film analysis 中文意思是什麼

film analysis 解釋
薄膜分析
  • film : n 1 薄層，薄膜；薄霧，輕煙；細絲狀的東西。2 【攝影】感光乳劑，照相軟片，電影膠片；影片。3 〈 pl ...
  • analysis : n. （pl. -ses ）1. 分解，分析；【數學】解析。2. 梗概，要略。3. 〈美國〉用精神分析法治療（＝ psychoanalysis）。
  1. Impact bifurcate analysis on a bearing - rotor system with unsteady oil film forces

    轉子系統非線性動力特性的數值分析及實驗研究
  2. A detailed analysis of the electrical properties of ato thin films was carried out in order to investigate the sb / sn atomic ratio and substrate temperature ' s influence on the ato thin film. a convictive explanation brought forward to illustrate the changing of the electrical ； properties of the ato thin film in different conditions

    在溫度較低時（ < 500 ） ，薄膜的方塊電阻隨成膜溫度的升高而降低；當基板溫度繼續升高，薄膜的方塊電阻隨基板溫度的升高而增大，這主要是因為玻璃基板中k ~ + 、 na ~ +離子向薄膜中的擴散。
  3. Mechanics analysis of decontaminating peeled - up film

    剝離型去污膜體力學性能分析
  4. In the model the film thickness in the passage was obtained at first using two phase flow theory ; then, similar analysis solution of concentration distribution of the pollutant in liquid phase and biofilm was obtained through mass component equation of pollutant in gas - liquid phases combined with the biochemical kinetic equation of mass transfer in biofilm and dismission of oxygen limited ; at last, the distribution of pollutant along the filter height and the waste gas purification efficiency were obtained

    該模型首先運用兩相流理論獲得了通道內液膜厚度，然後通過污染物在氣相、液相的質量組分方程，結合生物膜內的傳質與不?慮氧限制的生化反應動力學方程，獲得了污染物在液相和生物膜中濃度分佈的近似分析解，最終得到污染物在氣相中沿塔高的濃度分佈及廢氣凈化效率。
  5. As to the work about theory analysis, at first, the paper describes the atomizing and humidifying process of the centrifugal nozzle with firing pin type, high pressure and little aperture and liquid physical properties. later, combining with the structure characters of this kind of nozzle, the paper studies on the theory of the atomizing and humidifying process by three phases, which is water film forming phase, water film falling into pieces phase, and heat and mass transfer between water and air phase in turn

    理論工作方面，首先描述了撞針型高壓小孔徑離心式噴嘴的霧化加濕過程和液體的物理性質，然後結合撞針型高壓小孔徑離心式噴嘴的結構特點，將其霧化加濕過程分三個階段進行機理上的研究，這三個階段依次為液膜形成、液膜初次破碎及二次霧化、水與空氣的熱濕交換。
  6. Second, adopting the linearity of oil film of the guide bearings, the transient response of the shafts is computed and analysis by integrating with willson method. because of the uncertain position of the shafts in the guide bearing, the model and solution method of nonlinear transient response of the shafts is discussed

    然後結合willson數值積分法，採用線性化油膜力，對機組軸系的線性瞬態響應進行了計算分析，根據機組軸系在瞬態響應中運動的不確定性，給出了由導軸承油膜力非線性所引起的主軸系統的非線性瞬態響應的建模及求解方法。
  7. Through the analysis of image, narrative angle and genre, it can be concluded that betty blue indicates an important developmental trend of film : hybridity

    通過對其中的形象、視點和風格的分析，可以發現它可能代表了法國「后新浪潮」電影發展的一種重要方向：融合性或曰雜交性。
  8. Analysis of ion - irradiated carbon film on tungsten

    離子輻照鎢基上碳薄膜微結構的分析
  9. Analysis of the aesthetic value in 1930 ' s china left wing film

    20世紀30年代中國左翼電影美學分析
  10. Analysis of abnormal data in the measurement of film magnetostriction by false neighbor method

    偽鄰近點法分析薄膜磁致伸縮測試中異常數據
  11. In this paper, the rotating machinery at high speed is studied. there are discussed about numerical calculating methods for non - linear dynamical system, the rotor system radial impact and rubbing dynamics behavior analysis having the nonlinear rigidity on the unsteady and non - linear oil film, the rotor system dynamics behavior analysis with bending - torsional - pendular coupling vibrations, application of wavelet, fractal and network in fault diagnosis. the main works in this paper are as follows : ( 1 )

    本文以高速旋轉機械為主要研究對象，系統、深入地研究了非線性動力學系統的數值計算方法、具有非線性剛度的轉子系統在非穩態非線性油膜力作用下的徑向碰摩動力學行為、轉子彎扭擺耦合振動的動力學分析、小波和分形理論及人工神經網路在故障診斷中的應用問題。
  12. Because of the restriction of the performances of the infrared materials, we decide that the hollow waveguide should have the structure of single layer dielectric coated metallic film according to the general analysis of process controllability and transmission capability. the dielectric we choose is silver iodide, made from silver and iodine, and the optimum thickness is about 0. 77um

    因材料性能的限制，通過傳輸性能以及工藝可控性綜合分析，確定製備的空芯光纖為單層電介質塗覆金屬膜結構，電介質膜定為碘化銀，理論厚度為0 . 77 m左右，由銀膜直接碘化得到。
  13. Abstract : the therortical calculation of the bending stress of the root and experimental stress analysis on the modified profile and the standard involute tooth profile were made with the finite element method and the electric resistance strain film method. this indicated that the modified profile was supe rior to the standard involute profiles in terms of the bending strength

    文摘:分別用有限元和電阻應變片法對修形齒形和漸開線齒形進行齒根彎曲應力計算與實驗應力分析.結果證明在彎曲強度方面修形齒形比標準漸開線齒形更優越
  14. We believe the fine mechanical properties of tubular film are related to its fine chain orientation structure by using pole figure investigation and polarized fourier transform infrared ( ftir ) spectra analysis, the modes of orientation for flat and tubular films are obtained. it was found that the cellulose chains of the flat and tubular films have an uniplanar orientation mode with respect to the film surface

    通過x衍射織構（極圖）分析和偏振紅外光譜分析建立了平膜和管膜的取向模型：平膜和管膜都有單平面取向；平膜中的分子鏈在膜表面內呈無規取向:管膜中的分子鏈則相對于拉伸方向有明顯擇優取向。
  15. We prepare the si - sio2 and ge - sio2 thin film by using the dual ion beam co - sputtering method and the rf co - sputtering technique respectively, adjusting the substrate temperature ( ts ) and the annealing temperature ( ta ). then we analysis the structure of the thin film by using the xrd and tem

    論文採用雙離子束濺射和射頻磁控濺射沉積技術，通過改變薄膜沉積過程中基片溫度（ t _ s ）以及薄膜制備完成後退火溫度（ t _ a ）分別制備了si - sio _ 2和ge - sio _ 2薄膜。
  16. The analysis results indicate that the correlative influence factors to the technological capabilities of electronic solders include the composition and purity and chemical uniformity of solder alloy, the composition and properties of mother materials and their clean level on the surface, the surface tension of liquid state solders, the temperature and atmosphere in soldering and the activity of flux, the chemical composition and structure and properties of the surface film of melting solders, and so on

    分析表明：相關的影響因素主要包括合金的組成、純度和化學均勻性；母材的成分、性質和表面的潔凈度；液態焊料的表面張力；釬焊溫度、氣氛、助焊劑的活性；液態焊料表面膜的組成、結構和性能等。
  17. Besides, the growth of gasb expitaxy film was monitored by reflection high energy electron diffraction ( rheed ). the rheed images and intesity oscillation are collected by computer system. it showed that the gasb film prepared in 400 was amorphous and it became monocrystalline when the temperature rose to 500. atomic force microscope ( afm ) was applied to analyse the surface morphology of the films which were grown in diffrent growth rates or substrate temperature. the analysis were compared to simulation results. the experiment results indicated it was easy to form clusters when the rate of growth is high or

    此外，本文通過反射式高能電子衍射（ rheed ）監測了gasb外延薄膜的生長，利用rheed強度振蕩的計算機採集系統實現了rheed圖像和rheed強度振蕩的實時監測。實驗發現在400生長的gasb薄膜為非晶態，溫度升高到500薄膜轉變為單晶。利用原子力顯微鏡對不同生長速率和襯底溫度生長的gasb薄膜的表面形貌進行觀察分析，並與模擬結果進行比較。
  18. The quartenvave film stack based on one dimensional photonic crystal technology is designed. the measurement of the ir band is relatively mutual while that of mmw band is lack of report. the reflectivity of ir area ( 3 - 5 m ) by fourier transform infrared spectrometer ( ft - ir ) is given, and the experimental data of mmw band in microwave network analysis is also given

    本文給出了直接在傅立葉紅外光譜儀中進行的紅外波段透射率（實際是反射率）測量結果，在毫米波波段，通過自行設計的測試方法與測試系統，給出了在hp8510矢量網路分析儀下測得的未鍍膜、鍍膜樣品的比對測試結果。
  19. Abstract : through film analysis of second fly of men " s long horse handspring tucked salt with 720 performed by some of elite chinese gymnast, this paper indicates the kinetic characteristic and regulation of " second fly ", which is one of the key actions for this movement and also provide the theoretical bases and technique data for the training

    文摘:本文通過對我國部分優秀男子體操運動員跳馬「前手翻團身前空翻2周」動作的影片解析，揭示出運動員在完成該動作關鍵技術之一的第2騰空動作技術的運動學特徵與規律，為進一步訓練提供理論依據與技術參數。
  20. Film analysis system

    膠片分析儀
分享友人
分享到 Line

分享到臉書