explosive process 中文意思是什麼

explosive process 解釋
爆發性過程
  • explosive : adj 1 爆炸（性）的，爆發（性）的。2 暴躁的。3 【語言學】爆破音的。4 極易引起爭論的。n 1 易爆炸物...
  • process : n 1 進行，經過；過程，歷程；作用。 2 處置，方法，步驟；加工處理，工藝程序，工序；製作法。3 【攝影...
  1. On the basis of modern blasting theories, the moving process of explosive stress field of multi - row and simultaneity is analyzed and the characteristics of stress field inspired by equivalent effect cell of globosity charge in cylindrical charge structure are considered. thus energy distributing equation of detonator explosion is established and the explosive energy utilizing rate factors are known. so the moving process model of the hole filling is constructed and the equation of calculating reasonable filling length is produced

    本文在現代爆破理論的基礎上，分析了多排同段爆炸應力場的作用過程以及柱狀裝藥結構中等效單元球狀藥包所激發的應力場特點，建立了炸藥爆炸能量分佈方程，明確了影響爆炸能量利用率的因素，構建了炮孔充填物運動過程模型，得出計算合理充填長度方程。
  2. In this paper, firstly the macro parameter of the series connection app was comprehensively analyzed, among which the trajectory location of the bullet emission and the terminal velocity of the bullet were mainly analyzed, and the feasibility of the series connection app to cope with explosive reactive armor was demonstrated. and then the macro design about the head of the series connection app was made, among which a particular analyse about the bullet " s launching process was made, from which we concluded the relation between the thickness of the airproof loop and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the burning rate of the powder and the relation between the length of the bullet and the maximum pressure of the emission hole and the relation between the length of the bullet and the emitting time of the bullet, and the reasonable str ucture of the head of the carrier and bullet were designed, then the intensity of the head of the carrier was checked out using of the software of ansys

    本文首先對子母式穿甲彈總體參量作了全面的計算分析，其中主要分析了子彈射出的彈道位置和必要的子彈著靶速度，論證了子母式穿甲彈對付爆炸式反應裝甲的可行性，然後對子母式穿甲彈彈頭部進行了總體設計，其中主要對子彈的發射過程進行了詳細的分析，得出了母彈彈頭部發射孔內閉鎖環厚度與子彈飛離母彈速度的關系、子彈長度與子彈飛離母彈速度的關系、子彈長度與火藥燃燒率的關系、子彈長度與母彈彈頭部發射孔內最大壓力的關系以及子彈的長度與子彈發射所需時間的關系，設計出了合理的母彈彈頭部結構和子彈的結構，並利用ansys有限元分析軟體對母彈彈頭部的強度進行了校核。
  3. Wet and dry numerical simulation tests for explosive cyclone over western pacific were performed. by contrast the results show that : tropopause and constant temperature surface were raised by latent heat release in upper level and disturbance trough was produced because air flow ascended and became cold. owing to this process adaption, inertial instability emergenced

    對氣旋強烈爆發的過程進行干濕對比數值模擬試驗，得出：潛熱釋放使對流層項和等溫面抬高，氣流在高層的上升冷卻形成擾動槽，其適應過程使高層出現慣性不穩定。
  4. The software designed for the system is validated by experiments and proved correct. the system can s imulate the real air - stream and put it on missile ' s wings to make them work under the same force environment as the real spread process, so the relationship of explosive stuff and attack angle can be calculated

    本文所設計的監控軟體已通過實際系統的驗證，說明整個系統的設計是合理正確的，能夠真實的模擬力矩，產生一種類似真實氣流阻力的載荷，並將其正確施加於彈翼（尾翼）上，使彈翼（尾翼）能在與展開過程中實際受力相同的狀態下工作。
  5. The paper analyzes the chaos characteristics of the rock stress ^ fragment dimension crashing process under the explosive blasting by the chaos theory for the first time, puts forward academic point of view that blasting system is a typical chaos system, adding up to damage mechanics, reduces the connection between blasting fragment face and original damages of rock. then, the concepts of blasting attracted face and the blasting attracted factor have been put forward

    結合損傷力學研究了爆破破碎面與巖石初始損傷的關系，首次提出了爆破吸引面、破碎吸引因子的概念；結合分形理論，討論了爆破吸引面分形維數與破碎塊度分形維數之間的關系；使巖石在爆破作用下的本構關系研究轉化為破碎吸引面的本構關系研究。
  6. On the mixing technology of continuous mixing process of expanded an explosive

    膨化硝銨炸藥連續混藥技術與設計
  7. The load control system has already passed the test ' s validate. it shows that the design of whole system is correct. the system can truly simulate the real air - stream and put it on missile ' s wings to make them work on the same force situation as in the real spread process, so the relationship of explosive stuff and attack angle can be confirmed

    本文所設計的加載控制系統已通過實際系統的驗證，說明整個系統的設計是合理正確的，它能夠真實地模擬類似真實氣流阻力的載荷，並施加於彈翼或尾翼，模擬其在真實工作環境下的受力狀態，可以測算導彈攻角與火工品填藥量的關系。
  8. Abstract : this article simply introduces emulsified explosive production process, based on which control requirements for each production area have been described. alternatives are made for checking, control and instnanent adjustments

    文摘:本文簡單介紹了乳化炸藥生產工藝，在此基礎上詳細闡述了該乳化炸藥各個生產環節的控制要求，以及實現相應控制過程的各檢測、控制和調節儀表的選擇方案。
  9. This paper using ls - dyna finite element analysis program to model the damage process of oilcan steel plate under no. 3 rock explosive load, analysing the effect of the mass and shape of explosive to steel plates extent of damage and shape of crevasse

    利用ls - dyna有限元程序，模擬了油罐鋼板在3 （上標# ）巖石炸藥爆炸載荷下的破壞過程，分析了炸藥質量、藥柱形狀對鋼板破壞程度和破口形狀的影響。
  10. The detonation speed of 8701 explosive is measured and accords well with that obtained by empirical formulas used in the text. optical photographing is used to verify the expansion process of the armature, and shows fair agreement with the fe calculation results

    炸藥爆速測量結果與文中使用的經驗公式相符，光學照相方法得到的電樞膨脹過程與文中有限元計算的結果吻合。
  11. The results at normal temperature have shown that klc of high polymer bonded explosive are very low comparing to metals and some high polymer materials, thus the ability of pbxs to resist crack expanding is very poor, and once some cracks occur inner a structural part of pbxs, the structure will fail very soon and easily. so in the process of machining and production, cracks should be avoided carefully in pbxs parts. some important laws about klc of the three typical pbxs above changes with temperature have been obtained as follows : a

    對三種具有代表性的高聚物粘結炸藥j1 、 j2和j3在常溫下的平面應變斷裂韌度進行了測試與研究，研究結果表明：相對于金屬及某些高分子材料而言，高聚物粘結炸藥的k _ （ ic ）值很低，即高聚物粘結炸藥的抗裂紋擴展能力是極差的，一旦炸藥構件中產生了裂紋，炸藥構件將極易破壞，因此，在高聚物粘結炸藥構件的生產及加工過程中，應避免裂紋的產生。
  12. Smoking is strictly prohibited in the process of handling explosive materials

    "在處理易爆物時，嚴格禁止吸煙。
  13. The whole process realized the networked query and control system of the circulation information of civil explosive. next, the article studies the system architecture of the networked control system. it analyses and studies the bar code, civil explosive coding methods, relevant database, www web, xml web service, and dial network data transmission technology, etc. and apply these technologies to the control system

    其次，研究了民爆產品網路化監控系統的體系結構，分析和研究了條形碼、民爆產品條形碼編碼、計算機關系數據庫、 web應用、 xmlwebservice以及撥號網路數據傳輸等技術，並將這些技術應用於民爆產品網路化監控系統中。
  14. Abstract : by analyzing the method for evaluating the hidden danger in explosive factories ， based on the essential framework of self - learning of machine ， the process of implement the self - learning program with rote learning of such evaluation is discussed in detail

    文摘:通過對火炸藥工廠重大事故隱患危險性評估方法的分析，以計算機自學習的基本結構為主線，詳細探討了以機械學習策略完成該評估程序中對新危險品源自學習的過程。
  15. This paper set up a new data process method with the principal reference analysis method, with this method we deal with these data obtained from several kinds of materials, and analysis two explosives and two drugs, therefor, it was proved that the multi - energy method was a viable and effective method in explosive and drug identification

    摘要建立了以主坐標分析法為核心的數據處理方法，並用此法對多種材料的數據進行了處理，以此為基礎分析了兩種炸藥和兩種毒品，從而證明了多能法在炸藥和毒品識別中是一種可行而有效的方法。
  16. Abstract : based on the analysis of the pressing properties of loading materials for initiating explosive device, a system of automatic explosive pressing device was developed with the theory of intelligent control, so the automation of the pressing process was achieved, and the density identity of loading materials was enhanced significantly

    文摘:在分析火工品藥劑壓藥特性的基礎上，結合智能控制理論，研製了一臺自動壓藥機系統，實現了壓藥工藝過程的自動化，大大提高了壓藥密度的一致性。
  17. The design of the simulation training system of the production process in the explosive enterprise

    國投新集能源股份有限公司安全生產監測系統信息集成的實現
  18. In this paper, we use psu / ncar mm5 model to make a research about an explosive cyclone that occurred in western pacific between december 19 and 21 in 1981, we have a good simulation about the evolution of the real weather process

    本文以1981年12月19日? 21日發生在西太平洋上的一次爆發性氣旋為例，用psu ncarmm5模式對該天氣過程進行了數值模擬試驗，比較好地模擬出了此次天氣過程的演變情況。
  19. And the intelligent matching system of the explosive and rock based fuzzy inferring is set up. 4. it is difficult to study the match of the explosive and rock because of the complexity of blasting process

    （ 3 ）充分利用模糊理論的不確定性研究特點，提出了採用模糊推理的方法進行炸藥與巖石的匹配，建立了基於模糊推理的炸藥與巖石智能匹配系統。
  20. The relations between hole enlargement content and medicine content are obtained in the process of casing explosive hole enlargement by adopting energy conservation method, and based on ground simulated test and field test, the effects of extent of coefficient k are given

    採用能量守恆法導出了套管爆炸擴徑過程中擴徑量與藥量的關系式，通過地面模擬試驗及現場試驗給出了綜合影響系數k的取值范圍。
分享友人
分享到 Line

分享到臉書