end valve 中文意思是什麼

end valve 解釋
端閥
  • end : n 1 端，尖，末端，終點。2 邊緣；極點，極限。3 結局，結果。4 目的。5 最後，死。6 【紡織；印染】經...
  • valve : n 1 【機械工程】閥，活門，舌門；汽門。2 【解剖學；動物學】瓣，瓣膜；（貝）殼瓣；【植物；植物學】...
  1. After the valve has been adjusted to its balance set point and without moving the handwheel, remove the retaining bolt from the end of the handwheel using a 1 / 4 " allen wrench

    在閥門調整到平衡點，並且沒有旋轉手輪后，採用一把1 / 4 "通用扳手從手輪末端拆卸固定螺栓。
  2. The end flaps of the elastomeric seat should be flexed downward toward the valve i. d. as the body halves are being separated

    當閥體分開時，彈性閥體閥座的邊緣應該朝向閥門內徑彎曲。
  3. Take one body half and, starting at the bottom of the valve, work the end flap of the elastomeric seat into the opening of the body

    拿起一半閥體，從閥門底部開始，將彈性材料閥座的邊緣放入閥體的開口處。
  4. Valve should be clamped in a vise by the hexagonal metal shaft and the body halves pried apart at opposite end with a small screwdriver or similar thin edged metal tool

    這時閥門應該用一個六角形金屬軸夾緊在老虎鉗內，用一把小螺絲刀或類似的具有薄邊緣的金屬工具將閥體翹成兩半。
  5. As late as the end of the 18th century, there were still crooks for different keys, but when the valves were invented in the 19th century, the valve trumpet became an important brass instrument of the symphony orchestra

    起初因為沒有活塞，所以只能發出兩三種不同高低的聲音，吹出極為簡單的曲調。由於活塞的發明與使用，使現代的小號可以任意吹出多種曲調。
  6. Dimmension of valve stem end

    閥桿端部尺寸
  7. Insert a soft, blunt instrument into the valve end marked with the flow arrow and push the ball out of the valve end marked with the adj. arrow

    用一個柔軟的、無稜角的工具插入閥門上標記flow （流向）箭頭的埠，將球體從閥門上標記adj （調整）箭頭的埠推出。
  8. In the end, the mechanism of explosive accidents of lpg vessel under high temperature is analyzed. the major inducements of lpg vessel under high temperature are as follows : 1 ) sudden falling of pressure on valve opening ; 2 ) material strength falling of vessel wall, which is caused by high temperature of vessel wall ; 3 ) thermal stress that is caused by non - uniform temperature of vessel wall

    武漢理工大學碩士學位論文? ?論文最後分析了高溫環境下液化氣容器爆炸的事故機理，即高溫環境下液化氣容器爆炸的主要誘因為： 1 ）閥門打開時的壓力驟降； 2 ）容器壁溫度過高，導致容器壁的材料強度降低； 3 ）容器壁的溫度不均勻引起的熱應力。
  9. Note : periodic relief valve discharge may occur on dead end service applications, such as boiler feed lines or cooling tower makeup lines

    注意：在終端應用中，如鍋爐給水管線或冷卻塔補水管線，安全閥可能會出現周期性排放。
  10. In the end, the kinesis analysis and simulation methods of valve train utilizing ug - ii / motion modules are also discussed

    並利用ug - motion模塊進行配氣機構運動分析與模擬。
  11. Special water - saving valve, special shower head with strong spray power, using while bathing can put an end to waste

    專用節水閥、專用花灑，噴射力強，隨開隨用杜絕浪費。
  12. H the high - raisepitch of pump also must install inverted - end valve at export - pipeline, to prevent the water - hammer of closed suddenly to destroy

    8揚程高的泵在出口管路上還應該安裝逆止閥，以防突然停機的水錘破壞
  13. The linkage rides to the end of the slot with enough force to break the choke valve away from the full-choke position.

    連桿移動至槽的一端，用足夠的力推動阻風門全部離開全阻風位置。
  14. Upon pressure testing, if leakage is found at the rear end of valve, first of all, pressure has to be released, then, union shall be rotated 1 / 4 round with wrench to stop leakage

    在試壓測試時在閥門的後端假如有任何的泄露，應先泄壓后再使用板手將大殼轉1 / 4圈去止漏。
  15. Apply silicon sealer / lubricant to the inner and outer diameters of the flange kit gasket, and press the gasket onto the valve body end

    將硅密封/潤滑劑施加在法蘭組件墊圈的內徑和外徑上，將墊圈壓在閥體埠上。
  16. When the electrohydraulic push rod works, if the external force suffered by the piston rod is more than the setting output torque, the piston moves to the end ; oil pressure in the oil pipeline increases rapidly to the setting value, the safety valve overflows rapidly, to achieve overload protection

    電液推桿工作時，當活塞桿所受外力超過調定的輸出力距活塞運動到終點；油路中的油壓迅速增高至調定值，安全閥迅速溢流，實現過載保護。
  17. Q41f - 10c catena pad fluorine valve, q41f - 10cf catena pad fluorine valve, j41f - 16 pad fluorine end - valve, j44f - 16 angle form pad fluorine end - valve, sj41f - 10c pad fluorine inspect - lens, the connect form is flange, the passing parts of valve - body lumen and valve - cover valve - core etc. are all metal pad fluorine plastic inside, rotproof excellently

    Q41f - 10c系列襯氟球閥， q41f - 10cf系列襯氟放料閥， j41f - 16系列襯氟截止閥， j44f - 16系列襯氟角式截止閥， sj41f - 10c襯氟視鏡，連接形式為法蘭式，閥體內腔及閥蓋閥芯等過流部件均為金屬內襯氟塑料，耐腐蝕性能優異。
  18. The catena products design for stsrting closing controling of diversified strong corrosive medium, configuration form is float through form, connect form is flange, the passing parts of valve - body lumen and valve - cover valve - staff etc. are all metal pad fluorine plastic inside, rotproof excellently. the product have son - catena j41f - 16 pad fluorine end - valve and j44f - 16 angle form pad fluorine end - valve choosing to use

    本系列產品是為各種強腐蝕性介質的啟閉控制而設計，結構形式為直通式和角式，連接形式為法蘭，閥體內腔及閥蓋閥桿等過流部件均為金屬內襯氟塑料，耐腐蝕性能優異。
  19. Flame arrester is divided into two types ： pipe flame arrester and oil tanker flame arrester. it can be fixed at the pipe end or on the tanker separately. besides it can be matched with the breathing valve

    阻火器有管道阻火器和油罐阻火器兩種類型，分別安裝于管道末端上或貯罐上，也可以與呼吸閥配用。
  20. J44f - 16 angle form pad fluorine end - valve

    J44f - 16襯氟角式截止閥
分享友人
分享到 Line

分享到臉書