film speed 中文意思是什麼

film speed 解釋
底片感光度
  • film : n 1 薄層，薄膜；薄霧，輕煙；細絲狀的東西。2 【攝影】感光乳劑，照相軟片，電影膠片；影片。3 〈 pl ...
  • speed : n 1 快，迅速。2 速率，速度。3 （汽車的）變速器，排擋。4 （膠片，照相紙）感光速度。5 〈古語〉興隆...
  1. Best concentration of ions is 1. 5mol / l and dispersant pvp monomer 0. 8mol / l. spin - coating speed, which affected the quality of limn2o4 film greatly, was also studied. it demonstrated that smooth limn2o4 film without cracks could formed under 2000 rotates / min with the solution cion = 1. 5mol / l, cpvp = 0. 8mol / l, what ’ s more, fewest spin - coating times were needed at that speed

    實驗結果表明:採用離子總濃度溶液為1 . 5mol / l ，聚乙烯吡咯烷酮單元濃度為0 . 8mol / l的溶液旋轉塗覆時，轉速在2000轉/分鐘時最佳，所得到的濕limn204薄膜平整光滑均勻，加熱后無龜裂現象。
  2. Sdf high - speed extruding film compound machinery unit

    Sdf型高速擠出淋膜復合機組
  3. Washed air purifier working principle : siphon and using centrifugal principle will be mixed in water pure plant essential oils inhaled through its siphon principle the motor base coaxial centrifugal turbines in the bottom of straw through exchanges cover a very high - speed rotary motor, reuse centrifugal principle, will be mixed in water pure plant essential oil spray bottle in the form within a water film bile, the dust in the air and inhaled bacteria in water purification at the same time after the indoor air insufflation, quickly and efficiently by removing indoor toxin biological, dust, cigarette smoke, the smell, virus

    水洗空氣清新機工作原理：是利用虹吸以及離心原理；將混合於水的純植物精油通過虹吸原理吸入其電機底座的同軸離心渦輪下部的吸管中，通過交流罩極電機高速旋轉，再利用離心原理，將混合於水的純植物精油噴在瓶膽內形成一層水膜，將空氣中的灰塵以及細菌吸入水中，同時將經過凈化的空氣吹入室內，快速有效地去除室內的有毒素生物、灰塵、煙味、臭味、病毒等。
  4. In this paper, the rotating machinery at high speed is studied. there are discussed about numerical calculating methods for non - linear dynamical system, the rotor system radial impact and rubbing dynamics behavior analysis having the nonlinear rigidity on the unsteady and non - linear oil film, the rotor system dynamics behavior analysis with bending - torsional - pendular coupling vibrations, application of wavelet, fractal and network in fault diagnosis. the main works in this paper are as follows : ( 1 )

    本文以高速旋轉機械為主要研究對象，系統、深入地研究了非線性動力學系統的數值計算方法、具有非線性剛度的轉子系統在非穩態非線性油膜力作用下的徑向碰摩動力學行為、轉子彎扭擺耦合振動的動力學分析、小波和分形理論及人工神經網路在故障診斷中的應用問題。
  5. Film speed indicator

    膠片感光度指示圈
  6. Film wind - up with easy removable bobbins. variable speed drive with clutch for windup

    薄膜收卷在易於卸除的卷軸上，收卷速度由帶有離合器的速度可調電機控制。
  7. Using diethanolamine as aminating agent and glacial acetic acid as neutralizing agent, aminated epoxy acrylic cationic resin was prepared. the effect of technology of aminated epoxy acrylic resin on properties of eletrodeposition was studied by conductivity meter and electrophoresis apparatus. it was shown that, conductivity firstly decreased, and then increased with aminating temperature increase. in contrast with putting polyacrylic resin into thin acetic acid solution, the more compact film could be achieved by neutralizing polyacylic resin with glacial acetic acid and then add it into water. when neutralizing temperature was enhanced, the speed of electrodepsidon was found to increase, and the film was also more compact. increasing the dn leads to enhanced conductivity and smaller particle size. when dn equaled to 80, the smoothest film could be achieved

    以二乙醇胺為胺化劑、冰醋酸為中和劑，合成了胺化環氧丙烯酸陽離子樹脂.採用電泳儀和電導率儀，研究了胺化環氧丙烯酸樹脂合成工藝對陰極電泳塗料電沉積性的影響.結果表明，隨著胺化溫度的增加，電泳液電導率先下降後上升.將冰醋酸加入樹脂中中和，後用水稀釋，比樹脂在醋酸稀溶液中中和，電沉積性能更好.電沉積速率隨著中和溫度的上升而增加，電沉積膜緻密性相應增加.中和度（ dn ）愈高，電泳液電導率愈大，粒徑越小，而塗膜外觀在中和度為80時達到最佳
  8. Non - destructive testing. industrial neutron radiography. determination of the speed and average contrast of silver based film image reception systems using electrons with an energy less than 200 kev

    無損檢驗.工業用中子輻射照相術.用能量低於200kev的電子進行銀鹽底片圖象接收系統的感光度和反差平均值的測定
  9. The experiments also show that the responding speed of the thick film is improved and it has better properties than bulk samples and the ybco film may be as a new oxygen sensor material in practical application

    同塊材樣品相比，實驗證實ybco厚膜樣品的響應速度得到明顯提高並具有較好的響應特性，有可能作為一種新的氧傳感器材料。
  10. Microcracks and stresses will appear if the dropping speed, aluminum content and dropping cycles are too high. high temperature heat - treatment can eliminate and help to obtain compact thick film

    當提拉速度、溶膠濃度和鍍膜次數較大時膜內易出現微裂紋和脫落等缺陷， 550熱處理5h可以消除缺陷，獲得緻密厚膜。
  11. Film strength ability of a film of lubricants to resist rupture due to load speed and temperature

    油膜強度潤滑油油膜抵抗因負荷、速度和溫度而造成破裂的能力。
  12. Analyses of the critical rolling speed for oil film bearing and strip gauge control in rolling mill

    軋鋼機油膜軸承臨界軋速與板厚調控分析
  13. Using the world s largest film format, special effects and computer animation, the latest omnimax show " top speed " explores the science of speed. but in doing so, the film also becomes a stirring and inspirational story about the passionate pursuit of dreams and human excellence

    利用現今最大型的電影底片格式，加上特技效果及電腦動畫，新全天域電影極速挑戰帶領觀眾追蹤極速背後的科學，探索人類如何追尋夢想並取得卓越成就。
  14. Under function of impeller with high rotating speed, the used sand will be cast to the wearable junk ring to remove the inert film on surface of the sand via mutual collision and friction between sand and junk ring, impeller and case of machine, sand and sand

    工作時舊砂在高速回轉的葉輪作用下，拋向耐磨襯圈，通過砂粒與襯圈葉輪與機盒砂粒與砂粒之間的相互碰撞和摩擦，去除砂粒表面的樹脂惰性膜。
  15. Frame frequency and film running speed for exposure and projection of motion - picture films

    電影膠片暴光及投影的幀頻和膠片運轉速度
  16. This machine is suitable for producing 2 - layers or multiple - layer tri - side sealing composite film bag for foods, laundry detergent, candies etc. based on materials such as bopp, opp, cpp, pe, nylon, aluminum foil, and paper, it is an ideal packing bag making facility with easy operation and rapid working, making even - face, beautiful products with highly strong heating sealing. feature : 1. the whole machine adopts industrials control level computer and auxiliary three - servo control system. the pouch - making speed, pouch making length, temperature, countring punching and conveyor quantity of doubing finished products, etc. can be preset via touch screen

    該機適用於以bopp opp cpp pe尼鋁箔紙張為基材的兩層或者說多層三邊封復合薄膜袋食品袋洗衣粉袋糖果袋等的生產，本設備操作簡便，產品平整，形狀美麗，封邊處熱合強度高，制袋速度快是理想的包裝制袋設備。
  17. Photography - direct - exposure medical and dental radiographic film process combinations - determination of iso speed and average gradient

    攝影.醫療和牙科用直接曝光射線攝影膠片照相版圖片的iso感光速度和平均梯度的測定
  18. If the film has been properly loaded, the film speed appears on the lcd panel for about 2 seconds. then, the exposure counter displays “ 1 ”

    如膠卷裝得合適，膠片的速度將在2秒鐘內顯示在液晶屏上，這時，曝光計數器顯示「 1 」 。
  19. Press the up down buttons to set the desired film speed

    按壓向上向下按鈕調至所需的膠卷速度。
  20. The film speed and the “ iso ” indicator are briefly displayed on the lcd panel

    膠卷速度和「 iso 」指示燈都將在液晶屏上顯示。
分享友人
分享到 Line

分享到臉書