fet amplifier 中文意思是什麼
-
For the reason of the same frequency, we use the ldmos fet. there are three development for the middle power amplifier : the first stage power amplifier, the drive stage power amplifier and the last stage power amplifier
本文針對遙測遙控放大器與其頻率相同的特點，對中功率放大器進行研究。本文對固態線性功率放大器的研製包括：前級放大器的研製、驅動級放大器的研製、末級放大器的研製。 -
Through the design the dc feed network, input matching network for the ne900175 gaas fet and analysis the stabilization, power gain, bandwidth of the power amplifier we get the power amplifier is stability, the power gain is 11. 967db and the bandwidth is 300mhz. microstrip antenna has a narrow bandwidth, in this design antenna ' s bandwidth is 100mhz. antenna is the not only the load of the power amplifier, but also as the filter connecting to the output of the power amplifier
E類功放的pae相對a類、 b類、 ab類的功率放大器類型而言比較高，在50 ? 70 。分析了e類功放的工作過程后，以ne900175的gaas場效應管作為e類功放電路的開關，進行了外圍電路的設計，包括直流偏置電路、輸入匹配網路的設計，功放的穩定性、帶寬、增益的分析。該功放增益最大達到11 . 4db ，帶寬為320mhz 。 -
This method link amplitude adjust with phase adjust together, and perform coordinate control. by the simulation principle, the ct error compensation can be realized through operational amplifier, integrate circuit, fet, and other electronic component
這種方法將電流互感器的相位調整和幅值調整結合到一起，進行協調控制，運用模擬原理，並採用運算放大器，場效應管等電子器件實現了電流互感器的誤差補償。 -
Low noise amplifier using fet is adopted in the rf block of smart antenna both at 3. 95ghz and at 1. 9ghz. in the design process of lna, the author applies genetic algorithm in the optimization of gain and noise figure
兩套射頻電路的低噪聲放大器電路均採用了兩級場效應管放大，在其增益及噪聲的優化過程中採用了遺傳演算法這一全局搜索性能較好的數值演算法。 -
We decide to use seven - sections coupled - line filter after comparing the various filter circuits, and complete the quantitative analysis and optimization design by ads, hfss etc. ( 2 ) three - stages fet low noise amplifier according to the lna ’ s design theory and guide line, we decide to use ne3210s01 fet and choose the form of three - stages, thus we can achieve high stability, low noise and high gain
通過對各種帶通濾波器電路方案進行比較，確定採用七階平行耦合微帶濾波器，並利用ads ， hfss等工具進行了定量的理論分析和優化設計。 （二）三級聯低噪聲放大器根據微波lna設計原理及指標要求，我們選用ne3210s01系列低噪聲管，並採用三級放大的形式，以期獲得高穩定性，低噪聲，高增益。
分享友人