evaporating pressure 中文意思是什麼

evaporating pressure 解釋
蒸發壓力
  • evaporating : adj. 蒸發用的。
  • pressure : n 1 壓；按；擠；榨。2 【物理學】壓力，壓強；大氣壓力；電壓。3 精神壓力，政治[經濟、輿論等]壓力。4...
  1. In the condition of same condensation temperature and evaporating temperature, the cop of the basic gax cycle is lower than that of the simplicity cascade cycle, but it is greatly better than the mid - pressure double - effect cascade cycle, on the other hand, the work condition is not as rigor as the simplicity cascade cycle, so the ratio of performance and cost is relatively high

    在相同的冷凝溫度和蒸發溫度下，基本gax循環的性能系數（ cop ）雖然比單純復疊循環的低，但要遠遠優于中壓雙效復疊循環，而且運行的條件不象單純復疊循環那樣苛刻，故基本gax循環的性價比較高。
  2. The analysis indicates that in the absorbing refrigeration cycle using tfe - tegdme working fluid under the same evaporating temperature and condensation temperature, the performance of the simplicity cascade cycle is the best while the heat burden of the generator is the maximum, the performance of the mid - pressure double - effect cascade cycle is the worst while the heat burden of the generator is higher than the basic gax cycle

    分析結果表明，採用以tfe - tegdme為工質吸收式製冷循環，在同樣的蒸發溫度和冷凝溫度下，單純復疊循環性能最為優越，但發生器的熱負荷也最大；中壓雙效循環性能最差，而且發生器的熱負荷要比基本gax循環大，運行的經濟性差。
  3. As we all know, the back - pressure valve ( also called evaporating pressure regulator ) is often used to regulate the evaporating temperature of every high - temperature refrigeratory in the system containing many different temperatures but single engine of the ship. but it is neglected that the energy of the system is lost and the efficiency of the system becomes low

    眾所周知船舶單機多庫（簡稱為高、低溫冷庫）系統中，常用背壓閥（蒸發壓力調節閥）來調節各高溫庫的蒸發溫度，但忽略了系統無形損耗的能量，效率也有所下降。
  4. The relations between soil surface resistance and evaporating time, and difference of vapour pressure between evaporating plane and atmosphere were simulated. simulating result of the latter was better than that of the former

    同時，還對土壤表面阻力與蒸發時間的關系、與蒸發時間及土壤蒸發面和大氣間水汽壓差的關系進行了模擬，結果后一種比前一種模擬更符合實際。
  5. The results showed that soil surface resistance often increased with evaporation time and cumulative evaporation, but the relation might be changed by variation of difference of vapour pressure between evaporating plane and atmosphere ; difference of vapour pressure between evaporating plane and atmosphere was one of the major factors for determining the soil surface resistance

    結果表明，土壤表面阻力總趨勢是隨蒸發時間的延長和累積蒸發量的增加而增大，但這種關系有可能被土壤蒸發面和大氣間水汽壓差的改變所打破，土壤蒸發面和大氣間水汽壓差是決定土壤表面阻力的主要因素之一。
  6. The results show that while the mass flow of refrigerant is 1. 85g / s, the inlet temperature of refrigerant is 18. 9, the evaporating pressure is 0. 62mpa, the mass flow of water is 31. 1g / s, and the inlet temperature of water is 36. 9, the refrigerant of miniature evaporator wholly vaporizes in the tube, and the heat transfer rate is 342w. it achieved the demand of design

    經過實驗測試，當製冷劑質量流量為1 . 85g / s ，製冷劑入口溫度為18 . 9 ，蒸發壓力為0 . 62mpa ，水的質量流量為31 . 1g / s ，水的入口溫度為36 . 9 ，此時，螺旋管蒸發器內製冷劑完全蒸發，換熱量342w ，達到了微型蒸發器的預期設計要求。
  7. On the basis of orthogonal test, the optimum procedure parameters were determined. it is evaporating temperature of 750, reaction pressure of 4000pa and o2 content of 50 %

    以此為指標對制備工藝優化，其最佳工藝為：蒸發溫度750 、反應壓力4000pa和o _ 2在混合氣體中的比例50 。
  8. A ejector for is applied in this theory. it can not only regulate the evaporating temperature of each high - temperature refrigeratory but also reduce the back - pressure of the compressor when a system applies this theory. at the same time, the exhaust temperature of the compressor becomes low and the refrigerating capacity per unit of swept volume becomes high

    鑒于目前這種現狀，本文提出了以噴射器為基礎的船舶高、低溫冷庫製冷新循環，不但可調節高溫庫的蒸發溫度，而且也可使壓縮機的回氣壓力得到提高，壓縮機排氣溫度降低，單位容積製冷量上升，製冷系數提高，火用效率提高。
  9. Adaptability of high efficient evaporators of self - cleaning type of natural circulation to evaporating pressure

    自動清洗式自然循環蒸發器的試驗研究
  10. Attentions should be played to the following three systems in parallel multi - condensing unit : lubricant control system, evaporating pressure control system and computer controller

    並聯機組的關鍵點有三個： （ 1 ）潤滑油控制系統（ 2 ）蒸發壓力控制系統（ 3 ）電腦控制器。
  11. Carbon nanotubes were separately synthesized by a new pulsed laser ablation ( pla ) for in - situ growth method and cvd support method in this paper. ft - ir, uv - vis, xfs, laman, tem, xrd, bet methods were used to characterize the sol, carbon nanotube and other products in the experiment. in the pla method, the sols containing carbon nanotubes were successively obtained by using 1064nm pulsed laser to ablate the interface of fe / c, or ni / c targets and ethanol under common temperature and pressure, and then carbon nanotubes were directly acquired by evaporating the ethanol

    脈沖激光轟擊原位生長法是在常溫常壓下使用1064nm波長的脈沖激光轟擊目標靶與乙醇流動相的固液界面來連續制備含有碳納米管的溶膠，進而除去乙醇相得到碳納米管，其中目標靶為石墨與fe 、 ni等金屬催化劑混合壓製成的靶片； cvd基體法是使用自製的六方介孔mcm - 41多孔材料為基體，負載fe催化劑活性組分，通過cvd法催化裂解c2h2來生長碳納米管。
分享友人
分享到 Line

分享到臉書