emission coefficient 中文意思是什麼

emission coefficient 解釋
發射系數
  • emission : n. 1. （光、熱、氣體等的）發出，發射，射出，放射；傳播。2. （紙幣等的）發行；發行額。3. 發出物，放射物。4. 【醫學】排出；遺精。
  • coefficient : adj. 共同作用的。n. 1. 共同作用；協同因素。2. 【數，物】系數，率；程度。
  1. The imported transparent glaze fired at lower temperature was analysed semi - quantitatively by adopting emission spectroscope. the stripping of lead and cadmium from this transparent glaze fired at lower temperature in ceramic product was determined by atomic absorption spectroscope. the effect of chemical composition on the stripping of lead and cadmium was analysed. upon the author s opinion, the overproof lead stripping from the imported transparent glaze fired at lower temperature can only be settled by adopting lead - free glaze instead of adopting low - lead prescription. the author succeeded in developing an excellent lead - free transparent glaze fired at the lower temperature of 1000 1050. the success is based on an inquiry into the feasibility of using such new agents of fusion as li2o and sro in replacement of pbo ; and on a study of the effects of the contents of sio2 ， al2o3 ， b2o3and other metallic oxides on such performances of glaze as coefficient of linear expansion, fusion temperature and transparency. it is also based on an analysis of coefficient of linear expansion of blank and glaze on an analysis of coefficient of linear expansion of blank and glaze on their correlation ; and on a study of technology for preparing glaze

    採用發射光譜儀對進口低溫透明釉進行半定量分析，並用原子吸收光譜儀測定其陶瓷製品的鉛、鎘的溶出量，分析化學成分對鉛、鎘溶出量的影響.結果表明，進口低溫透明釉採用低鉛配方不能解決鉛溶出量的超標問題，只有採用無鉛釉才能解決.探討用氧化鋰和氧化鍶等新型熔劑完全代替氧化鉛的工藝，研究釉料中氧化硅、氧化鋁、氧化硼和各種金屬氧化物的含量，對釉的線膨脹系數、熔融溫度和透明度等性能的影響.分析坯料、釉料的線膨脹系數及其相互關系和釉料制備的工藝，研製出優質的1000 1050低溫無鉛透明釉
  2. Based on the comparison and analysis of the secondary electron emission coefficient of two kinds of emitter gaas in theory, it is concluded that when primary electron energy is lower the deviation of secondary electron emission coefficient of two kinds of emitter gaas will become smaller, while when primary electron energy is higher the deviation will increase

    通過對兩種負電子親和勢二次電子發射材料的二次電子發射系數的理論值進行比較和分析，得出：當原電子入射能量較低時，兩種材料的二次電子發射系數差值較小；當原電子入射能量較高時，兩種材料的二次電子發射系數差值較大，而且隨著原電子入射能量的升高，兩種材料的二次電子發射系數差值也在增大。
  3. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  4. There are 3 parts of heat loss for gas boiler, including heat emission loss, uncompleted burning loss and fume hot loss, uncompleted burning loss decreases following the increase of excess air coefficient, while fume hot loss increases. it is obvious that there exit an optimum coefficient of excess air which make boiler own highest efficiency which is the purpose of burning control

    不完全燃燒熱損失隨過量空氣系數的增大而減小，而排煙熱損失隨過量空氣系數的增大而增大，不難看出，存在一最佳的過量空氣系數使得兩者之和最小，即使得鍋爐的熱效率最高，燃燒控制的目的即在於此。
  5. In this paper a perfect and flexible experimental system of low nox combustion is established firstly. the influences of the temperature of combustion, the air excess coefficient, a certain amount of vapor added in advance, the temperature of preheated air, adding microwave into gas before combustion, gas recycling combustion and the mode of combustion ( diffused and premixed ) on nox emission are analyzed respectively. the combustion of liquid petroleum gas is simulated with phoenics 3. 5

    首先建立了完善靈活的低no _ x燃燒實驗系統，在實驗系統上完成了燃燒溫度、過量空氣系數、預先加入一定量的水蒸汽、空氣預熱溫度、對燃氣預先進行微波處理、煙氣再循環燃燒以及燃燒方式（擴散式與預混式）對no _ x生成的影響分析；採用phoenics3 . 5軟體進行了液化石油氣燃燒的數值模擬。
  6. This paper proposed a multizone and multidimensional radiation heat transfer model of g4135 diesel engine, including a combustion chamber space zone - model, a radiate temperature model, a radiate emission coefficient and an absorption coefficient model

    摘要對g4135直噴式柴油機建立了一個輻射多區多維模型，包括缸內工質的幾何空間模型、輻射溫度模型、輻射發射系數、吸收系數以及燃料油滴的散射系數模型。
  7. Moreover, multiple frequency stimulation method can increase consumption of ic obviously and surface diffuse reflection method can improve surface emission coefficient of ic availably

    混和信號激勵法能明顯增大三極體放大電路耗散功率，特別是第一級耗散功率；增頻激勵法能有效提高ic耗散功率；表面漫射法能有效增大元器件的發射系數。
分享友人
分享到 Line

分享到臉書