film type and size 中文意思是什麼
film type and size
解釋
膠片型號尺寸-
There was no difference in other biologic characteristic of mscs between the two separation method, such as cell anchorage ratio and clone formation ratio. ( 2 ) plga film presented uniformity frame with no protuberance and fissure under scanning electron microscopy ( sem ). big aperture with smooth wall and average 400 m i n size running - through each other was observed in porous plga substrate, around the big aperture there were many round micropores about 5 m size. all of the structure were equal and uniform, which satisfied the further research work. ( 3 ) mscs adhesion at earlier time was promoted by biotiegenrafter 3h, cell number was ( 1. 5 0. 18 ) 105 in the plga film coated with biotiegen group, which was significantly higher than that in plga film group ( p < 0. 01 ) and higher than that in coverslip group ( p < 0. 05 ), which cell number was ( 1. 04 0. 21 ) 105. after 6h and 12h biotiegen could not promote cell adhesion, and cell proliferation and alkaline phosphatase ( alp ) activity were not promoted dramatically during 9 days. ( 4 ) cell adhesion was promoted by fibronectin or collagen type i
G ） i型膠原、纖維粘連蛋白促進細胞增殖，細胞接種后3 、 6 、 gd三個檢測時間點，實驗組細胞均明顯高於對照組。與1型膠原相比，纖維粘連蛋白刺激作用更強。 ） i型膠原、纖維粘連蛋白尚能誘導mscs細胞向成骨細胞分化，不僅表達成骨細胞標志物ocn 、 alp 、 opnmrna ，而且堿性磷酸酶活性明顯增高，堿性磷酸酶及鈣結節7第四軍醫大學博士學位論文一染色均強陽性， i型膠原組mscs細胞堿性磷酸酶活性較fn組更高，有顯著性差異；同時，兔疫組化染色表明，經纖維粘連蛋白作用的mscs1型膠原表達陽性。 -
Sol - gel method was used for preparing the nano - tio2 photocatalytic film on general glas slid and ito conductive glass. the spectrum property, surface image, crystlal type, particle size, thickness and other properties of this film were measured by uv - vis, afm, xrd and other apparatus
採用溶膠-凝膠法在普通玻璃載波片和ito導電玻璃上制備出負載型納米tio _ 2薄膜，並用uv - vis ， afm ， xrd等對納米tio _ 2薄膜的光譜特性、表面形貌、晶型及粒子大小、薄膜厚度等進行了表徵。 -
The result indicated that the crystlal type of film convert to anatase after 500 c treatment for 1 hour, the particles size on the film surface and film ' s thickness can be adjust in some extent by properly control the technics conditions
結果表明，在500熱處理后， tio _ 2晶型從無定性態轉變為銳鈦礦結構，且通過適當控制工藝條件，可在一定范圍內調控tio _ 2薄膜表面粒徑大小和薄膜厚度。 -
" we tried to prepare the aircore meander type thin film inductors to increase the frequency that can be used. we prepared them with masks and by magnetron spllttering. wthollt the magnetic material we got large inductance by properly choosing the size parameter. the change of the size parameter does not influence the frequency that can be used, so we can improve the quality factor in the same time
為了得到在更高頻率下適用的薄膜電感，在本實驗中我們嘗試製作了柵極型空心薄膜電感。我們採用掩膜法，通過磁控濺射制各樣品，在不加磁性材料的情況下，適當選取線圈形狀參數來得到較大的電感，由於形狀參數的改變不影響樣品的適用頻率，因而也能達到增大品質因數（ q值）的目的。
分享友人