feed temperature 中文意思是什麼

feed temperature 解釋
給水溫度
  • feed : feed1fee 的過去式及過去分詞。vt 1 給…飲食，給…東西吃；給（嬰兒）餵奶。2 喂養，飼養，使吃草，放牧...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. In recent years at iron - making plant of pangang, the coke ratio of pig iron has reduced evidently by insisting on “ burden preparation ” course, improving quality of sinter, raising wind temperature, increasing rich oxygen quantity and injecting abundant pulverized coal into bf. the solid fuel consumption of sinter has been decreased greatly through insisting on using high - quality calces, practising high feed sintering, actualizing many techniques in solving key problems. at the same time, the energy source base management has been strengthened, and energy - saving work has made great progress, profits generated by energy - saving have exceeded a hundred million yuan

    近年煉鐵廠通過堅持「精料」方針，改善燒結礦質量，提高風溫，增大富氧，實施大噴煤，使入爐焦比有明顯下降；燒結堅持用好生石灰，推行厚料層燒結，實施多項技術攻關，固體燃耗大幅度下降；同時加強能源基礎管理，節能工作取得長足進步，節能創效益1億元以上。
  2. Fuzzy and front feed control of induction heating temperature

    前饋復合控制方法
  3. It is appropriate for measuring end temperature of bearing liner or other works, e. g., push bearing liner of steamer, supporting bearing liner or push bearing liner of electromotor main axis, bearing liner of coal pulverizer, bearing liner of high efficient feed water pump, bearing liner of compression machine and kinds of other objects inpetrochemical plant

    適用於測量軸瓦或其它機件的端面溫度，如：汽輪機推力軸瓦，電機主軸支持瓦推力瓦，磨煤機大瓦和高效給水泵軸瓦石油化工廠壓縮機軸瓦和各種機件物體的表面測量。
  4. This machine is not effected by the liquid level, air pressure, temperature etc, because it adopts the auto feed back system

    液位氣壓溫度等因素對本設備沒有任何影響，因為本機採用了自動反饋控制系統。
  5. The gas feed automation system, which includes field instruments, gas feed controller, wireless remote supervising system, and so on, will realize following functions : gas flow measurement, gas pressure and temperature measurement, gas flow control, gas pressure regulation, intermittent gas lift, wireless remote monitoring, and etc. this paper will discuss the following content in detail : first part is introduction

    該自控系統包括現場變送儀表、氣舉配氣控制器和無線遠程監控等，主要完成天然氣流量計量、氣體壓力溫度檢測、天然氣流量控制、管道干壓調節、間歇氣舉以及遠程監控等功能。本文將會重點介紹以下內容：首先是概述部分，簡要介紹了氣舉採油技術和氣舉配氣系統的地位和現存問題，並介紹了配氣自控系統的主要性能和優點。
  6. In order to enhance the precision, this design proposes that temperature - measuring circuit of platinum resistors and software should be employed to carry on adjustment of measured precision ; it also proposes that the interference of the grid can be reduced by the voltage front feed ; and meanwhile it calls for the application of the photoelectric insulation, the over heating protection and alarm so as to enhance the security performance of the system

    為了提高精度，本設計還採用了鉑電阻溫度測量電路，並利用軟體對測量精度進行自校準；通過電壓前饋控制減少電網干擾。此外，設計中還加入了光電隔離措施及過熱自動保護和報警功能，以增強系統的安全性能。
  7. To improve the purity of carbon dioxide from the purifying column, a nonlinear model was established for describing the relationship between the carbon dioxide purity and the seven factors of feed purity, feed temperature, column top pressure, column top temperature, column reactor heating temperature, column reactor pressure and column reactor temperature built on the actual production data by using artificial neural network

    摘要為提高提純塔出口二氧化碳純度，根據實際生產數據運用人工神經網路方法建立了出口二氧化碳純度與進塔純度、進塔溫度、塔頂壓力、塔頂溫度、塔釜加熱溫度、塔釜壓力、塔釜溫度7個因素之間的非線性模型。
  8. A grinding surface is consisted of multi pillars lump. because better chips of metal wash away better during grinding process and allow more grinding fluid flow and keep the temperature low for work piece, it is suitable for larger in - feed grinding

    由多片柱型塊組合而成為一個研磨面，由於研磨過程排屑性較好，研磨液滲透較多，研磨工件不易發熱所以適合大進刀量之研磨。
  9. By detailedly analyzing the control problem caused by the time - delayed characteristic of main - steam temperature, the fact that a well - designed feed - forward effect can supply the want of the feedback effect and solve the control problem of long time - delayed system was put forward

    通過對電廠主蒸汽溫度的大遲延特性導致的控制難題的詳細分析，提出合理設計的前饋控製作用能彌補反饋控製作用的不足，可以有效地解決大遲延系統的控制問題。
  10. In this paper, concentrated sulfuric acid and titanium dioxide are used to prepare the tios04 solution that test later required under long time heat. the influences of reaction time and reaction temperature to yield of tioso4 are discussed. in the experiment of preparing tio2 powder, reaction temperature, ph values, material ratio, operation way, velocity of feed, calcining heat and time are researched by the principle of nucleation and growth in thermodynamics and kinetics

    在制備tio _ 2粉體實驗中，根據成核生長的熱力學和動力學原理，深入分析了沉澱反應時環境的溫度、 ph值、反應物配比、操作方式、加料速度等因素對ti （ oh ） _ 4粒度的影響，以及焙燒溫度和保溫時間等因素對制得的納米tio _ 2粉體性能的影響，得出了制備銳鈦型納米tio _ 2粉體的優化工藝條件。
  11. According to the characteristics of temperature control objects in heating medium and cooling system, designs the cascade control system applying the fuzzy control and feed - forward control, solves the problems of lag and variable parameter, and meets the demand of 0. 1 t temperature control precision

    針對熱媒和冷卻控制系統溫度控制對象的特性，結合模糊控制和前饋控制設計了串級調節控制系統，在溫度控制中較好地解決了大滯后、變參數的問題，滿足了控溫準確度0 . 1的要求。
  12. At constant temperature, changes in melt viscosity are often due to variable feed rate and / or poor mixing

    溫度恆定時，熔融粘度變化通常是由於投料速率變化和/或混和不均導致的。
  13. The temperature of the f - p cavity is accurately controlled by a set of thermoelectric cooler ( tec ) modules attached on the body of the cavity and the electronic feed - back circuit. we found that the long - term unidirectional frequency shift of the output laser resulting from the slow increase of the cavity length under the effect of the temperature integration on the cavity body is essentially eliminated

    因此，往往有多臺f ? p腔出現在同一個實驗裝置中本文利用珀耳帖元件，對穩頻系統中作為頻率參考標準的fabry ? perot干涉儀進行精密控溫，並利用f - p腔的透射特性，對自製的全固化單頻nd ： yvo _ 4激光器穩頻。
  14. Two conclusions about the tube will be drawn : l ) being used in the heater of 300mw unit, it will cause 57 % decrease of the heater ' s volume and make the workshop ' s area much more smaller, which is gained from the reasonable device of the heater itself ; 2 ) when used in 100mw unit, higher capability lower temperature difference higher feed temperature of the heater will be available and better economic efficiency of the unit will be gained

    應用雙側微肋強化換熱管后體積可以減小為原來的43 ，大大減小了加熱器佔用廠房的面積。 （ 2 ）雙側微肋強化換熱管應用於100mw機組熱電廠加熱器時，進行改造中，由於原加熱器存在很多缺陷，使加熱器傳熱性能降低，此時使用雙側微肋強化換熱管對加熱器進行改造時，可以提高加熱器傳熱性能，減少加熱器端差，提高加熱器給水溫度，提高機組的經濟效益。
  15. It was founded that the flux increases as the feed temperature, concentration and flow rate increase, and increases as the downstream pressure decreases. the separation factor increases as the feed flow rate and downstream pressure increase, and decreases as the feed temperature increases

    由試驗結果表明，溫度升高，增大料液濃度，降低冷側壓力，以及增加料液流速，膜蒸餾通量增大；同時流速提高，溫度降低，以及增大冷側壓力，分離因子增大。
  16. Results of vmd experiments indicate that flux increases when feed temperature, feed rate and vacuum degree increase. but the increase of flux becomes slowly when feed rate reaches 60l. h - 1 ; flux increases with pore size rapidly, but rejection approaches zero when pore size reaches 0. 5m

    實驗表明，隨進料溫度、進料流速、冷側真空度的增大，膜通量增大；但進料流速增大到60l . h - 1之後，通量隨進料流速的增長變緩；膜通量隨孔徑較快地增大，但當膜平均孔徑達到0 . 5m時，截留率迅速降低，已無實際意義。
  17. The influence of packing height, ratio of water to entrainer and acetic acid initial concentration to separation effect of azeotropic distillation was studied in detail. simulation calculations of general distillation and azeotropic distillation were carried out. the influence of reflux ratio, theoretical plate, feed position, feed temperature and feed concentration to distillation process were discussed

    （ 3 ）與普通精餾比較，分離要求相同時，共沸精餾時所需要的理論板數要低於普通精餾所需要的理論板數，迴流比減小，可降低設備投資70萬元，塔釜加熱量減少36 % 。
  18. Under the conditions of operation pressure about 0. 5mpa and feed temperature 25c, the rejection performance of nacl feed solution ( 500ppm ), is about 36 %, while the flux is about 40. 3ml cm - 2 h - 1

    在本研究中，利用溶膠一凝膠法制備出平均孔徑約為15nm 、水通量為7oml ? 。 m一2 ? h一1 、性能較好的5102 / a12o3無機復合超濾膜。
  19. Under the conditions of operation pressure about 0. 8mpa and feed temperature 20 ?, the rejection performance of er feed solution is about 98 %. ftir and sem are used to analyses the structure and component of membranes

    結果表明， 5102 / a120 :無機超濾膜一聚乙烯醇/ 510 :一a1203復合納濾膜混合膜分離體系對紅黴素的提取率可達98 % 。
  20. Under the conditions of operation pressure about 0. 5mpa and feed temperature 25 c, the rejection performance of nacl feed solution ( 500ppm ), is about 35 %, while the flux is about 45ml cm - 2 h - 1. the pa membranes were prepared by interfacial polymerization, usingl, 3, 5 - benzenetricarbonyltrichlori2, 4 - dichloroterephthalaldehyd e, 1, 3 - phenylenediamine as monomers

    研究結果表明， 5102 / a12o :無機復合超濾膜的研製原料正硅酸乙酷、乙醇、水、 n ， n一二甲基甲酸胺（ dcca ）和hno3之間的配比、塗膜過程、熱處理溫度等直接影響著溶膠的質量和膜的性能。
分享友人
分享到 Line

分享到臉書