filling density 中文意思是什麼
filling density
解釋
填充密度-
On the basis of field investigation and a lot of tests, the paper detailed researches the engineering geology properties of xigeda filling material. the distinction of the modulus of resilience was analyzed, and the influence of the intrinsic factors including moisture content, dry density, mudstone content and the external factors including compaction mode, paving thickness were adequately discussed. based on the researching how various factors influence the road compaction effectiveness, the author studied the relationship between modulus of resilience and roadbed compaction quality index, connected the compactness with modulus, and listed the data of the modulus in the various compaction area
基於此，本論文在大量現場調查、室內外試驗資料基礎上，詳細研究了昔格達填料的工程地質性質；通過路基回彈模量特徵的研究，充分闡述了含水量、干密度、泥巖含量等「內因」 ，及壓實方式、松鋪厚度等「外因」對路基模量值的影響；在分析眾多因素對路基壓實效果影響的基礎上，開展了回彈模量與路基壓實質量指標間關系的研究，進而把現場壓實度與現場回彈模量有機的聯系起來，給定了不同壓實區間對應的模量值。 -
Feather and down - test methods - determination of the filling power bulk density ; german version en 12130 : 1998
羽毛和絨毛.試驗方法.裝填力 -
After correlation analysis of the raw of growth and development, dry matter accumulation, rate of filling, hulk density and yield, it concluded that the best sowing - time was on 30th in april and the best harvest - time was on 5th in october
通過對生長發育規律及對干物質積累、灌溉速率、容重、產量進行相關分析，確定4月30日左右為吉油1號玉米的最佳播種期， 10月5日左右為最佳收獲期。 -
The next trail would require a slightly higher filling density acid.
在下一次試驗時需要注入比重較高的酸。 -
It is widely applicable to lotus paste filling with equal density, applied in cutting and rationing the fruit filling
適用於各類密度均勻的蓉餡料、水果餡料的切割定量。 -
Surface active agents determination of apparent density of pastes on filling
表面活性劑漿狀物在灌裝時表觀密度的測定 -
The main simulation results were as follow : the average energy of electron decreases with the increasing pressure ; it decreases with the increasing methane concentration in the filling gas in the lower pressure range and increases in the higher pressure range ; the number density of fragment h and ch3 does not always increases with the gas pressure, but reaches an individual maximum ; energy carried by neutral dissociative fragment ch3 decreases with increasing gas pressure and ch4 concentration
主要結果如下：平均電子能量隨著反應室內氣壓的增加呈下降趨勢；在較低氣壓范圍內平均電子能量隨著反應源氣體中甲烷濃度的增加而減少；在較高氣壓范圍內平均電子能量則隨著甲烷濃度的增加而增加；隨著氣壓的增加碎片h和ch _ 3的數目並不是一直增加的，而是在不同的特定氣壓下出現各自的最值；碎片攜帶的能量基本隨甲烷濃度和氣壓的增加而減小。 -
So far as the mixing material for building the earth - rock fill dam with clay core for shiquanhe hydropower station is concerned, the effect from the variation of the sand content for the filter material on the maximum dry density and the relevant parameters are to be determined within the variation area of the mixing mass ratio of ( 46 ~ 54 ) : ( 54 ~ 46 ) through this experiment, due to the max, dry density is largely influenced by the mixing ratio of both the lifter material and the clay and the sand content of the filter material, so as to determine the actual filling compactness of the mixing material of the core
摘要由於獅泉河水電站粘土心墻土石壩摻合料的最大幹密度受反濾料與粘土料的摻合比例、反濾料含砂率的影響較大，因此擬通過本試驗確定摻合質量比在（ 46 ~ 54 ） : （ 54 ~ 46 ）范圍變化時，反濾料含砂量變化對最大幹密度的影響程度及相關參數，從而確定心墻摻合料填築的實際壓實度。 -
Considering that the way to gain standard maximum dry density value of xigeda filling is complex, this paper suggests adopt means combining field cbr test and compactness measuring to control construction quality
鑒于昔格達混合填料標準最大幹密度取值的復雜性，建議採用現場承載比與壓實度檢測相結合的辦法進行現場施工質量控制。 -
Through the statistic and analysis of rock core crack, sonic wave velocity test, microcosmic structure of core slice observation by electron microscope, core strength test to the sampled damaged slope rock mass, it indicates that the damage degree of smooth blasting to slope rock mass has no obvious relation with blasting scale but with the line density of explosive filling and the strength of the rock in damaged area decreases evidently
通過受損邊坡巖體取樣巖芯裂隙的統計分析、聲波速度測試、巖芯切片微觀結構的電鏡觀察及巖芯的強度試驗，發現光面爆破對邊坡巖體的損傷程度與爆破規模無明顯關系，而與光爆孔的線裝藥密度有關，損傷區巖石的強度明顯降低。 -
The aim of this paper is to search for a new type periodic slow - wave structure with filling periodically magnetized plasma, and following works are done : 1. firstly, the investigation of wave propagation characteristic in magnetized plasma with periodically changing density is done. by numerical calculation, analyze the effect of additional magnetic field and plasma density changing on the propagation characteristic
本文的目的是探索一種周期磁化等離子體慢波結構，並做了如下的工作: 1 .對電磁波在密度周期變化磁化等離子體中的傳輸特性進行了研究，通過數值計算分析了不同外加磁場以及不同等離子體密度情況下波的傳播特性。 -
Through theoretical analysis and experimental research, new predewatering techniques of perforated pipe filtering net and divided flow settling have been developed and tested which are of their first kind to realize the low density transportation and high density filling of the filling pulp
通過理論分析和實驗研究，首創並試驗了多孔管濾網振動預脫水和分流沉降預脫水新技術，實現充填料漿的低濃度輸送、高濃度充填。 -
According to the tests on ball - feed ratio, medium filling percent age, ground pulp density, active power and grinding efficiency, the authors anal yse main factors affecting ball mill s active power and grinding efficiency, es tablishing the relationship between ball mill s internal state ( such as ball - f eed ratia, medium filling percentage and ground pulp density ) and external param eters ( such as active power and grinding efficiency ) and giving appropriate oper ating parameters for improving grinding efficiency
通過對球磨機球料比、介質充填率和磨礦濃度與有功功率和磨礦效率試驗，分析了影響球磨機功率和磨礦效率的主要因素，建立了球磨機內部狀態（球料比、介質充填率和磨礦濃度）與外部參數（有功功率、磨礦效率）之間的關系，提出了改善磨礦效率的合理操作參數。 -
Package testing ; stipulation of filling rate of pre - packages, form with coefficient of variation of the density of products and of the package for cleaning products
包裝試驗.預包裝充滿率的規定.產品密度和清洗產品包 -
Package testing ; stipulation of filling rate of pre - packages, form with coefficient of variation of the density of products and of the package for plants protection products and similar products
包裝檢驗.預包裝充滿率的規定.產品密度和植物防護產 -
Package testing ; stipulation of filling rate of pre - packages, form with coefficient of variation of the density of products and of the package for washing and cleaning products and similar products
包裝檢驗.預包裝件裝滿率的規定.洗滌清潔及類似制 -
Testing of packaging ; determining the filling ratio of prepacks ; form relating to coefficients of variation for the density of the packaged material and for the package for adhesives and allied products
包裝的檢驗.預包裝充滿率的測定.包裝材料密度和粘合
分享友人