦合，求出了閾值電壓，計算了不同偏置電壓下的電流密度分佈、載流子濃度分佈和熱場分佈，分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響；最後，給出了考慮n - dbr和雙氧化限制層時激光器中的等勢線分佈，分析了n - dbr和雙氧化限制層對vcsel電流密度、載流子濃度、溫度和光場分佈的影響。 -
The optimum conditions for air electrode preparation were shown as follows : active carbon which was baked for 15 min in 900 as carrier for catalyst, bond is 60mass % polytetrafluoroethylene ( ptfe ) liquor, 20 % ptfe in waterproof layer, 10mass % pore - making in waterproof layer thickness of waterproof layer 0. 30mm, 10mass % ptfe in catalysis layer, nickel screen for current collector, compacting pressure 6mpa
確定製備空氣電極的最佳工藝條件為:催化劑載體的處理條件為在900下灼燒15min ，粘結劑為60mass % ptfe的水溶液。防水層中pefe含量為20mass % ，造孔劑含量為10mass % ，其厚度為0 . 3mm 。催化層中ptfe含量為10mass % 。 -
Electrode with a mobile carrier
流流體載動電極
分享友人