electron alloys 中文意思是什麼
electron alloys
解釋
鎂合金-
Qantitative method for electron probe microanalysis of metals and alloys
金屬及合金的電子探針定量分析方法 -
By analyzing the microstructure of as - cast alloys with different surplus of samarium added, the optimum surplus of samarium is decided. by comparing the microstructure of the alloys annealed for different time, the ideal and economical annealing time is confirmed. the microstructure and phase composition of alloys during the whole preparation of sm2fe17nx are analyzed using the scanning electron micrograph with energy - dispersive x - ray analysis and x - ray diffraction patterns
本論文首先就熔煉工藝參數對鑄態組織微結構的影響進行了探討，並制定出一套較為合適的熔煉工藝；通過對不同釤加入量的鑄態組織微觀結構的觀察分析，確定了原料配置過程中釤的最佳補償量；通過對採用不同退火時間的合金組織進行比較，確定了理想、經濟的退火時間；同時還利用掃描電子顯微圖像和x射線衍射圖譜，比較了整個制備過程中，試樣微結構和相組成的變化情況。 -
The results of the experiments show that the ti3al - tcll dual alloys, by vacuum - electron - beam weld, hot die forging and 680c / 12h, ac, heat treatments, have satisfied synthesis properties of intensity, plasticity, hardness. and also it is the feasiblie way. this will establish the supporting technology for the manufacture of the compress disk in the areoengine
實驗結果表明，經真空電子束焊接ti _ 3al ? tc11雙合金經過熱模鍛造和680 12h ， ac或815 1h + 700 8h ， ac熱處理后，焊接區組織過渡均勻，可以使得焊縫處強度在室溫拉伸時高於ti _ 3al ，而在600拉伸時高於tc11合金，獲得強度、塑性、硬度均令人滿意的綜合性能，且是一條可行的工藝路線。 -
There are distinct changes about shifts or intensity in bulk plasmon, surface plasmon, and interband electron transitions losses as a result of oxidation of specimens, and adsorption and oxidation processes can be studied through these changes. at room temperature, the formation of oxide layers on uranium and uranium - niobium alloys were found to occur rapidly upon exposure to oxygen, and the resultant oxide in each case was near - stoichiometric uo2. due to formation of niobium oxide in uranium - niobium alloys, the diffusion of o ~ ( - ) ( o ~ ( 2 - ) ) and u ~ ( 4 + ) in the interface region was prevented, and the corrosion resistance of uranium - niobium alloys to oxygen is greatly enhanced by alloying with niobium
研究結果表明：清潔表面鈮和鈾的體等離子體振蕩所造成的電子能量損失的實驗值與理論計算值較為符合；隨著氧化程度的加劇，表面等離子體（ sp ） 、體等離子體（ bp ）以及價帶電子躍遷所造成電子能量損失的譜峰發生了明顯的連續偏移或強度的變化，這些變化可以用來分析鈾及鈾鈮合金的初始氧化過程；室溫下，鈾及鈾鈮合金很容易與氧作用，最終結果，鈾僅氧化為二氧化鈾，另外，在鈾鈮合金氧化過程中，因為有鈮的氧化物存在，不利於氧和鈾在界面擴散，增強了鈾鈮合金抗氧化性能； eels能獲得樣品表面的信息比aes更為表面，更為靈敏，但由於eels的譜線過于集中，主要在幾十ev以內，也有不容易區別和解譜的不足。 -
Welding - electron and laser beam welded joints - guidance on quality levels for imperfections - aluminium and its weldable alloys
焊接.電子和激光束焊接接頭.缺陷的質量分級指南.鋁及其可焊合金 -
In this work, using elemental powders as starting reactant materials several carbide powders such as wc, sic, tic, zrc and corresponding alloys had been fabricated by ball - milling technique. x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), transmission electron microscopy ( tem ) and other measurement techniques had been used to monitor the structural changes of powders after some ball milling time and the properties of the cemented tungsten carbides. and the mechanism for the formation of matal carbides by ma has also been discussed
本文主要對機械合金化（ ma ）技術在碳化物制備中的應用進行了研究，利用高能球磨，以元素粉末為原料，制備出wc 、 sic 、 tic 、 zrc的粉體以及wc基硬質復合材料，並利用x射線衍射、掃描電鏡、透射電鏡等方法分析和研究了球磨過程粉體的變化以及燒結后硬質合金的性能，對機械合金化制備碳化物的有關機理進行了研究和探索。 -
The influence of a static electric field was investigated systemic in three stratifications : the electron scope of single atom, multi - atom local effect and macro - materials character based on electron theory. the multi - scope effect of electric field on metals and alloys, such as the atomic energy, solute elements, microstructure and precipitates, fracture character, mechanic and physical properties, were studied with the purpose of finding the mechanism and the nature of the electric field
針對目前電場作用研究中的問題，本文以鋁合金為研究對象，分別在三個不同尺度的理論范疇：單原子的電子理論，多原子（原子團簇）的微觀局域效應，和材料宏、微觀行為，系統的、多層次的研究了電場在電子層次，溶質行為，微觀組織，以及宏觀的斷裂特徵和性能等多個尺度的電場效應。 -
The corrosion resistance of uranium is greatly enhanced by alloying with niobium. in this study the adsorption process and the initial stage of oxidation reactions of oxygen on uranium - niobium alloys surface at room temperature were studied with electron energy loss spectroscopy and auger energy spectroscopy ( aes ) in this paper
鈾鈮合金化很大程度上增強了鈾的抗腐蝕性，本文主要是利用電子能量損失譜和俄歇電子能譜（ augerelectronspectroscopy ，簡稱aes ）研究鈾鈮合金的初始氧化過程。
分享友人