epoxy bonded 中文意思是什麼

epoxy bonded 解釋
環氧粘合的
  • epoxy : adj. 環氧的。n. 【化學】環氧樹脂。
  • bonded : adj. 1. 有債券作保證的；有抵押的，有擔保的。2. （貨物）存入[關棧]待完稅的。3. （織物）多層黏合的；【化學】化合的，結合的。
  1. The box girders were to be precast units, bonded together in place at the joints with an epoxy resin.

    箱梁採用預制構件，在現場連接處塗以環氧樹脂，以粘結成為整體。
  2. And. the test research on the restrained beams strengthened by epoxy - glued cfrp which is glued in term of different angle is presented. based on the test of shear strengthening by cfrp - bonded, qt. ality control standards of the design and construction is established

    作者對cfrp加固用材料性能、結構受力特徵進行了系統的論述，對按不同角度粘貼cfrp加固的約束梁進行了試驗研究，得到大量數據，並在試驗的基礎上，得出了有關的構造要求、錨固要求等設計施工質量控制條件。
  3. The epoxy system is ul listed and provides excellent mechanical and electrical properties, excellent fracture toughness, and outstanding thermal endurance. a permanently bonded, external semi - conducting coating provides a fully shielded, deadfront system

    Epox技術經ul認證，環氧產品具有優良的機械和電氣性能，結構牢固，不易破碎，並有突出的熱耐受能力。
  4. Standard specification for fusion bonded epoxy - coated structural steel h - piles and sheet piling

    熔接環氧樹脂塗層結構鋼氫反應堆和垛板的標準規范
  5. Standard specification for fusion bonded epoxy - coated pipe piles

    熔接環氧樹脂塗覆管樁標準規范
  6. Anti - corrosive painting of fusion bonded epoxy coating powders

    熔融結合環氧粉末塗料的防腐蝕塗裝
  7. The bonded magnets with excellent magnetic properties were manufactured by wetly - mixed epoxy and prfeb powders, which granularity was 100 to 140, and under the pressure of 600 to 800 mpa. then the magnets were solidified 2 hours, under the temperature of 160c

    結果表明，當環氧樹脂與磁粉採用溶劑濕混，成型壓力選為600 ? 800mpa ，磁粉顆粒在100 ? 140目之間，磁體在160 ~ c真空固化2小時，粘結prfeb永磁合金的磁性能達到最佳。
  8. The recent application situation and typical cases of external fusion bonded epoxy coating of buried steel pipelines are described and analysed, from which some suggestions of the design and construction of external fusion bonded epoxy coating are put forward as follows : management of the pipeline project should be strengthened to guarantee the quality of coating ; external fusion bonded epoxy coating should be preferred in flat open country ; space between cathodic protection stations can be reduced suitably in the mountainous and rocky area to attain the best protection effect

    摘要綜述和分析了近幾年埋地長輸管道環氧粉末塗層的應用現狀和典型實例，並由此提出了環氧粉末塗層在設計、施工中的一些改進建議：加強管道建設的管理；在平原地帶可優先選用環氧粉末塗層；在山區石方段可適當減少陰極保護站的間距。
  9. Pe lining steel pipe is currently most popular and widely used in big cities of china, made of hot dipped galvanized steel pipe bonded with the inner layer of pe pipe under high temperature and pressure, the outer layer of steel pipe can be coated with pe also, which shall be connected by malleable iron fittings with pp lining, outer layer could be coated with epoxy

    公司目前生產和銷售dn15 - dn600襯塑復合鋼管內襯外覆塑鋼管內復不銹鋼凈水管襯塑瑪鋼管件不銹鋼管件溝槽式管接頭襯塑帶頸螺紋法蘭襯塑平面整體法蘭等產品，並可按用戶要求生產特殊規格的襯塑復合鋼管內襯外覆塑鋼管內復不銹鋼凈水管及管件。
  10. The entire valve body and bonnet, inside and outside are fully coated with a fusion bonded epoxy that offers protection against corrosion and abrasion. the wedge is fully encapsulated with a vulcanized sbr or epdm rubber. all trims are made of stainless steel and copper alloy to prevent from polluting fluid medium

    閥門內外表面採用無毒環氧樹脂粉末塗敷，閘板全包耐蝕橡膠，其他與介質接觸的零件，均採用不銹鋼和銅合金製造，具有良好的抗蝕性能，不污染介質。
  11. Solid epoxy resin with the low epoxy value is better than liquid epoxy resin to the magnetic performance, and the content is 2 % wt will do good to improve the magnetic characteristics of the bonded ndfeb magnet

    粘結劑選用固態環氧樹脂（ e - 12 ）且在ndfeb粘結磁體中的含量為2 3為最好。
  12. The dependences of the magnetostriction of epoxy bonded smfe2 composites on binder content, model pressure and sample size were determined. the magnetostriction of samples is the maximum when the binder content is in a range of 4 % - 6 %, and it increases with increasing the model pressure from 16 mpa to 62 mpa

    當粘結劑與磁粉的質量比在4 ： 100到6 ： 100之間，粘結smfe _ 2具有最佳的磁致伸縮性能；當模壓壓力小於62mpa時，隨著壓力的增大粘結smfe _ 2合金的磁致伸縮增大。
  13. Fusion - bonded epoxy coating for the interior and exterior of steel water pipelines

    鋼制水管內外的熔融膠合環氧樹脂塗層
  14. Protective fusion - bonded epoxy coatings for the interior and exterior surfaces of ductile - iron and gray - iron fittings for water supply service

    供水設備用球墨鑄鐵和灰鐵配件的內外表面的防護熔融膠合環氧塗層
  15. Technological standard of internal coating of fusion bonded epoxy for steel pipeline

    鋼質管道熔結環氧粉末內塗層技術標準
  16. Epoxy esin bonded glass - backed micapaper tape

    環氧玻璃粉帶
  17. The study of cure mechanism of a fusion - bonded epoxy powder coating

    環氧粉末塗料的固化機制研究
分享友人
分享到 Line

分享到臉書