filter insertion loss 中文意思是什麼

filter insertion loss 解釋
濾波器插入損耗
  • filter : n 1 濾器，濾紙，過濾用料[砂、炭等]。2 【無線電】濾波器；【物理學】濾光鏡，濾色器。vt 過濾，用過濾...
  • insertion : n. 1. 插入；記入；刊登。2. 插入物；插入句；插入廣告；插銹，補繡。3. 【動、植】著生（點）。4. 【電學】嵌入，介入。5. 【醫學】（肌肉的）附著。adj. -al
  • loss : n. 1. 喪失；丟失，遺失。2. 減損，損失，虧損（額）；損耗；減少，下降。3. 失敗；輸掉。4. 錯過；浪費。5. 損毀；【軍事】傷亡；〈pl. 〉 傷亡及被俘人數。
  1. The main works are as follows : 1. the paper systematically describes basic concepts and theories that form the foundation for design of general microwave filters. the topics will cover filter transfer function, lowpass prototype filters, frequency transformations, immittance inverters and the passband insertion loss under the influence of the dissipation of filter elements 2

    現總結如下: 1 .對微波濾波器的設計理論進行系統的分析，闡述了微波濾波器的傳輸函數、低通原型、頻率變換、倒置變換器以及元件損耗對帶內插損的影響等方面。
  2. Method of insertion loss measurementsfor passive radio interference filter units

    無源無線電干擾濾波器插入損耗測量方法
  3. Moreover, computer - aided design for power - line filter and discussion on implementation of intelligent equipment of noise measurement and suppression are also introduced, results show that the discrimination network based on splitter / combiner has better hf performance with low insertion loss and good rejection capability, however, it is more expensive

    結果表明，基於分相器混和器的噪聲分離網路具有更好的高頻特性，且網路插損和噪聲模態抑制特性能夠滿足工程精度要求，但網路製造成本較高。
  4. Specialties : the range of center frequency it can achieve is bigger than one - piece filter ; at the time it has the features of wide pass - band, low insertion loss and high restraint outside the band

    特點：可實現的中心頻率范圍較單片濾波器寬，通帶寬度范圍大，插入損耗小，帶外抑制高。
  5. Together with the test of its basic performance, a programmable filter using the designed chip and two saw filters, whose center frequency and bandwidth can be adjusted, is also built and tested. the test results show that, the minimum insertion loss is - 5. 2 - 10. 5db, with the maximum isolation loss lying between - 40. 5 - - 23. 4db, and the maximum continually tunable dynamic range is 21. 3db, from 50mhz to 250mhz

    測試結果表明：在50 250mhz的工作頻段內，該電路導通時最小插入損耗約為- 5 - 10 . 5db ，關斷時隔離度可達- 40 . 5 - 23 . 4db左右；其連續可調的加權動態范圍最大值為21 . 3db 。
分享友人
分享到 Line

分享到臉書